Some water is compressed from 1 atm pressure to 4 atm pressure at constant temperature. The initial density of water is 1000 kg/m³. Since the isothermal compressibility of water is α =4.8x10-5 atm-1, what will be the density change at the end of the compression process?    a) 1,153 kg/m³  B) 1.74 kg/m³  NS) 1,872 kg/m³   D) 1,105 kg/m³  TO) 1,101 kg/m³

Q: c) A piston cylinder assembly initially contains water at 75 kPa and 8 percent quality (x = 0.08)…

A: According to terms and conditions of bartleby we can only provide upto 3rd part. Thank you!

Q: Temperature in Baguio was 77°F, the barometric pressure was 29.8 in, and the relative humidity was…

A: The mole fraction of water in the air is the fraction of moles of water present in the air, Mole…

Q: Şekil-1 37 к T? 60kg m The rod with a mass of 50 kg in the figure above is homogeneous and its…

A: given data; mass (m)=50kgweight (w)=mg               =50*9.81…

Q: 3- A piston-cylinder assembly is in equilibrium with a volume of saturated liquid of 0.15 m³ and a…

A: Given data as per question  Volume of saturated liquid =0.15 m3 pressure = 700 kPa   Volume of…

Q: Patm=101kPa; g=9.81m/s² A substance is contained in a piston cylinder assembly with properties as…

A:

Q: QUESTION 10 This question is about springs and oscillations. A mass of 10 kg is attached to two…

A:

Q: Air fills a 2-m-diameter balloon at 20°C and 5 kPa gage. Additional air is forced into the balloon…

A: Given: Diameter of balloon, D1=2 m Temperature, T=20°C Pressure, P =5 kPa

Q: Find the enthalpy value at outlet?

A: Given, Enthalpy at the inlet of throttling = 293.5kJ/kg

Q: 1) If a gas is heated against a pressure, keeping the volume constant, then work done will be equal…

A: 1) The work done is given by W=P∆V, where P is pressure and ∆V is change in volume For a constant…

Q: An ideal gas has specific heat values of c_v=0.3 kJ/(kg*K) and c_p=1 kJ/(kg*K). Find change in…

A: Given data  for an ideal gas cv = 0.3 kJ/kg-K cp = 1 kJ/kg-K change in temperature (∆T) = 250oC   To…

Q: 4. A 100 liter tank contains a mixture of saturated liquid water and saturated steam at 370 °C. a)…

A: Answer: (a) If the volume of each phases are equal: ● The mass of liquid phase is 22.5938 kg. ● The…

Q: Determine the phase of the water at 100 kPa and enthalpy of 2675 kJ/kg?   a) superheated b)…

A: Given data: The pressure of the water is P=100 kPa The given enthalpy of the water is h=2675 kJkg

Q: 1-Static : is defined as the state of equilibrium of bodies affected by a system of force does…

A: 1) option d is correct( all option).  Body in static equilibrium should have zero moment and zero…

Q: Atmospheric pressures in the upper and lower floors of a building are shown on a barometer as 96.5…

A:

Q: 3. The cylindrical diving bell is open at the bottom and closed at the top, as shown. It is lowered…

A:

Q: Water vapor at a flow rate of 20000kg / h enters a steam boiler with a specific volume of 150 kPa…

A:

Q: 28. 2.5 kg/min of saturated steam at 4.6 MPa expand adiabatically until its temperature is 200 deg…

A: Mass flow rate, m˙= 2.5 kg/min= 2.560 kg/s State 1: Saturated steam and P1= 4.6 MPa State 2: T1=…

Q: In a piston-cylinder system there are 2kg of water at 200°C and 0.5MPA. The water is cooled at…

A: Given:T1=200°CP1=0.5 MPaP2=P1

Q: Water atp1= 5 bars andT1= 240◦C is inside a rigid closed container of volumeV= 0.5 m3, which…

A: Since we only answer upto three subparts, we will answer the first three. Please resubmit the…

Q: A mechanical shovel is digging sand, each load weighs 500 kgf, The shovel lifts each load to a…

A: Given        Weight, W =  500 kgf          Height, h = 15 m              Time, t = 1/2 min      Flow…

Q: The relation between mass and volume flow rate can be shown with the help of the fluid property...

A: Volume flow rate is the amount of volume flowing through a cross section in a period of time. Mass…

Q: t2 and b)p2 c)internal Heat and d)work

A: Given: p1=95.3+14.7 psia=15480 lb/ft2V1=0.6 ft3V2=3.6 ft3Cp=0.124 Btu/lbRCv=0.093 Btu/lbR To…

Q: 2. Both a gage and manometer are connected to a gas tank to measure its pressure. If the reading on…

A:

Q: In figure (4), the crate is initially at rest on the ground. If the motor exerts a force of F = (600…

A: F= (600 +2 S²) N m= 10kg S= 10 m   To find : What is the speed of the 10 kg crate? V=?

Q: A steel rod is heated from 25 to 250 degree Celsius. Its coefficient of thermal expansion is 10-5…

A:

Q: 10. The fuel gage for a gasoline tank in a car reads proportional to the bottom gage pressure as in…

A: Given: Height of tank, specific gravity of gasoline and water height Required: Height of air remain…

Q: A 100 liter tank contains a mixture of saturated liquid water and saturated steam at 370 °C. a) Find…

A: Answer: (a) If volume of each phases are equal: ◆ The mass of liquid phase is 22.5938 kg. ◆ The mass…

Q: In the following figure, we have a disk that has a force of 9.0 N. applied. The diameter of the disk…

A: Given Mass, M=50 kg Radius of disk, r= 0.060 m

Q: A solid aluminum (SG = 2.70) has a measured mass of 66 grams in air and 46 grams when immersed in…

A:

Q: A stationary building contains 13 kg of Helium (He) at a temperature of 20 oC and a pressure of 110…

A: Given: The mass of helium, m1 = 13 kg The temperature of helium, T1 = 20°C = 293 K The pressure of…

Q: A spherical balloon has a diameter of 9 m and contains Helium gas at a temperature of 38 °C and a…

A: Diameter of balloon, d = 9 m Temperature of Helium gas, T = 38 C = 38 + 273 = 311 K Pressure of…

Q: An 1.000 L aluminum pot is filled to the brim with water and heated from 10.0°C to the boiling point…

A: Solution:

Q: Water pressurized with a gas in a cylindrical tank are available. It is measured as l1 = 60 cm, l2 =…

A: Given as per image in question: l1 = 60cml2 = 40cml3 = 30cmPatm = 100KPaPw = 1000Kg/m3Poil=…

Q: A gas-filled piston-cylinder unit with volume 2 m³ compressed and pressure 100 kpa. On the piston…

A:

Q: A spherical neutrophil 16µm in diameter is resting as shown in the attached photo. The pressure…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: Initial volume b) Final temperature c) Work done d) Heat added. e) Change in internal energy.  For…

A:

Q: ) One kg of gas at 240 °C,expands adiabatically, so that its volume is doubled and th temperature…

A:

Q: 4) An ideal gas undergoes a constant volume (isochoric) process in a closed system. The heat…

A: Two objective type question given related to…

Q: An irregularly shaped object floats freely in water (y = 62.4 lbf/ft'), such that 20 of the volume…

A:

Q: In figure (1), the block moves upward from position (A) to (B) though the distance (d = 2.5 m). Take…

A:

Q: .5 kg of an ideal gas undergoes an isentropic process from 657 kPa gage and a volume of 0.017 cubic…

A: