Water is to be pumped at a head of 142 ft, the water temperature being 100°F and the barometric pressure being 14.3 psi. At intake, the pressure is a vacuum of 15 in Hg snd the velocity is 13 fps, what is tge net positive suction head (NPSH)?

Q: H.w : nitrogen gas flows into a convergent nozzle at 200 kpa 400 K and very low velocity it flows…

A:

Q: If the net positive suction head (NPSH) requirement for the pump is not satisfied, then, Select one:…

A: ANSWER = (a) cavitation will formed.

Q: How do we find the force and pressure exerted in using a 12 volts mini reverse air pump and a 25mm…

A: Given: Mini reverse air pump = 12 V Round suction cup diameter= 25 mm To find: Force and pressure…

Q: Differentiate between Impulse and reaction

A: The basic difference between impulse and reaction turbine is that in impulse turbine steam flows…

Q: Q3: For ideal fluid, Find the force required to hold the blade in position, if the weight (1kN) and…

A:

Q: A pump draws benzene at 25°C from a tank whose level is 2.6 m above the pump inlet. The suction line…

A: Atmospheric pressure=98.5kPa Vapour pressure = 13.3kPa Head loss= 0.8m To find net positive suction…

Q: For ideal fluid, Find the force required to hold the blade in position, if the weight (1kN) and…

A: Given: The weight of blade, W = 1 kN The discharge, Q = 0.4 m3/s

Q: Bernoullis equation assumes a. Fluid is compressible b. Flow is unsteady c. No friction in the…

A: Bernoulli's equation assumes an ideal and incompressible fluid. So the answer will be an option (c).…

Q: At the inlet to a certain nozzle the enthalpy of fluid passing is 2800 kJ/kg. In addition, the velc…

A:

Q: boiler feed pump water at 90 C and enthalpy of 376.92 kJ/kg. It operates against a head of 9.5 m…

A: Given: h1 = 376.92 kJ/kg H = 9.5 m eff =  0.7

Q: A 1inch diameter nozzle there is water flows under 400ft head to operate a turbine. There is 90%…

A: Write the diameter of a nozzle.   d=1 in=1 in×1 m39.37 in=25.4×10-3 m   Write the head of the water…

Q: A 32 m high down Comer-tank system operates lloo bar if the exit quality of the steam is what will…

A: Given             Volume, V = 32 m3 Initial pressure, P1 = 100 bar               Quality, x = 0.5…

Q: A pipe reducer with the pressure at A and B is 345kPa and 290 kPa respectively. the diameter at A…

A:

Q: How to work out a Bernoulli pipe diameter change to increase or decrease flow into a Ram pump drive…

A: To calculate the required diameter change to increase or decrease the flow into the Ram pump drive…

Q: Which of the ff are assumptions followed by the Bernoulli eq ?   the pump is working at 100%…

A: Given question: Which of the following are assumptions followed by the Bernoulli equation ?…

Q: 1) With the below nozzle arrangement, what pressure is needed in the pipe in order to get a nozzle…

A: From the given data,

Q: flow work relation (Wflow) is the same whether the fluid is pushed into or out of the control…

A:

Q: DC heater pressure = 50 psig, Assume: pump efficiency of 70%, water is at saturated cor ressure from…

A: TO given thatwater mass flow rate,m=100000Ib/hr=12.5998KG/Sout let…

Q: 3- Discuss the siphon process and what benefit of it?

A:

Q: 1. define the cutfof ratio and the compression ratio     2. air is compressed at a constant…

A: Define cutoff ratio and compression ratio

Q: A centrifugal compressor has a single stage and 4 stage model with suction conditions of 100 kPa and…

A:

Q: as density decreases, mass flow rate: a. de

A:

Q: Water at 40°F is flowing downward through the fabri- cated reducer shown in Fig. 7.11. At point A…

A: Given:Water temperature, T=40oFVelocity at point A, VA=10 ft/sPressure at point A, PA=60 psig=60*144…

Q: If the NPSHR is 3m less than the NPSHA you got on question number 2, determine the pump suction…

A:

Q: A fous stage centrifugal pump has four ideutical empelles, keyed to the same shaft. The shaf in…

A: A device which converts mechanical energy into pressure energy with the help of centrifugal force is…

Q: 3. The power output is 30 hp to a centrifugal pump that is discharging 900 GPM at which operates at…

A:

Q: As shown in the picture blew, a pump can deliver volume flow rate of    of water through a vertical…

A: Given   Flow rate, Q = 3.6 x 10-3 m3/s          Density = 1000 kg/m3       Height, h = 8 m…

Q: For transferring of water, a pump is installed in the height of 3 m above the surface of the water.…

A: hsp=Pρg=100kpa1000×9.81=10.19hs=3mhf=4mhvp=Pvρg=10kpa1000×9.81=1.019

Q: Assuming a permanent loss using the pressure drop from the 180 L/min flow rate and taking energy to…

A: Flow rate ,Q = 180 L/min or 0.003 m3/s Time = 24 hours

Q: In a direct boosted cold water system to tanks the pressure of the water main is 350 kPa vertical…

A: Given that, pressure difference in water =350kPa vertical height=65m residual head loss at tank=3m…

Q: What type of pump is shown in Fig. ? How does itoperate?

A: This is a flexible liner pump

Q: At the inlet to a certain nozzle the enthalpy of fluid passing is 2800 kJ/Kg. In addition, the…

A:

Q: 14) Calculate the actual pump and turbine work 525 °C Boiler 20 MPa Wturb.ou Turbine urdund Pump…

A: Answer: (a) The actual turbine work is 1177.6654 kJ/kg. (b) The actual pump work is 22.4709 kJ/kg.

Q: Q3) What is the maximum permissible difference in elevation between the water surface of an intake…

A: As we know the NPSH means the net positive suction head. it measures the pressure in the fluid by…

Q: Explain the effect of cavitation in turbine.

A: