Water flows through the pipe at the rate of 30L/s. The absolute pressure at point A is 200 KPa, and the point B is 8 m higher than point A. The lower section is 8 cm and narrows down to 5 cm diameter. Find the velocities of the stream at point A and B. Also, find the pressure at point B.

Q: An air tube is open at both ends and contains à constriction connected on both sides by a channel of…

A: The flow rate, Q = 12000 cm3/sThe diameter at section 1, D = 3 cmThe diameter at section 2, d = 1 cm

Q: In this system, d = 6 in., D = 12 in., Az₁ = 6 ft, and A5₂ = 12 ft. The discharge of water in the…

A:

Q: A liquid of a density e flows through a divergent pipe. An absolute pressure at the inlet is equal…

A: Bernoulli's principle states that the energy of the flow at the inlet of a pipe will always be equal…

Q: A horizontal pipe is full of flowing water.  At location A the velocity is 1.5 m/s and  the…

A: The Pressure of the water at B is 133.43 kN/m3.Explanation:Given:v1 = Velocity at location A = 1.5…

Q: A siphon pipe of diameter 250 mm contracts to a diameter of 100 mm over a vertical distance of 5 m…

A:

Q: What is the pressure at point 2 (kpa), if the water flows as irrotational inside the pipe? Given…

A:

Q: A 50-mm diameter siphon is drawing oil (S.G. = 0.82) from an oil reservoir as shown. If the head…

A:

Q: What is the pressure at point 2 (kpa), if the water flows as irrotational inside the pipe? Given…

A:

Q: Water is flowing through a horizontal pipe of diameter 200 mm at a velocity of 3 m/s. A circular…

A: We have, Diameter, d=200 mm=0.2 m,     V=3 m/s Diameter of circular plate, d1=150 mm=0.15 m (as…

Q: The SG of the oil in the tank is 0.93, and a plunger with a diameter of 5 inches is being pushed…

A: V1=0.5ft/s D1=5inch D2=30mm

Q: 5. A nozzle that discharges a 60-mm-diameter water jet into the air is on the right end of a…

A: To determine:the magnitude and direction of the resultant axial force.Given:The outlet diameter of…

Q: = Q2: As shown in figure (2), when the water jet of diameter 25mm and Vj 30 m/sec., determine the…

A:

Q: Assume the water in the first tank maintains its height and pressure. The valve is opened and after…

A: Solution: Given Data: P=200 kPaρ=1000 kg/m3D=5 cmPatm=100 kPa   To Find: Mass flow rate through the…

Q: Water "bubbles up" above the exit of the vertical pipe attached to three horizontal pipe segments.…

A:

Q: Water flows through the pipe contraction shown in the figure below. For the given d=0.11 m…

A:

Q: Qil A (30 N/s) flow throw the reducer of the proceeding problem ,the air in the (300mm) pipe having…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: Determine the inclination angle at point C for the water stream to reach a range of 10 m. Also…

A:

Q: What is the pressure at point 2 (kpa), if the water flows as irrotational inside the pipe? Given…

A: Solution:

Q: If the static pressure of that fluid in the pipeline is 4.3 ´ 104 Pa while its total pressure is 4.7…

A:

Q: ind the flow rate of water through the system shown for the turbine to produce 20 kW. Neglect…

A: Write the Bernoulli expression as follows.

Q: The diameter of the pipe at the larger end is 0.50 cm and at the smaller end is 0.20 cm, the larger…

A: Larger end: D1= 0.50 cmZ1= 7 mV1= 1.2 m/sP1= 5200 kN/m2 Smaller end: D2= 0.20 cmZ2= 3 m   To find:…

Q: Water flows steadily through the system shown below. The 4-in. section leads to a throat, followed…

A: Consider the diagram shown below for the given system as shown below. From the continuity equation,

Q: Determine the velocity of efflux from the nozzle in the wall of the reservoir of (a) * .Figure, (b)…

A:

Q: A jet of water strikes a stationary curved plate at one end at an angle of 30°. The jet of 75 mm…

A: It is asymmetrical curved plate and water jet strikes at the one end of the plate. Write the given…

Q: The figure represents a stream of water in a pipe. If the distribution of velocities in a section is…

A: For the solution refer below images.

Q: Q4/ Gas (p = 0.0022 lb/ft) flows through duct shown in fig. At A flow rate is 60 ft /s under a…

A:

Q: The level of mercury in the manometer has the reading shown in fig, Determine the velocity of the…

A:

Q: Water enters a motor through a 500-mm-diameter pipe under a pressure of 15 kPa. It leaves through a…

A:

Q: 3-56. A 2-in. Younded orifice exists in the horizontal bottom of a large tank. The water in the tank…

A: According to the given data H=12ft h=6ft Cc=1 d=2in=0.16667 ft we need to find  Discharge of the…

Q: AAA cir Water is flowing through a horizontal pipe of diameter 200 mm at a velocity 3 m/s. A…

A: Given:pipe diameter, D=200 m or 0.2 mvelocity of flow, v=3 m/sdiameter of solid plate, d=150 mm or…

Q: Vz = 5 m/s Az = 0.9 m² Water A = 0.3 m² V = 15 m/s A water jet enters horizontal section of the…

A:

Q: A fountain consists of a horizontal inlet pipe with a cross-sectional area, A1, which enters a block…

A:

Q: A horizontal water jet at 21°C issues from a circular orifice in a large tank. The jet strikes a…

A: The objective is to determinea)  The jet speed, vb)  The diameter, d of jet just downstream of the…

Q: Water circulates through the Venturi tube shown at 80°F. If an ideal flow is considered (without…

A:

Q: Following the pump, the pressure in a 6-inch inner smooth pipe conveying water is 20 pounds per…

A: SOLUTION : Given Data: Inside diameter of the pipe (d) = 6 inch = 0.1524 m Pressure (ΔP) = 20 psia =…

Q: A tank open at the top with a water level of 1 m has a hole at a height of 0.5 m. A free jet leaves…

A: Given:Water level in tank=1 m,Height of hole from the base=0.5 m,

Q: Water flows through the pipe contrac- For the given 0.2-m difference in manometer level, determine…

A:

Q: Turbulent water flows through the pump at 0.1 m /s. Total head losses between 1 and 2 are 15 m, and…

A:

Q: 2. Three smooth rubber-lined fire hose each 60 m long and having 22 mm nozzle, are connected to a…

A: