Water flows from tank A whose level is at elevation 84.0' to tank B whose level is kept at elevation 60.0'. The tanks are connected by 100 ft of 12′′ pipe (f = 0.020) followed by 100 ft of 6′′ pipe (f = 0.015). There are two 90° bends in each pipe

Q: 40m 120 1.2L/ Water ervoirs A and B are connected to each other through a 40-m-long, 2-cm swing…

A:

Q: - 520ft D = 20 in L=20,000 ft B VB PB 400 ft A 20-inch diameter pipe carries 4 ft³/s of water from…

A: The discharge through the pipe, Q = 4 ft3/secThe diameter of each pipe, d = 20 inchesThe length of…

Q: Water is pumped at the rate of 2 cfs from a reservoir 20 ft above a pump to a free discharge 90 ft…

A: Q = 2 cfsKb = 1.2 Kentry = 0.5 D = 6 in or 0.5 ft L = 1500 ft L34 = 1400 ft

Q: Problem 3 A 5-m long and 2-m wide gate contains water with a depth of 4 m as shown and is supported…

A:

Q: 6 m/s ter flows through the e at A at 6 m/s. termine the pressure A and the velocity of 3 m water as…

A:

Q: 11. A tank 3.66m has its ends vertical, top and bottom horizontal, 1.82m high. The top and the…

A: Given: Required to find:  the time necessary to lower the water surface to 1.22m

Q: Water flows with a flow rate of 0.6 cumecs through an inclined pipe PQ of length 10 m length having…

A: flow rate = 0.6 cumecs length of pipe line = 10 mPressure at Q = 30 kN/m2To Find :The pressure at…

Q: Water is discharged through the drain pipe at B from the large basin at 0.03 m^3 /s. If the diameter…

A: Given : Discharge through the drain = 0.003 m3/s Diameter of drainpipe = 60 mm To Find : Determine…

Q: reynolds number b.) total head lossv(m) c.) gage pressure at 1

A: Gauge pressure: - It is defined as the extra pressure to a system with respect to local atmospheric…

Q: P. 7.48 - A water discharge of 8 m³/s is to flow through this horizontal pipe, which is 1 m in…

A: The given data is: Q=8 m2/s d=1 m hf=7v2/2g

Q: Water flows from lank A whose level is at elevation 84.0' to tank B whose level is kept at elevation…

A: given data:  elevation of tank A = 84 ft  elevation of tank B = 60 ft  length and diameter of pipe A…

Q: For downward real flow in offset water pipe shown, find: The required pressure at D 1. 2. Determine…

A: Given, PA = 50 kPa L = 8 m  D = 20 mm or 0.02 m  Q = 0.2 L/s or 0.0002 m3/s

Q: The chute has a cross-sectional area of 0.03 m² at A and B. If the flow is 0.4 m³/s at B and the…

A:

Q: (0= 25°, D1 = 20 cm, D2=1.5 cm, P1=125 kPa, and Q1=5 m³/hr) Water flows through this horizontal pipe…

A: Answer  Let us first draw the free body diagram showing directions all the force Total Force…

Q: ... T A 30° 2.5m Water hinge L = 2m In the figure shown, a quarter circle gate AOB is hinged at…

A: Water pressure resulting from a liquid flowing on submerged surfaces is what causes hydrostatic…

Q: Using a standard pipe with a diameter of 0.1016 m and a length of 152.4 m, water at 16 ° C is…

A: Given data  Head loss Friction factor Diameter  Length  Temperature  Two 90° elbow 1 Closing slide

Q: The T-junction has discharges Q1=0.3 m3/s, Q2=Q3=0.15 m3/s, and has diameter D1=0.45 m, D2=0.3 m,…

A: Angle of bend(θ) = 90°  for pipe 2 and 3Pressure at section 1(p1) = 500 KN/m2

Q: The large tanks A and B are connected by a variable section pipe. The water level in tank A is 2m,…

A:

Q: BUILDING 3.6m 2F 1m 3.6m 1F ТАР Im GROUND 0.9m 3.6 m PIPELINE BASEMENT 1m

A: The given data is: Maximum flow rate at 1F (Q1F) = 2.5 L/s Inner diameter of the taps (d) = 18 mm g…

Q: Water at 25°C (p = 997.1 kg/m³ and v=0.898x10-6 m²/s) is pumped into the galvanized iron (ε = 0.15…

A: The density of the water = 997.1 kg/m3 The kinematic viscosity = 0.89810-6 m2/sThe roughness of the…

Q: Water flows through the pipe at A at 6 m/s. Determine the pressure at A and the velocity of the…

A:

Q: 2. Points A and B are 5km apart along a new 60 cm cast iron pipe carrying water. A is 9 m higher…

A:

Q: Reservoir X is located at elevation 180m. The elevation at the junction is at 120m and is 15,000…

A:

Q: An L-shape gate AOB weighing 20 kN at its center of gravity G, 0.6 m above the bottom and 0.5 m from…

A: To determine the height of water so that no reaction is developed at the stop (B).   Given, Weight…

Q: A pipe carrying sea water (SG = 1.03) reduces its diameter from 30cm at point 1 to 10cm at point 2.…

A:

Q: The hydraulic cylinder extends at 0.5 m/s and determine the angular velocity and the angular…

A: The given figure is shown below:

Q: A rectangular gate of width 5 m and depth 1.5 m is installed to control the discharge as shown in…

A: Given that :-A rectangular gate of the width 5 m and depth 1.5 m is installed to control the…

Q: Water is pumped from reservoir A through 1850 m pipeline 600 mm across a valley to a second…

A: Given, Total Pipe length (L) = 1850 m  Diameter (D) = 600 mm or 0.6 m   Friction factor (f) = 0.02

Q: Q7) Water flows from a large reservoir to a smaller one through a 5-cm diameter smooth piping system…

A: The given data is shown below: Diameter=5cmDynamic viscosity=0.001307 Pas

Q: Assuming that all pipes has a friction factor of 0.021, determine the elevation at surface of…

A:

Q: compute the force acting on the flange.

A:

Q: Two pipes A and B are connected in series diameter and length equal to 400mm 200m and 600mm,300m…

A: First, we need to convert all the given values into SI units for consistency. The diameter of the…

Q: diameter on the liquid surface. a. Compute for the value of eccentricity if the top of the gate is…

A:

Q: Problem 2 Water flows through a horizontal 45 degree bend with a 22-i pressure of 15 lb/in². Pi L- y…

A:

Q: Problem P68 (6) Let's extend the previous problem. In our lectures, all the momentum problems…

A: The problem is given in the above figure.  Data given,  Pressure at section 1 = 100 KPa = 100 kn/m2…

Q: 不 1 m 1.5 m 3 m E Air, p = 32 kPa Oil, s = 0.80 Water Glycerin, s = 1.26 LL F cg 60° D

A:

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?