What is the power of a steam jet 15mm in diameter moving at 750 m/s? Steam condition, 1.4 kg/cm2, dry and saturated (v = 1.256m3/kg). (With drawing to fully understand the question)a) 29.67 kW c) 19.67 kWb) 39.67 kW d) 49.67 kW

Answered: Image /qna-images/answer/35a47191-722d-429f-800e-29f2003c7499.jpg

Answered: What is the power of a steam jet 15mm…

What is the power of a steam jet 15mm in diameter moving at 750 m/s? Steam condition, 1.4 kg/cm2, dry and saturated (v = 1.256m3

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: 11. A right triangular surface (shaded region) is submerged vertically in water, as shown. What is…

A: Find the force on one face due to water pressure.

Q: With a pressure of 120 kPa and a temperature of – 24 ºC, 0.19 liters of refrigerant 134a is turned…

Q: 1) Between two sections in a vessel, a fluid moves in a steady flow manner. At entrance: A1=20 m²,…

A: Answer: (a) The mass flow rate at inlet is 24000 kg/min. (b) The velocity of fluid at inlet is…

Q: Questo ): The fluid (SG = 0.8 and μ = 1.25x10-³ Pa-s) is flowing inside a 30-cm-diameter tube with…

Q: Some water is compressed from 1 atm pressure to 4 atm pressure at constant temperature. The initial…

Q: The specific heat of aluminum is 0.22 cal/(g-C°). The quantity of heat required to change the…

Q: 49. A piping system includes three pumps each having the performance characteristics shown in the…

A: Given Data: Three identical Pump characteristics curve shown in a figure Find: Supply head(ft) of…

Q: In figure (1), the block moves upward from position (A) to (B) though the distance (d 2.5 m). Take…

Q: Find the pressure of the fluid with an enthalpy of 300 kJ/kg, specific volume of 2 m^3/kg and…

Q: The quality of the fluid is 60%. Its internal energy at saturated liquid state is 800 kJ/kg and…

Q: Atmospheric pressures in the upper and lower floors of a building are shown on a barometer as 96.5…

Q: Q1A- If the viscose force is dominate in Reynolds number, the flow will be: * a) Laminar…

A: 1A) Reynold's number is the ratio of inertia forces to viscous forces. Low value of Reynold's number…

Q: 3. The cylindrical diving bell is open at the bottom and closed at the top, as shown. It is lowered…

Q: In figure (4), the crate is initially at rest on the ground. If the motor exerts a force of F = (600…

A: Disclaimer: Since you have asked multiple questions, we will solve the first question for you. If…

Q: In figure (1), the block moves upward from position (A) to (B) though the distance (d = 2.5 m). Take…

A: If a force F is inclined at an angle θ with the horizontal, then the component of force along the…

Q: 3- The gas in a reciprocating cylinder expands and moves the piston 12 cm. If the floor area of the…

Q: A mechanical shovel is digging sand, each load weighs 500 kgf, The shovel lifts each load to a…

A: Given Weight, W = 500 kgf Height, h = 15 m Time, t = 1/2 min Flow…

Q: Blood pressure is 80 mm Hg . Convert it into absolute pressure? (1 atm = 760 mm Hg)

A: Absolute pressure is the sum of gauge pressure and atmospheric pressure. Pabs = Pg + Patm where…

Q: Blood pressure is 100 mm Hg . Convert it into absolute pressure? (1 atm = 760 mm Hg) A)760 mm…

Q: Argon is heated at 350 K with a mass flow of 4 kg/s as it passes through a pipe. Given that the heat…

Q: Determine the mass of ideal air inside the chamber at a volume of 10 m^3 , pressure of 3 bar and…

A: Given data: Pressure (P) = 3 bar = 3*105 Pa Volume of the chamber (V) = 10 m3…

Q: The relation between mass and volume flow rate can be shown with the help of the fluid property...

