Water at 15°C is transported from a large open tank to the bottom of another open tank above. The surfaces of the two tanks are kept at 160 ft apart vertically. The pipes used have an ID of 3.5 inches, and a total length of the pipe used is 150 ft. In the system, there are two fully open gate valves, 6 90° elbows, and 2 standard tees. The pump used has a mechanical efficiency of 60%, and the volumetric flow rate of water is at 35 (ft^3)/s. Frictional losses due to sudden contraction and expansion are negligible. Determine the Reynolds number of the flow

Q: pipes in parallel, the total friction head loss equals to the individual friction head loss in each…

A:

Q: Problem 2: Control volume and Bernoulli Water drains from a tank through two r = 0.01 m diameter…

A: Given  1)  2)  3)  Please Rate if this solution helps youThank You

Q: A pump is used to transfer crude oil from a non-pressurized oil tanker to a storage tank at a…

A: As all the units of the parameters in the given problem are irregular, convert all the units into SI…

Q: As seen in Figure 3 below, the water from the tank 1 is pumped to the tank 2 with a flow rate of…

A:

Q: A fertilizer delivery system is shown in the figure. The hose is made of a material whose…

A: Solution: Given Data: CR=0.12d=25 mmD=30 mmR=1.3 mV=5.4 m/sη=75%SG=1.1h=10 m - 1.2 m = 8.8 m

Q: Water with a specific heat of 1 BTU/lbm F is pumped using a 1-hp jet pump from a well that is 20 ft…

A: Given       Specific heat, C = 1 BTU / lbm           Flow rate, m = 5 gal/min…

Q: 5. Water is pumped at a rate of 6 x 10-4m³/s in a horizontal pipe of 0.04 m diameter and 150 m…

A: Flow rateDaimeter of the pipeLength of the pipePressure drop in the is 150.15 KPaHeight of the…

Q: The system in Fig 2 pumps water from a lower reservoir to a higher reservoir.  The pipe diameter is…

A: Given That: Pipe diameter dp= 0.235 m,L1=5 m, L2=4.5 m, L3=1.5 m, L4=0.6 m,impeller diameter d =…

Q: Figure 1 shows water at 20°C to be circulated from and to the reservoir. The 30 diameter pipe made…

A:

Q: 1. Water flows through a venturi meter. At the constricted section where the area is 24cm², the…

A: Given data:-Area at section 2-2, a2=24cm2=0.0024m2Pressure at section 2-2,…

Q: A pump draws 20 m3/h of water having a density of 1000 kg/m3 from the open storage feed tank to an…

A:

Q: Water (15 C) is transported from an open reservoir to the atmosphere through a new cast iron pipe (d…

A:

Q: A large container filled with water and uncovered for use in fighting fires in an ethylene…

A:

Q: Water is circulated from a tank of large proportions through a filter and then back to the mentioned…

A: Given, Power added to the water by the pump, Wp' = 200 ft.lb/a KL elbow = 1.5 KL Exit = 1 KL Valve =…

Q: Liquid propane, at its bubble point, is to be pumped from a reflux drum to a depropanizer. The…

A:

Q: Problem 4: During the daytime, water is drawn from an upper reservoir and is run through a turbine…

A: Step 1:Step 2: Step 3: Step 4:

Q: Two vertical circular cylindrical tanks are connected near the bottom by a short tube having a…

A:

Q: Water is retained in a small mountain lake whose surface is 280 ft above the inlet to the turbines…

A: Bernoulli's theorem is used in fluid dynamics and gives the relationship between the pressure,…

Q: Water at 25°C flows from the elevated tank to the pipeline and delivered at 150 L/min at a point…

A: Note: As per policy, We can solve the first three subparts. Please resubmit the remaining parts.

Q: Water flows between two reservoirs A & B. The water level in A is 400 m AOD and in B is 385m AOD.…

A:

Q: Water from an open tank elevated 5m above ground is allowed to flow down to a pump. From the pump,…

A: Given that, Elvation of tank, z=5 m,length of pipe, l=100 m,Number of elbow, n=2,Volume flow rate,…

Q: 5.9.5. Factory tests indicated that a cavitation parameter for a particular pump is o = 0.075. The…

A: Given: Cavitation parameter for the pump→σ=0.075  Pressure at the sea level→Patm=101.325 KPa…

Q: Determine the pump work of the oil piping system. The oil has kinematic viscosity of 0.0001 m²/s and…

A: Given:Kinematic viscosity of the oil, ν=0.0001 m2/sSpecific gravity of the oil, SGoil=0.79Pipe…

Q: As shown in the figure, the water flows from the ground floor of a three-storey house to the second…

A:

Q: . In reference to problem number 1, if another pump was used having a power requirement of 12 hP…

A: Concept:-  It is a fliud machinery question in which pump is delivering the water at a certain…

Q: A centrifugal pump was purchased to pump the water from an open tank to a water jet spray cleaner.…

A: Given Datagauge pressure=75kN/m2d=0.64mh=15m

Q: A 28-in pump is used to deliver water from a lower reservoir to a higher reservoir . The total…

A: Given:d=10 inL=62 ftf=0.022H=365-0.04718Q2

Q: The figure below shows a fluid flow system that is designed to pump water at 20 °C from a lower…

A: Given:Water temperature, T=20oCLength of Suction pipe, Ls=20 mSuction pipe=312" schedule 40…

Q: In a direct boosted cold water system to tanks the pressure of the water main is 350 kPa vertical…

A: Given that, pressure difference in water =350kPa vertical height=65m residual head loss at tank=3m…

Q: A centrifugal pump is used to pump water at 25 ° C from a reservoir open to the atmosphere with the…

A:

Q: which is 14.17 m above the tank bottom and discharges to the atmosphere with a velocity in the…

A:

Q: A centrifugal pump is required to pump water to an open water tank situated 4 km away from the…

A:

Q: A water is pumped at a rate of 87.87 in3/min through a 0.197-in radius pipe on the main floor of a…

A: Given,  Flow rate of water , Q = 87.87 in3/min =1.4645 in/s Radius of the pipe at inlet, ri =0.197…

Q: A 28-in pump is used to deliver water from a lower reservoir to a higher reservoir . The total…

A: Given:d=10 inL=62 ftf=0.022H=365-0.04718Q2

Q: 3. A water from Agno River is pumped at 13.3 L/s using a submerged pump at an efficiency of 78% that…

A: Consider Bernoulli’s equation for steady flow between the points (1) and (2).…

Q: A pipe with a cross sectional area of 5x10 m' is delivering oil at a rate of 1x10 m/s at a pressure…

A:

Q: the diameter of the suction pipe is 385mm. The diameter of the discharge pipe is 268mm. If…

A:

Q: Two reservoirs are connected by a single 600 mm diameter pipe that is 3 km long. Take the head…

A: Bernoulli's equation Bernoulli's equation states total energy at point in the flowing fluid consist…

Q: B2. Determine the resistance of an aluminium coil of 1.25 cm as diameter consists of 14800 turns and…

A:

Q: A centrifugal pump driven by a 120-kW motor rotating at 2400 rpm is used to pump 20°C water in a…

A: Solution: Given Data: P=120 kWN=2400 rpmT=20oCH=30 mη=70%h=9 m   To Find: (a) Calculate Zmax? (b) If…

Q: Water is pumped from a reservoir to a tank with a lift of 20.0 ft. The suction pipe, which connects…

A: Given data as per question Diameter of suction pipe =12 in Diameter of discharge pipe =10 in…

Q: A pump delivers water from a lake into a 6 ft diameter by 10 foot tall sealed pressurized tank…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.