What is the power absorbed by the 900 ohms resistor in the figure shown below? 0.1A 100n 2000 12002 2600300 2000 soon 2000

Q: • In the source room you connect a battery of 20V to terminals A and B, A being the point of higher…

A: Here, we have given two rooms, one of them is the source room and the other one is the sink room.…

Q: Is there a limit to the series voltage a chain of these batteries can achieve?

A: we need to explain given statement.

Q: Why is it important to know you measure current through a component and voltage across?

A: Please find your answer below in step 2

Q: 1-4 A d'Arsonval meter movement with a full-scale deflection current rating of 200 μA and an…

A: Answer: Full-scale deflection current   Ifs = 1 mA internal resistance   Rm = 500Ω of an half-wave…

Q: 9 9 n. R7 6 0 6n U 6

A:

Q: 4.0 Ω 5.0 Ω. 18 V 3.0 Ω 6.0 Ω

A:

Q: We want to make a resistivity measurement. How should we connect the probes of the multimeter? Drag…

A: a multimeter is a portable device that can be used to take various electrical measurements like,…

Q: Current, Resistance, ohms (minimum value) Color Coded Resistors Voltage, volts ampere 8 batteries 7…

A:

Q: Across a 230 V, 60 Hz powers supply is a 15 ohm non-inductive resistor. What is the equation of the…

A: Given,  Voltage source value =230V RMS Therefore, the voltage value = Vp = VRMS ×sqrt(2) =…

Q: 12 V 2 kn 3 kn 4 mA 1 kn 3 kn 2 kn 1o

A: The voltage drop across 2k ohms is determined for the above-shown circuit diagram

Q: 2. 3 Ω .5Ω + 24 V 3 a b 3 0 1Ω ww

A:

Q: What is the power dissipated by the 0.500-ohm load resistor that is connected to a 12.0-V emf with…

A: First we will find out voltage across load resistance.then We will find out power across load .

Q: A 12-V DC automobile head lamp is to be used on a fishing boat with a 24-V power system. The head…

A: Headlamp voltage=12 V Fishing boat power system voltage=24 V Headlamp rating=50W   The power across…

Q: Find the current in the given figure. Let R₁ 2 ohm, R2 = 3 ohm, R3 = 6 ohm, and Va = 12V. Va 202 ww…

A: GivenThe op-amp circuit with DC supply is given by,Here DC supply voltage is .To findThe current  in…

Q: 6.IF THE VOLTAGE AT RESISTOR RX IS 12VOLTS, WHAT IS THE TOTAL CURRENT AND THE VOLTAGES AT THE 5KOHM…

A: In the circuit, all the 3 resistors and voltage source are connected in series which that same…

Q: A DC electrical circuit with a 24-volt power supply has two resistors in series of 150 ohms and 430…

A: Let us find the voltage drop across the 430 ohm resistor using ohm's law and finding the current in…

Q: Calculate the current through the 80-ohm load resistor RL.  The source voltage is 80 volts.  The…

A:

Q: Determine the voltage across R1 in the figure below, if the source is 10 volts, the Zener is 6.8…

A:

Q: What is factor of a cable at 5 degrees celcius when calculating resistance

A: The solution is provided in the following section.

Q: What is the total power dissipated by the circuit?

A:

Q: Which resistor in Figure 1 must have the largest power-dissipation rating?Explain.

A:

Q: How does the magnitude of the voltage across the power supply compare to the voltage across the bulb…

A: Concept If the supply element (active source) and absorbing load type of element are connected in…

Q: 4) For circuit shown in Figure (4): Determine the voltage drop across 90. a) 17V 20 90 b) 15V c) 19V…

A: Given circuit is:

Q: 3. а) For the circuit show below determine the transfer function H(s). 0.1 μF 2 k2 200 mH i(t) (1) +…

A: In laplace domain , circuit can be draw as

Q: How much current is drawn to the 12-V source? What is the voltage on each resistor?

A:

Q: Calculate the current through the 80-ohm load resistor RL.  The source voltage is 80 volts.  The…

A:

Q: A 12-V DC automobile head lamp is to be used on a fishing boat with a 24-V power system. The head…

A: Given     Rating of lamp ,P = 50W Voltage rating of lamp ,VL= 12V Available Voltage, V= 24 V

Q: What is the greatest voltage that can be applied across a -W, 2.7-MN resistor without causing it to…

A:

Q: What are the differences between load resistance in a circuit and internal resistance in a battery?…

A: The internal resistance of the battery refers to the resistance that is offered by the battery, as…

Q: 4. Design a low-pass filter circuit that has the transfer function. Assume all capacitors to be…

A: Given transfer function of a low-pass filter circuit . HL(s) = -628^3/(s +628) (s² +628s +628²)…

Q: A voltage sources an IR drop across a 20 ohms R1, 60 volts across a 30 ohms R2, and 180 volts across…

A:

Q: ww R

A:

Q: What is the power provided by the 3V source to the circuit

A:

Q: 5 Determine the voltage at resistor R1. (assume LED forward voltage is 2.0 volts) * R2 2000 5V D1 R1…

A: In this question we will find voltage across resistor R1 .....

Q: A circuit component carries a current of 2.4 amperes and has a voltage drop of 10 volts across it.…

A: Given that,             current I= 2.4A             voltage drop Vd=10V             resistance R=?…

Q: VT= 10 V A R₁ 150 $2 R₂ 15 $2 R3 1052 B + Lo

A:

Q: 1 20 O 30. O 40. O 50. O 60. O 70. C:

A: We need to find out equivalent resistance for given circuit

Q: 6. The equivalent total resistance in the circuit in Figure 1 is 2200 E=7V- 4700 1000. 100. 3300…

A:

Q: The current enters to the positive terminal of a device is i(t) = et amps, and the voltage across…

A: Given, Current, it=e-4t A Voltage, vt=3didt               vt=3ddte-4t=-12e-4t V Time, t = 0 to 2 sec

Q: The resistivity of on alley is (51 * 10-8n.m). The are : 15 cm long, 6cm wide , and 0.014 cm thick.…

A: For figure 1, Cross sectional area = 0.014*10-2*15*10-2=0.21*10-4m2 Length of  material= 6 cm…

Q: Circuit 1: 830 900 1000 1500 640 700

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions…

Q: What is the advantage of using the voltage divider technique in determining the voltage across a…

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.