Water flows in a 10-ft-wide rectangular channel with a flowrate of 200 ft3/s. Plot the specific energy diagram for this flow (using excel). Determine the two possible depths of flow when the specific energy is 6 ft. [Answer in units of ft]. I know how to solve the equation but I don't know how to plot the specific energy diagram using excel.

Q: Calculate the discharge, in ft3/s, m3/s, and liter(s)/s of the stream according to the given…

A: The objective of the question is to calculate the discharge of a stream given the cross-sectional…

Q: Two reservoirs (El 24.9m and El 101.9m) are connected by two pipelines 1-2 and 2-3 with a pump…

A: To Determine Power given by the pump, P

Q: Calculate the values of critical height and critical velocity for water flowing through a…

A: Given: Width of channel, b = 7.5 m Flow rate, Q = 22.5 m3/sec

Q: Most of you may have seen water towers in and around small towns. The function of a water tower is…

A: Here, the relation between the height of the water above the ground in the water tower is…

Q: I have gotten this far, but I am not sure how to read the graph to find effieciency. Please see…

A: Radial Flow pump is used and its efficiency is 75%Explanation:Given Discharge Q= 0.03 m3/s  convert…

Q: Determine the operating conditions (HP, Q, ep, and Pi) of a pump capable of moving water (68°F) from…

A: Given, D = 12" or 1 ft L = 8700 ft  e = 0.006 ft    NOTE : As per guidelines, only first question…

Q: If the liquid of Prob. 10.89 is a superliquid (zero head loss occurs with the flow of this liquid),…

A:

Q: flowing through a smaller pipes are 25, 15, and 12 L/min, what is the flow rate in the 1.9 cm pipe?…

A:

Q: compute the uniform rate of flow in liter per second which would fill a reservoir has a capacity of…

A: given   reservoir of capacity , V = 265 us gallon  to find uniform flow rate (Q) in lit/sec which…

Q: A pitot tube was installed in a pipe section and showed a maximum height of 100mm. What is the flow…

A:

Q: Given water flowing through a 50 ft long pipe with a 1/2 in diameter at a flow rate of 5 gal/min,…

A: Q=5 gal per min   =5×0.1336 ft3 per min     =5×0.1336×0.305360 m3 per sec     =0.316×10-3…

Q: The water system in a suburban area consists of an old 8-inch pipeline 2,500 ft. long which conveys…

A:

Q: m3 flows at a rate of 0.05 in a 20 cm diameter new cast-iron pipe. What would be the S ntage…

A:

Q: Hazen-Williams equation used to define

A: The relationship used for corelating the physical properties of pipe to flow of water is known as…

Q: DATA SHEET Pipe Section Material Pipe Pressure at Length Dia. Reynolds Roughness Flow Velocity…

A: Calculating pressure; Pressure 'P'=ρgh=32.2×62.35×1bFx3×150 ft=301166.014×1bfft2=20.9143…

Q: Calculate the discharge, in ft3/s, m3/s, and liter(s)/s of the stream according to the given…

A: Given Area 18 ft2Velocity 0.5 ft/sTo find out Discharge in ft3/s , m3/s and l/s

Q: Estimate the water demand for a city of 100,000 people. Assume the annual average consumption rate…

A: number of people=100000annual average consumption rate=647Lpcd

Q: 5. Water flows at a depth of 40 cm in a100-cm-diameter storm sewer. Calculate the flow rate and the…

A:

Q: Q) Name and discuss the importance of energy dissipation structures in the context of open channel…

A: Various types of energy Dissipators in context of open channel flow are : 1- Simple Concrete apron :…

Q: 1 An orifice meter to carry water is calibrated with air in a geometrically similar model at t the…

A: For orifice meter calibrated with airGeometrical similar modet at  1/6 th prototype scaleto find…

Q: The flow rate into a water tank is 25 m3/s. The outflow rate is 15 m3/s. The tank has a capacity of…

A: The discharge or flow rate is the volume of water flow through in particular time, formula to…

Q: Water flows in a horizontal tube with two sections, a large cross-sectional area (250 m) and a speed…

A: The area at entrance (A1) = 250 The area at exit (A2) = 100 Velocity at inlet (v1) = 2m/s Since no…

Q: An experiment to determine the discharge coefficient of the venturi meter was conducted and the…

A: A1=Inlet area =π4*0.312=0.07547m2 A2=Outlet area =π4*0.192=0.02835m2

Q: PROBLEM 5: A turbine, located at an elevation 255 m below that of the water surface at intake,…

A:

Q: The flow into a reservoir over a one hour period is shown in the following table. tt (minutes) 0…

A: The given data shows the flow into a reservoir within one hour period. The interval period is 10…

Q: e of water equal to 3.5x10" f water is applied according every 10 dave 4 12 brs ber

A: For 10 days we need 3.5×106m3sVolume=3.5×106m3s×10days×24hrsday×3600sechr=3.024×106m3

Q: Problem 1: Water at 60°C flows at a rate of 0.015 m³/s from the reservoir through the pipe system…

A: To Determine 1. If flow is laminar or turbulent inside the pipe 2. The energy loss, b, due to…

Q: The figure below represents the flow measured in a single day in River City. 2,500 2,000 1,500 1,000…

A: (1) Consider the graph,

Q: Calculate the head loss of a pipeline with a discharge of 2100 m3/hr flowing through a pipe 450mm in…

A:

Q: If X liters per second of water flows through the system shown below, calculate the total headloss…

A:

Q: 5. A smooth plastic 10-m long garden hose with an inside diameter of 20 mm is used to drain a wading…

A:

Q: A chemical plant in Bulacan has a 131m pipeline network with a 141mm diameter and an average flow…

A: Data is as given

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.