jWater flows through a vertical contraction (venturi) section. Piezometers are attached to the upstream pipe and minimum area section as shown. The velocity in the pipe is V= 24 m/s. The difference in elevation between the two water levels in the piezometers is d = 33 cm. What is the velocity (m/s) at the %3D minimum area? Vz 24 m/S d= 33 cm

jWater flows through a vertical contraction (venturi) section. Piezometers are attached to the upstream pipe and minimum area section as shown. The velocity in the pipe is V= 24 m/s. The difference in elevation between the two water levels in the piezometers is d = 33 cm. What is the velocity (m/s) at the %3D minimum area? Vz 24 m/S d= 33 cm

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The pipe diameter is 800mm. The ultrasonic measurements recorded are: Pipe centerline velocity = 4.9 m/s %3D Velocity at radius 100mm = 4.4 m/s %3D Solve for the Friction factor f using turbulent flow profile.
PROBLEM 2 The pressures at polnts 1 and 2 of the water plpe shown are 300 kPa and 100 kPa, respectively. If the velocity at section 1 is 20 m/s and water flows steadily, determine (a) flow rate (m/s) and the (b) diameter (cm) of the plpe at section 2. 50 m d, =0.1 m Elevation View
-№ L2 Ly Fig. P. 3.5.19 sakeses
1. A pipe has a slope of 1 in 100 and its length is 300 meters. Its diameter is 0.6 meter at the lower end while 1.2 meters at the higher end. The rate of flow through pipe is 5400 liters/min. Find the pressure at the lower end if the pressure at higher end is 68.07 kPa. Neglect losses.
What is the minimum pressure difference between A and B which would allow an upward flow through this pipe if L = 1.2 m and 0 = 30°? Round the answer to the nearest multiple of 5 Pa. B (4)
The observed pressure drop for 40 °F water flowing at 16 ft/min in a 4.5-in-diameter pipe is 9.68 x 10 psi/ft. Determine the relative roughness (e/D)of the pipe. (e/D) =
PROBLEM 4 A pipe has a total length of 9800 ft with diameter of 30 in., and its thickness is 5/8 in. Assume that Ep = 30 x 10° psi, and Es = 300,000 psi. If the initial velocity for steady flow is 8 ft/s and a valve near the end of the pipe is partially closed so as to reduce the flow to half of the initial velocity in 3 seconds, (a) What is the wave celerity (ft/s), and (b) find the maximum pressure rise (psi) from the water hammer.
- once answered correctly will UPVOTE!!
The surface of an open channel lined with brass has a bed slope of 1:1000 and a Manning's coefficient of 0.011. Water is transported at a rate of 10 m/s in uniform flow. Determine the best hydraulic section for the following geometric shapes. (b) (i) A semicircular open channel. (ii) A parabolie open channel.
A concrete pipe 750 mm in diameter is laid to a gradient of 1 in 200.The estimated value of Manning’s ?is 0.012m−1/3s.Calculate the discharge when:(a)the pipe is full;(b)the depth is 90% of maximum.Explain why the answer in (b) exceeds th
k=10^-3 ft/min Find: a) Seepage beneath the dam (ft/min) b) Pressure head at points A and B b) Pore water pressure at points C through K (in psf) f 570 ft. EL. 780 f (coeff. of friction) 0.35 50 ft. 280 ft Yconc 150 er 180 ft. 7 EL. 600 380 ft 170 ft. EFGHL K. 170 ft. silty SAND .Y Ysat 120 pef k- 10-3 /min