A: Volume flow rate is the amount of volume flowing through a cross section in a period of time. Mass…

Q: 1) Fill in the unknown properties for the materials given below. PLEASE EXPLAIN THE CALCULATIONS YOU…

A: Solution, Water All the values can be obtained using steam tables of water. To define a state only…

Q: In a turbine system, states A and B are homologous. If the net head ratio HA/HB =16 , volume flow…

Q: Ageothermal power plant was installed at the rear side diff of Mayon Terrain that generates thermal…

Q: The quality of refrigerant R134a is increased from 0% (saturated vapor) to 50 %. Which one of these…

A: The quality of refrigerant R134a is increased from 0% (saturated vapor) to 50 %. Which one of these…

Q: A steel rod is heated from 25 to 250 degree Celsius. Its coefficient of thermal expansion is 10-5…

Q: Water with a mass of 2.245 kg changes from a saturated liquid state to saturated vapor at a constant…

A: Given : mass (m) = 2.245 kg Temperature (T) = 100° C To Find : Internal energy = ?

Q: A fruit of 250 grams is cooled inside refrigerator from 30 C to 2 C. Determine the amount of the…

A: Given data: Mass of the fruits (m) = 250 g = 0.25 kg Initial…

Q: A solid aluminum (SG = 2.70) has a measured mass of 66 grams in air and 46 grams when immersed in…

Q: A stationary building contains 13 kg of Helium (He) at a temperature of 20 oC and a pressure of 110…

A: Given: The mass of helium, m1 = 13 kg The temperature of helium, T1 = 20°C = 293 K The pressure of…

Q: The objects in the shape move by sticking to each other after colliding in a frictionless plane.…

A: Given, m1=5 kg, v1=2 m/sm2=3 kg, v2=-2 m/s

Q: A rod of length L and mass M is fixed so that it can rotate around point O. As shown in the figure,…

A: Consider the diagram shown below for the given system at an instant. From the above right triangle,

Q: Maximizing the wind velocity of 92 m/s and 25 units of wind turbine was installed at the seaside…

Q: The air with a density of 1.1 kg / m^3 enters the duct of the air conditioning system with a flow…

Q: An electronic device will be cooled by a fan with a volumetric flow rate of 0.34 m³/min. If the air…

Q: A spherical neutrophil 16µm in diameter is resting as shown in the attached photo. The pressure…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: 1. is referred as the temperature at a stagnation point in the flow of fluids in fluid mechanics and…

A: As per given question 1. ........is referred as the temperature at a stagnation point in the flow…

Q: ) One kg of gas at 240 °C,expands adiabatically, so that its volume is doubled and th temperature…

Q: Water flows through a pipe network. The pressure, velocity, and altitude at a given point (point 1)…

A: Option a is correct 6.33m

Q: Carbon dioxide gas enters a pipe at a pressure of 3.7 MPa and a temperature of 496 K at a flow rate…

A: given data;pressure (P)=3.7MPa=3.7*106Patemperature (T)=496K carbon dia oxide (CO2) mass flow rate…

Q: A 0.60m3 tank contains saturated steam at 0.3 Mpa. Heat is transferred until the pressure reaches…

Question

What is the power of a steam jet 15mm in diameter moving at 750 m/s? Steam condition, 1.4 kg/cm², dry and saturated (v = 1.256m³/kg). (With drawing to fully understand the question)
a) 29.67 kW c) 19.67 kW
b) 39.67 kW d) 49.67 kW

