Consider the water pump shown in fig, Determine the power that the pump supplies to the water if the velocity of the water is at A is V= 2 m/s and the pressures at A and B are 175kPa and 350 kPa, respectively. Neglect friction losses.

Q: Situation 7: A schematic of a garden fountain is given in the figure. A pump located beneath a water…

A: Given: Volume flow rate is 250 gpm. The garden fountain is shown below:

Q: A 3.5-hp pump delivers 1140 lbf of ethylene glycol at 20°C in 12 seconds, against a head of 17 ft.…

A: Calculate the efficiency of the pump in %.

Q: a pump discharges 250 gpm of water at a temperature of 180 fahrenheit against atotal head of 152…

A:

Q: A water jet with a flow rate of 2.83 m3 / s is traveling at 6 m / s in the positive x direction. The…

A:

Q: 5. A nozzle that discharges a 60-mm-diameter water jet into the air is on the right end of a…

A: To determine:the magnitude and direction of the resultant axial force.Given:The outlet diameter of…

Q: A pump is driven at 1800 RPM and delivers 12 GPM at 2000 psi. If the volumetric efficiency is 90%,…

A:

Q: find the speed up with which it flows inside the hose.

A:

Q: An irrigation pump delivers water through a 6 - inches horizontal pipe flowing full at the outlet,…

A: If an object travels with constant velocity, then the motion of the object is said to be uniform…

Q: A jet of 50mm diameter impinges on a curved vane and is deflected through an angle of 175 degree.…

A: d=50 mmδ=175°θ=180-175=5°u=35 m/secQ=170 Lsec orQ=170×10-3 m3secSinceQ=AV170×10-3=π4×.052×VV=86.58…

Q: A swash plate piston pump has a maximum displacement volume of 40 ml/rev. The pump is driven at 1550…

A: given data; maximumdisplacement volume(Vmax)=40ml/revspeed(N)=1550rpmmechanical efficiency…

Q: A 20 mm diameter pipe forks, one branch being 10 mm in diameter and the other 15 mm in diameter. If…

A:

Q: The jet plane has a mass of 250 Mg and a horizontal velocity of 140 m/s when t = 0. Figure F(KN)…

A:

Q: 1a. Water flows into a tee fitting at a flow rate of 0.02 m3 /s. A pipe is connected to B. The…

A:

Q: Patm A water Tank C hi h2 As shown in the figure, at hi= 1.8 m, h2= 3.6 m positions, the water in…

A:

Q: The performance characteristics of a certain centrifugal pump are determined from anexperimental…

A: The objective of the question is to calculate the actual head rise across the pump and estimate the…

Q: The pressure after the pump in a 6-inch inside smooth pipe conducting water is 20 psia. The water is…

A: Given data as per the question Diameter of the pipe =6 in =0.1524 m The pressure of pipe =20 psia  =…

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.