What do you mean by glaciofluvial deposits or stratified drift?
Q: 3. What type of rock is most prone to contain sinkholes? Why?
A: To find out the rock that is most prone to sinkhole.
Q: .Define the Following unconformity, hiatus, Environmental of Deposition, formation, Cretaceous
A: Unconformity- A contact between two rock units in which the upper unit is usually significantly…
Q: ted at time t=0, d at an angle of 4 the (a) horizonta
A:
Q: The coordinates of two points in a straight line section of a semi-logarithmic graph of the…
A: given: e1=2.50e2=1.75σ'1=150 KN/m2σ'2=600 KN/m2
Q: plication of load increment. How many months will be required to reach a settlement of 8 cm ? Assu
A: Degree of settlementU1=4cm16cm=0.25TV1=π4U2=π40.252=0.04908U2=8cm16cm=0.50TV2=π4U2=π40.52=0.196349
Q: 5. A soil on a hillslope has a slope-normal thickness of 2.2 m, bulk density of 1,625 kg/m³ and a…
A: Answer (5) We are given thickness of a soil strata h = 2.2 m bulk density ρ =1625 kg/m3 slope…
Q: Explain the Contact Pressure and Contact Settlement ?
A: Contact Pressure The contact pressure is the ratio of the normal load to the true contact area,…
Q: 32° S63°W. A well is started at the superface is drilled vertically 49.6 feet deep. What…
A: Given data Dips 32° S63°W Vertically 49.6 feet deep
Q: How do metamorphic rocks that form deep inside the Earth under ductile conditions get exposed to the…
A: The conditions required to form a metamorphic rock are very specific. The existing rock must be…
Q: r is incorrect again, it should be positive 134.6 kN/
A: Given:- ∅=200qu=140kN/m2 To find:- pore water pressure
Q: Explain the Correlations for Undrained ShearStrength (cu), Preconsolidation Pressure (standard…
A: Undrained Shear Strength (cu): The undrained shear strength is the parameter used to determine the…
Q: What is Westergaard Stress Distribution?
A: The Westergaard equation is related to the stress distribution in the soil when it is subjected to…
Q: 3. The type of this folds is... 4. The type of this Fault is... Hangingwall 5. The type of this…
A: Types of folds: Compare figure 1 with figure 2 Hence the given fold is an symmetrical type fold
Q: 16. E. Hoek and E. T. Brown (1980) introduced the empirical criterion of failure for rocks: 01.p qu…
A:
Q: What are Stratified Drifts ? Explain the cause of Stratified Drifts ?
A: Its a predominantly sorted sediment laid down by or in meltwater from glaciers and includes sand,…
Q: What factor of formation most influences the texture of igneous rocks?
A: An igneous rock is a rock produced by the crystallization and solidification of cooling magma.
Q: A smooth two-dimensional flat plate is exposed to a wind velocity of 70 km per hour. If the laminar…
A: Given : Wind velocity = 70 km/hr Rex = 3 X 105 Kinematic viscosity of air = 1.49 X 10-5 m2/sec This…
Q: 1. Identifying the rock type in a basis in site investigation prior to a more detailed study on the…
A: Rock is any solid mass of minerals that occur naturally . Rocks are mainly classified based on their…
Q: 3. What is the equivalent shear wave velocity of the soil layer? How to calculate?
A: Brief concept- Soil- Soil is a mixture of organic and inorganic matter, minerals, and various other…
Q: A copper bearing host rock is blasted and found to exhibit a swell factor of 30%. What is the…
A:
Q: Present proposals for subsurface structures in response to the hydrostatic pressure of a given…
A: There are a number of options to consider when designing subsurface structures that can withstand…
Q: 13 - The phenomena of caves to develop in limestone is called; a) Jurassic b) horst 06935 c) Astatic…
A: Karst is made mainly of solid rock, such as limestone, with small beds and cracks. Karst often…
Q: What is the rating of the rock under "Spacing of Discontinuities" parameter? The average joint…
A: Given data in question Spacing of discontinuities 8 joint /m To find out Rating of the recovered…
Q: Briefly indicate the difference between a normally consolidated and an overconsolidated soil…
A: A soil which has never had an effective vertical stress that was higher than its current effective…
Q: Provide generalized comments on the hardness, soundness, and durability associated with the three…
A:
Q: Explain the various ways in which the rock mass could be estimated. 2. Which is the preferred choice…
A: Various parameters used to evaluate the rock mass Joint spacing Block volume Weathering Roughness…
Q: Earth materials always trace the complete rock cycle from sediment through igneous rocks. a. True b.…
A: Answer :- 2. False Explanation,:- Every rock could go through the complete rock cycle,but it may…
Q: rlaying or top layer.Explain briefly why is this
A: Each layer within a stratigraphic sequence is isotropic with regard to its propagation velocity, ray…
Q: QI: Explain in depth about Folds and Faults. Process - Factors influenced Types with picture/diagram…
A: Disclaimer "Since you have asked multiple question, we will solve the first question for you. If you…
Q: a) When did contour lines meet? b) What is the equivalent of rhyolite? c) What is the source of…
A: As per guidelines we are supposed to answer only first 3 questions so please repost rest questions…
Q: The dip direction of a rock layer is 293 °. What is the strike of this rock layer? O AN13E O B)N23E…
A: Given Data: Dip direction of rock layer=293o To find strike of the rock layer.
Q: 6.2 Differentiate between: a- Orogeny and epirogeny b- Conformable and unconformable beds Regular…
A: Difference are below mentioned
Q: 11.5 Liquefaction is a phenomenon in which the strength and stiffness of a soil is reduced by…
A: Liquefaction: Soil liquefaction is the phenomenon in which strength and stiffness of the soil…
Q: If material is dumped from a fixed positin, a conical spoil bank is created. True False
A:
Q: In terms of capability of rock to sustain load, which one tends to be LOWER in terms of value, is it…
A: Following is required answer :
Q: Water is flowing vertically upward in a sand with a saturated unit weight of 20 kN/m3. At what…
A: Given-saturated unit weight=20 kN/m3
Q: what is confined and unconfined aquifer? What are their differences?
A: A confined aquifer is condition where the ground water table of water mass is confined between two…
Q: Example 5.2: - Formation water sample with solids concentrations of calcium (Ca) = 460 ppm, sulfate…
A: Given data: The concentration of Ca=460 ppm The concentration of SO4=1400 ppm The concentration of…
Q: What is RQD? What kind of rock is a rock with RQD = 20?
A: Rock-quality designation (RQD) is a measure of the degree of jointing or fracture in a rock mass,…
Q: 131.6 kPa 53.6 kPa 315.2 kPa 315.2 kPa 35 131.6 kPa 2. Find Normal and Shear Stress at Failure Plan…
A:
Q: A free standing stockpile of loose dry sand has a friction angle of 35 degrees. What is the stable…
A: Friction angle, To find: Stable slope angle.
What do you mean by glaciofluvial deposits or stratified drift?
Step by step
Solved in 2 steps with 4 images
