A rectangular gate of width 5 m and depth 1.5 m is installed to control the discharge as shown in figure below. The end 'B' is hinged. Determine the force normal to the gate applied at 'A' to open it. C Gate 3.0 m B 45° 1.5 m Hinge Gate: 5.0 m width 1.5 m depth

Q: Problem 1 The gate shown is rectangular and has dimensions height h = 6 m by width b = 4 m. The…

A: Below is the clarified and detailed explanation for above tricky question.....if you are ok with my…

Q: Water is pumped at the rate of 2 cfs from a reservoir 20 ft above a pump to a free discharge 90 ft…

A: Q = 2 cfsKb = 1.2 Kentry = 0.5 D = 6 in or 0.5 ft L = 1500 ft L34 = 1400 ft

Q: 4. A vertical semi-circular gate with a diameter of 6 m is vertically submerged in water with its…

A:

Q: (0= 25°, D1 = 20 cm, D2=1.5 cm, P1=125 kPa, and Q1=5 m³/hr) Water flows through this horizontal pipe…

A: Answer  Let us first draw the free body diagram showing directions all the force Total Force…

Q: Q5:A rectangular gate is fitted at the base of a reservoir wall with a pivot in the arrangement…

A: Height of water level, h = 2.779 mSize of gate = 1.2m x 0.9m

Q: The light right-angle boom which supports the 290-kg cylinder is supported by three çables and a…

A:

Q: 3. For the gate shown, α = 45°, y₁ = 1 m, and y₂ = 4 m. Will the gate fall or stay in position under…

A: Given :

Q: Q.4.A..A (3m) high, (5m) wide rectangular gate is hinged at the top edge at (A), and is restrained…

A:

Q: A thin 5-ft-wide, right-angle gate with negligible mass is free to pivot about a frictionless hinge…

A: Width=5ft Diameter of drain pipe=2ft L=2ft To find minimum water depth(h)

Q: AB, a rectangular (0.6 mx0.9 m) sluice gate, blocks a liquid with a gravity of 0.79. The weight of…

A: The figure is given:

Q: 4. A long, continuous steel gate, BC, restrains fresh water as shown and is supported by hinges at…

A: Given : Determine the reaction component for a typical hinge at A and at B ?

Q: 1. A tank is filled to a depth of 5 feet of water and is 8 wide by 10 feet long. Determine the…

A: Note- For question no 2, kindly repost this question by mentioning which question you want to be…

Q: 4. The'rectangular gate AB is 3.05 m x 1.22 m in dimension and its pin connected at the point B. If…

A: FBD of the given problem:

Q: For the quarter circle gate BC with a hinge at C, the force P = . . kN to hold the gate stationary…

A:

Q: Problem 2 Water flows through a horizontal 45 degree bend with a 22-i pressure of 15 lb/in². Pi L- y…

A:

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.