what is the void fraction at the channel

Q: The thermal mass flowmeter is used with Select one OaAll answers are wrong b. Gas and liquid…

A:

Q: END PLATES SHEARED FROM 1/2" x 4" FLAT BAR 3/4 DRILL THRU 4 PLACES 1- 12 1 1/2" BI, PIPE 90° 2" LR.…

A: For any pipe, there is specific naming method. For example, Inner Diameter = Nominal Size Thickness…

Q: has part B of this problem been done

A: using the Euler's first law for rotation, the reaction force at each bearing is,

Q: ow do you find how many intake ports you need when designing a design for an intake tower

A: introduction; Intake towers are used for water supply in heavy supply from a river or reservoir. In…

Q: .eter

A:

Q: The oil sump's small external surface area helps heat transfer from the oil to the outside air.…

A: Oil sump is used in 2 stroke and 4 stroke engines to cool the engine oil when its temperature…

Q: What would be the heat flux at the end of the tank without the metallic shield?

A:

Q: What is the horsepower of the pump? 1 -10⁰ Area = 1 =qift so' hf thm - zcas

A:

Q: Find the force required to hold the plug in place. The water discharges freely into the atmosphere…

A: water velocity v=3m/sentry diameter D=0.25mplung diameter d=0.2mto find the force required to hold…

Q: Because of not being able to access the entire internal part of a pipe, this type of equipment is…

A: The question is asking about a type of equipment that is difficult to inspect internally due to…

Q: 111 about industrial piping WHAT IS THE RELATIONSHIP BETWEEN OPERATING PRESSURES, MAWP, HYDROSTATIC…

A: The question is asking about the relationship between different pressure parameters in the context…

Q: convert 35 psig in kPaa

A: Psig and kPa both are units of pressure. Psig = pound per square inch  kPa = kilo Pascal

Q: Venn Diagram of the difference between actual and theoretical discharge

A: To show the difference between actual discharge and theoretical discharge

Q: What must the water pressure need to be on for the third floor sink (36ft off the ground) to have…

A: Given data,  H= 36 ft =10.9728 m. Pressure at third floor  P=32 lbf/in2 =220632 Pa.   Let density of…

Q: The diagram below shows all the antinodal lines (dashed) and nodal lines (solid) due to two point…

A: Given:To find:Are the two sources in phase or out of phase? Explain how you can tell from the…

Q: 113 About industrial piping UNDER WHAT CONDITIONS SHOULD FLOW VELOCITIES BE LIMITED?

A: The objective of the question is to understand the conditions under which flow velocities in…

Q: On what condition will there be no cavitation in the pump? When NPSHavailable = NPSH required When…

A: ● Introduction to NPSH: NPSH (Net Positive Suction Head) is the minimum head required at the suction…

Pressure Vessels

The term pressure vessel refers to a closed container that contains gas or liquid at a different pressure than environment pressure. The pressure vessels have a wide scale of applications in our day-to-day lives and other industrial places. Some common examples of pressure vessels are gas cylinders, autoclaves, compressor vessels, etc.