Water flows through a horizontal pipe at a rate of 2.3 gal/s. The pipe consists of two sections of diameters 4 in. and 2.2 in. with a smooth reducing section. The pressure difference between the two pipe sections is measured by a mercury manometer. Neglecting frictional effects, determine the differential height of mercury between the two pipe sections.

Q: Water at 10°C flows through the system shown in the figure below at 0.38 m³/s. Energy loss in the…

A: Given data:The density of water at 10 degrees celsius isConsider point 1 on the free surface of the…

Q: A venturi meter with a throat diameter of 6 cm is fitted in a horizontal pipeline of 12 cm diameter…

A:

Q: 480 kPa 15 cm Water 445 kPa Reducer 8 cm

A: Flow through pipe given- d1=15cmd2=8cmQ=0.035 m3/sec

Q: Open tank (4 m long, 3 m height and 3 m wide) contains liquid (S-0.8) to height 1.5 m. If this tank…

A:

Q: An open cubical tank was initially fully filled with water. The water is leaking from the tank…

A:

Q: Determine the maximum allowable height, in metres, of a pump relative to a reservoir it is…

A:

Q: By applying a force F, a saline solution is ejected from the 10-mm-diameter syringe through a…

A:

Q: A cast iron pipe (roughness =0.26 mm or 0.010 inches) having a diameter of 100 mm is used to fill…

A:

Q: Problem 5.127: (Munson, et al. 6th ed.) Water flows steadily down the inclined pipe as indicated…

A: Diameter of Pipe= 6 inDistance between 1-2   L= 5ftDifference in the mercury level  X= 6 inAngle of…

Q: Oil with viscosity 7.8 x 10-4 lbs and specific weight 59 flows through the funnel below. ft²…

A:

Q: 1. What approximations, if any, can you make from the statement that the diameter of the tank is…

A: From the given problem it has been stated that diameter of tank is larger than diameter of nozzle.…

Q: A 15-ft-diameter tank discharges water at 50 F through a 2-in.-diameter sharp edged orifice. If the…

A:

Q: Eight cubic feet of water flow per second downward through this pipe line. When the upper pressure…

A: Pressure gauge in section 1, P1=25 lb/in2. P1=25(144)=3600 lb/ft2. Discharge, Q=8 ft3/s A1=π4(1)2=π4…

Q: We have two connected tanks with surface areas A1 and A2, both open to the atmosphere, filled with…

A: h1=Height between point 1 to the bottom in left tankd=Height between point 2 to the bottom in right…

Q: 8 m/s y 100 mm -X 30⁰ B. 100 mm

A:

Q: It is known that the pressure at the nose of an air- plane traveling at relatively low speed is…

A: Dear student, we are suppose to solve only 3 subparts. Please post other sub parts as a separate…

Q: Problem 5: A pressurized tank of water has a 10-cm-diameter nozzle at the bottom, where the liquid…

A: Taking point 1 above liquid surface and point 2 just after nozzle exit.

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.