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

An ideal gas has specific heat values of c_v=2 kJ/(kg*K) and c_p=3 kJ/(kg*K). Find change in temperature if the enthalpy change is 90 kJ/kg? A)270 C B)30 C C)50 C D)180 C E)135 C
Find the enthalpy of fluid at 100 kPa with a specific volume of 1 m^3/kg and internal energy 100 kJ/kg? A)100 kJ/kg B)150 kJ/kg C)200 kJ/kg D)250 kJ/kg E)not sufficient information
In figure (1), the block moves upward from position (A) to (B) though Ed = 2.5 m the distance (d = 2.5 m). Take (F1 = 22 N, F2 = 46 N, F3 = 58 N). F. 20° Figure (1) 50 F2 1) What is the amount of work produced by force (F1)? a) 35.3J b) 44.1J c) 17.2J d) 49.3 J e) 91.9 J f) 39.3 J g) None of them 2) What is the total amount of work produced by the three forces? a) 2.59 J b) 15.34 J c) 7.42 J d) 3.98 J e) 11.71 J f) 28.72 J g) None of them
kg 2. Oxygen at the rate of 1.36 undergoes a reversible isobaric process during which min KJ ,V1= 0.5 m3 and T1= 204 °C. For both non-flow and min its entropy change is -1.465 min K steady flow, change of kinetic and potential energy are both zero, compute: a) AU b) Δη c) Wnf d) Wsf
Please try to solve in 30 minute
A) W >0 8) W0 W0 W 0 Q2. The pressure in a gas pipe is measured by a mercury manometer as shown in the figure. One leg of manometer is open to atmosphere, if the difference in the height of mercury column in the two legs is 450 mm. Barometer reads the atmospheric 755 mm of mercury (Hg). Compute the pressure in the pipe in (kPa) and (bar).
39 - The speed of the air entering a nozzle at the nozzle exit was 196 m/s and its density was measured as 0.681 kg/m³. Since the mass flow rate in the nozzle is 1,421 kg/s continuously, which of the following is the outlet cross-sectional area of the nozzle? a) 48,325 cm² B) 49,373 cm² NS) 106,461 cm² D) 110,603 cm² TO) 84,678 cm²
Problem 1 A reservoir of glycerin has a mass of 1,200 kg and a volume of 0.952 cu. m. find a.) weight b.) unit weight c.) mass density d.) specific gravity Problem 2 If an object has a mass of 22 kg at sea level, a.) what will be its weight at a point where the acceleration due to gravity g=9.75 m/s² b.) what will be its mass at that point? Problem 3 What is the weight of a 45-kg boulder if it is brought to a place where the acceleration due to gravity is 395 m/s per minute? Problem 4 What is the specific weight of air at 480 kPa absolute and 21°C? Problem 5 Find the mass density of helium at a temperature of 4 °C and a pressure of 184 kPa gage, if atmospheric pressure is 101.92 kPa. (R=2079 J/kg-°K) Problem 6 At 32°C and 205 kPa gage, the specific weight of a certain gas was 13.7 N/m³. Determine the gas constant of this gas. Problem 7 Air is kept at a pressure of 200 kPa absolute and a temperature of 30°C in a 500-liter container, what is the mass of air? Problem 8 What pressure is…
Given problem: A certain gas with Cp = 0.529 Btu/lb.R and R = 92.6 ft.lbf/lbm°R expands from 5 ft3 and 80°F to 15 ft3 while the pressure remains constant at 15.5 psia. Compute the change in enthalpy. Choices: a.) 105 Btu b.) 100 Btu c.) 122 Btu d.) 202 Btu
9- Water pressurized with a gas in a cylindrical tankare available. Measured as li = 60 cm, b = 40 cm and 13 = 30 cm. Atmospheric pressure: Patm = 100 kPa ; Relative densities are: psu = 1, Poil=0.85 and pona=13.6. What is the pressure at point D? a) 150.0 kPa B) 176.7 kPa NS) 50.1 kPa D) 76.7 kPa TO) 96.8kPa
27. 1.8 kg of steam at 1.65 MPa, 300 deg C is compressed isothermically until it becomes ssaturated. What is a)P2, b)delta H, c)delta U, e)delta S, f)delta V, & g) WNF-
Electric power is generated in the hydroelectric power plant with a turbine-generator system, which has a water input of 45 m3 per second from a height of 53 meters and operates with 73% efficiency. Calculate the electrical power generated in the plant since the friction loss in the pipes is neglected. A) 1,7 MW B) 17 MW C) 32 MW D) 171 MW E) 23 MW