Atmospheric pressures in the upper and lower floors of a building are shown on a barometer as 96.5 kPa and 97.5 kPa, respectively. Calculate the height of the building if the density of the air is 1.06 kg / m^3. A) 9376 m B) 943 m C) 9280 m D) 102 m E) 96 m

Q: Heat transfer occurs whenever there is a ____ difference between two substances. a) volume b)…

A: Energy transfer is movement of energy from one place to another place. And there should be a…

Q: As shown in the figure, a rod of mass m= 1 (kg) and length L = 1 (m) is standing between the…

A:

Q: There is saturated water vapor at 135 ° C in an insulated, constant volume closed container. It is…

A: Given data: The temperature for the saturated vapor is T1=135°C The temperature after cooling is…

Q: QUESTION 10 This question is about springs and oscillations. A mass of 10 kg is attached to two…

A:

Q: Piston-cylinder device contains 2 kg of steam. The steam undergoes an internal energy change of -40…

A: Given data: Change in internal energy  = -40 kJ/kg Heat transfer = -50 kJ Need to determine the…

Q: 18. The airplane shown is in level flight at an altitude of 355 m and a speed of 85.0 m/s. At 85.0…

A:

Q: Questions 1,2 and 3 In the figure shown, if F, 250 lb, and F₂= 200 lb, Determine the following: 1)…

A: Given data :- F1 = 250 lb                        F2 = 200 lb

Q: A 2,500-kg car is rounding the curve of radius 250 m. If the road is bank at an angle of 10°, what…

A:

Q: In figure (2), the friction coefficient between the crate and truck top surface is (0.5). If the…

A:

Q: - The pressure of a closed vessel with a constant volume of 22.4 liters is 300 kPa. Which of the…

A:

Q: A 300 cc solid weigh 180 grams in water and 240 grams in water and 240 grams in oil whose relative…

A: Volume of solid, V= 300 cc = 300 cm3= 300*10-6m3 Mass of solid in water, M1=180 grams = 0.180 kg…

Q: Fluid with a density of 900 kg/m^3 is applying pressure on the gate shown. The depth of the water is…

A: Given data: Density of the fluid, ρ=900 kg/m3. Height of the gate, h=12 m and it's width, b=4 m. As…

Q: 3. The cylindrical diving bell is open at the bottom and closed at the top, as shown. It is lowered…

A:

Q: luid with a density of 900 kg/m^3 is applying pressure on the gate shown. The depth of the water is…

A: Write the expression for the hydrostatics force.

Q: In figure (4), the crate is initially at rest on the ground. If the motor exerts a force of F = (600…

A: Disclaimer: Since you have asked multiple questions, we will solve the first question for you. If…

Q: 3- The gas in a reciprocating cylinder expands and moves the piston 12 cm. If the floor area of the…

A:

Q: CAMERO 1. A gage attached to a pressurized nitrogen tank reads a gage pressure of 70.5 cm of…

A: Note: As per the policy, we can solve the first three parts. Please resubmit the remaining part…

Q: For ideal gases, .... is a function of temperature only   a) pressure b) specific volume c) density…

A:

Q: A mechanical shovel is digging sand, each load weighs 500 kgf, The shovel lifts each load to a…

A: Given        Weight, W =  500 kgf          Height, h = 15 m              Time, t = 1/2 min      Flow…

Q: During a steady flow process, the pressure of the working substance drops from 200 to 20 psia, the…

A: Since you have posted a question with multiple sub parts, we solve first three sub parts for you. to…

Q: 26. A 60-kg rectangular box, open at the top, has base dimensions 1.0 m by 0.8 m and a depth of 0.50…

A: option B is rhe correct option

Q: Determine the mass of ideal air inside the chamber at a volume of 10 m^3 , pressure of 3 bar and…

A: Given data: Pressure (P) = 3 bar                    = 3*105 Pa Volume of the chamber (V) = 10 m3…

Q: A 7.80-g bullet moving at 575 m/s penetrates a tree trunk to a depth of 5.50 cm. What is the average…

A:

Q: The quality of refrigerant R134a is increased from 0% (saturated vapor) to 50 %. Which one of these…

A: The quality of refrigerant R134a is increased from 0% (saturated vapor) to 50 %. Which one of these…

Q: In figure (4), the crate is initially at rest on the ground. If the motor exerts a force of F = (600…

A: F= (600 +2 S²) N m= 10kg S= 10 m   To find : What is the speed of the 10 kg crate? V=?

Q: A steel rod is heated from 25 to 250 degree Celsius. Its coefficient of thermal expansion is 10-5…

A:

Q: For ideal gases, .... is a function of temperature only       A)change of density

A: Given data :-  For ideal gases, .... is a function of temperature only

Q: As shown in the figure, when the points P and Q move downward with a velocity of v =9 (m/s), what is…

A: Solution:

Q: Fluid flows through the venture tube shown below. Pressure at section 2 is equal to 100 kPa. If…

A: Given data: P1=200 kPaP2=100 kPa Density of mercury ρHg=13500 kg/m3

Q: In the following figure, we have a disk that has a force of 9.0 N. applied. The diameter of the disk…

A: Given Mass, M=50 kg Radius of disk, r= 0.060 m

Q: As shown in the figure, if the velocity of the center of mass of the small cylinder is v = 8 (m/s),…

A:

Q: A piston cylinder with a volume of 0.3 m3 contains 0.7 kg of water at a pressure of 0.6 MPa. At…

A:

Q: A stationary building contains 13 kg of Helium (He) at a temperature of 20 oC and a pressure of 110…

A: Given: The mass of helium, m1 = 13 kg The temperature of helium, T1 = 20°C = 293 K The pressure of…

Q: A 1-m diameter and 1.6-m height cylindrical drum is filled with a fluid whose density is 850 kgm/m3.…

A:

Q: The objects in the shape move by sticking to each other after colliding in a frictionless plane.…

A: Given, m1=5 kg, v1=2 m/sm2=3 kg, v2=-2 m/s

Q: In figure (2), the friction coefficient between the crate and truck top surface is (0.5). If the…

A: Given, Initial velocity of truck = v = 50 km/hr = 13.89 m/s Friction coefficient between crate and…

Q: An electronic device will be cooled by a fan with a volumetric flow rate of 0.34 m³/min. If the air…

A:

Q: A spherical neutrophil 16µm in diameter is resting as shown in the attached photo. The pressure…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: 4. Andrew, whose mass is 60 kg, spins a ball of mass 0,4 kg on a frictionless table top with a…

A: Given: Mass of Andrew = M = 60 kg Mass of ball = m = 0.4 kg Angular velocity = ω= 5 rad/s length of…

Q: ) One kg of gas at 240 °C,expands adiabatically, so that its volume is doubled and th temperature…

A:

Q: An ideal gas has specific heat values of c_v=2 kJ/(kg*K) and c_p=3 kJ/(kg*K). Find change in…

A:

Q: Differential area dA of a gate is given as ydy where dy is the differential length and y is the…

A:

Q: 5. A block of m= 20 kg is acted upon by two forces as shown in the figure. (in m/s2) of the block?…

A: Given:Mass of the block, m=20 kgForces acting on the block:F1=40 NF2=30 N

Q: In figure (1), the block moves upward from position (A) to (B) though the distance (d = 2.5 m). Take…

A:

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.