Q.4.A..A (3m) high, (5m) wide rectangular gate is hinged at the top edge at (A), and is restrained by a fixed ridge at (B). Determine the hydrostatic force exerted on the gate by the (5m) high water and the location of the pressure center. B. Give the differences between the fluid average velocity of the laminar flow and the turbulent flow.

Q: Water is pumped at the rate of 2 cfs from a reservoir 20 ft above a pump to a free discharge 90 ft…

A: Q = 2 cfsKb = 1.2 Kentry = 0.5 D = 6 in or 0.5 ft L = 1500 ft L34 = 1400 ft

Q: 2. Water flow from A to E through the pipe shown. It is known that the flow in pipe 4 is 450 L/s,…

A: Solution:Given:The flow in pipe 4 is Q4=450L/sThe pressure head or head loss at pipe 1 is hf1=62mThe…

Q: a rectangular gate of width "a", length "b" and inclined at an angle "A", with water on one side is…

A: a) location of centre of gate from water surface along plane of gate  from water surface =xy'+b2…

Q: *6-4. Water flows with a velocity of 6 m/s through the pipe at A. If the pressure at A is 65 kPa,…

A:

Q: Water flows steadily down the inclined pipe as indicated in Fig. Determine the following: (a) The…

A:

Q: A square gate shown is 6-ft on all sides is hinged at the top of the gate, and is restraine by the…

A: INTRODUCTION: This is a hydrostatic force acting on a inclined plate type question. we have to know…

Q: Water at 25°C (p = 997.1 kg/m³ and v=0.898x10-6 m²/s) is pumped into the galvanized iron (ε = 0.15…

A: The density of the water = 997.1 kg/m3 The kinematic viscosity = 0.89810-6 m2/sThe roughness of the…

Q: Consider a 12-inch diameter steel pipe (ks = E = 1.5 x 10* ft) which has water flowing under…

A: NOTE : Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: A homogeneous rectangular gate AB 7.9 ft wide and 10 ft long. Friction in the hinge is negligible.…

A: Find force acted on surface AB