Water flows in triangular V-notch steel channel, with vertex if 60°, at a velocity of 1.2m/s. Find the normal depth of flow if the channel is laid on a slope of 0.0017. use n=0.014 Group of answer choices 0..9m 0.8m 0..7m 0.6m

Water flows in triangular V-notch steel channel, with vertex if 60°, at a velocity of 1.2m/s. Find the normal depth of flow if the channel is laid on a slope of 0.0017. use n=0.014 Group of answer choices 0..9m 0.8m 0..7m 0.6m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: For the half-Vee channel in Fig., let the interiorangle of the Vee be θ. For a given value of area,…

A: Write out Manning's formula

Q: A TRAPE ZOIDAL CHANNEL WITH SIOES INCLINED 36° WITH THE HORIZOMAL ANND A 5.erm Bottomn WITH IS LA'D…

Q: The rate of discharge through the canal in the figure below is to be 11 m³/s. Find the width b and…

Q: Q(2): Design an earthen trapezoidal channel for water having a velocity of 0.6 m/s. Side slope of…

Q: Ex 4: Water flows at 600 ft/min in a right triangular flume for which n=0.012. Find the critical…

A: step 1-

Q: Two concrete pipes (n=0.01) must carry the flow from an open channel half square section 2m wide and…

Q: A rectangular channel (n=0.011) 18m wide is to carry water at a flow rate of 35 m3/s. The slope of…

Q: 2. A reservoir of water is connected to 8-inch-diameter pipe 50 feet long and discharging freely.…

A: Given:- The diameter of the pipe connecting reservoir = 8 inch The length of the pipe = 50 ft The…

Q: trapezoidal vn in figure is on a siope of the channel must carry 60 cfs. Determine the depth of…

Q: show that for a submerged hydraulic jump just downstream of a sluic gate, in a horizontal…

Q: Water flows through pipe AB 1.3m diameter at speed of 3m/s and passes through a pipe BC of 1.6m…

Q: Q5) Calculate the (i) water discharge (m'/sec)and (2) Manning's constant for the flow through an…

A: We have above given data we have to find discharge and Manning's constant

Q: 07. (a). A most efficient trapezoidal section is required to give a maximum discharge of 21.5 m'/s…

Q: find the depth

A: In this type of flow ,the hydraulic gradient line coincides with the free surface.Flow in…

Q: A 12" pipe carrying 3.93 ft^3/s connects to a 6" pipe. Find the velocity head in the 6" pipe. a.…

Q: Pressurized tank delivering a vertical jet. Compute the required air pressure above the water to…

A: Apply Bernoullis theorem P1γw+v122g+z1=P2γw+v222g+z2

Q: Find the flow for a rectangular channel, 5 m wide for uniform at depth of 2 m. The channel has a…

A: A = Flow Area, (ft2) n = Manning's Roughness Coefficient. R = Hydraulic Radius, (ft) S = Channel…

Q: Water flows in the channel shown in the figure below at a rate of 90 ft3/s. Determine the minimum…

Q: Consider the flow under the sluice gate of Fig. . Ify1=10 ft and all losses are neglected except the…

A: Assume the flow is frictionless. Equate the specific energy at section 1 and 2, we get…

Q: D-3ft Slope = 151. Pipe with a diameter of 3ft, longitudinal Slope 1.500, a roughness Valve M" to…

A: Given, D = 3ft S = 1.5% n = 0.013

Q: Q (5-8)/ Water flows uniformly in an earth Trapezoidal cross section open channel. Data available…

Q: Water (p =10 kg/m³) flows through the shown horizontal pipeline. At section (1), the flow velocity…

A: ρ = 10Kgm3P1 = 5KPa = 509.8581Kgm2v1 = 6msArea of the pipes = a = .15m2 Patm = 1498.9829 Kgm2 v1 =…

Q: Decimal Places required in the final answer: 3 El 100m A El 82m B 1500 m, 450 mm, f 0.0225 Q.500 m,…

Q: depth of 2 m. The bed slope as 1 in 1 .slope 1:2 6

Q: The velocity components in the x and y directions for an incompressible flow are given as u = (-5 +…

A: Please refer the attached image for complete solution. THANK YOU.

Q: 4. A 200 mm line discharges water and hits 4.5 m below its original level. The point where water jet…

A: given that Cc =0.61 Cv =0.97 X =9.2m Y = 4.5m

Q: Find the rate of flow in m3/s and conveyance for a rectangular channel 5.0 m wide for uniform flow…

Q: Points A and B are 5km apart along a new 60cm diameter cast iron pipe carrying water. A is 9m higher…

Q: 10. Water is flowing through a 1m diameter pipe at 7.9 m3/s. Which of the following is closest to…

Q: 3. A rectangular channel (1.4 m wide) is shown on the right. Water flows down the incline with the…

A: As per guidelines we need to answer only first question so please repost rest questions separately.

Question

Water flows in triangular V-notch steel channel, with vertex if 60°, at a velocity of 1.2m/s. Find the normal depth of flow if the channel is laid on a slope of 0.0017. use n=0.014

Group of answer choices

0..9m
0.8m
0..7m
0.6m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Q7) Water flows from a large reservoir to a smaller one through a 5-cm diameter smooth piping system as shown the in the figure. Determine elevation Z1 for a flow rate of 6 L/s. The dynamic viscosity of water is (0.001307 Pa.s). Z₁ = ? Sharp-edged entrance, K₁=0.5 D=5cm -Control volume boundary 9m -Standard elbow, flanged, K₁=0.3 Gate valve, fully open K₂=0.2- -80 m- 4 =4m -Exit, K₂=1.06
3) Water flows in a triangular V-Notch steel channel, with vertex angle of 60°, at a velocity of 1.2 m/s. Find the normal depth of flow if the channel is laid on a slope of 0.0017. Use n=0.014.
4) If water flows at 100 kg/s through the double wye at B, at 70 kg/s through C, and at 90 kg/s through D, determine the average velocity of flow through the pipe at A. (Answer: V₁ = 3.68 m/s) 300 mm 200 mm 100 mm 200 mm
A 3-m wide rectangular concrete channel has a normal depth of 1.25 m when the discharge is 8.75 m³/s. The slope of the channel is classified as: Select an answer and submit. For keyboard navigation, use the up/down arrow keys to select an answer. a b с d mild critical steep very steep
Q3/ The width of the trapezoidal channel is (2 m) and side slope (Z = 1 m). The discharge through of open channel is (2 m³/sec). Find the critical depth.
The critical slope is the slope that will maintain a uniform and critical flow in a canal with constant discharge. When the discharge of the canal is 11 cms, width of 6 m, side slope, z = 2 and n = 0.025, the critical slope is
The Aqueduct canal has side slopes at 45° to the horizontal base of the channel and conveys water at a depth of 1.5m. a. Calculate the width of the base.b. Calculate the gradient of the channel bed to discharge 2.54m3/s with a mean velocity of flow of 1.56m/s. Take Chezy C = 66.