Water droplets are to be separated from air in a simple separation drum. The flow-rate of the air is 1000 m3 h -1 at STP and it contains 75 kg of water. The drum will operate at 1.1 bara of pressure and 20°C. Size a suitable liquid-vapour separator -i.e. specify the length (L) and diameter (D).

Q: Problem # 3: Friction losses and volumetric discharge through a water piping system The cold-water…

A:

Q: 1.A liquid refrigerant (sg = 1.080) is flowing at a weight flow rate of 23.0 N/h. Required…

A: As per our guidelines we are supposed to solve only one question if multiple questions are asked .…

Q: Q/ Air is to be bubbled through the solution in the reactor CSTR, in order to strip out of the…

A:

Q: Equipment: STATIC VELOCITY TOTAL Pat Image 1. The tabletop air nozzle was used to measure the flow…

A: Given,ρair=1.2kg/m3ρwater=1000kg/m3We know that,P=ρgh and…

Q: 9. The diameter at section (1) is 0.3m. The diameter at section (2) is 0.15m. What is the flow rate…

A: Givend1=0.3md2=0.15ms.g=0.85h=12.7 cm Hg

Q: 3. Air at 28 °C flow over a wet-bulb thermometer. If the thermometer reads 20 °C what is the…

A: Given: Dry bulb temperature : 28 C Wet bulb temperature : 20 C hfg @ 20 C = 2454.1 kJ/kg To find:…

Q: 35. Water enters a heated tube of 2 mm diameter at 30C and leaves the tube at 60 C. Find the water…

A: Given Data The diamter of tube is:D=2 mm=0.002m The reynolds number is:Re=1000 The inlet…

Q: -1. A large tank contains air, gasoline (pc= 680 kg/m³), light on p 800 kg/m³) and water. The…

A: Given:Density of the gasoline, ρG=680 kg/m3Density of light oil, ρo=800 kg/m3Pressure p of the air,…

Q: Question 11: A non-flat plate is placed inside a wind tunnel where the air velocity in the test…

A:

Q: 5.(a) What is compressed air and what is the normal pressure for using it in pneumatic system? (b)…

A: Answer (a) Compressed air: It is an air that is compressed by the compressor more then the…

Q: The volumetric flowrate of CCl4 (? = 0.659 g/cm3) in a pipe is 5.39 L/s. Find:a.the mass flow rate…

A:

Q: 4. A special oil is to be used in an absorption tower. The preliminary design of the unit requires…

A: A schematic diagram of the given case is Given data, Datum height at section 1, Z1 = 10 ft Length…

Q: A wind turbine has the following data: Downstream wind velocity = 9 m/s Upstream wind velocity =18…

A:

Q: running and delivering air at 12

A: Given: t=12 minPmax=180 PsiPmin=155 PsiQr=25 scfmQc=0

Q: A pipe, inside diameter 1.27 cm, water flows through the pipe at a rate of 0.5 liters per second at…

A:

Q: 10.6 As shown, air (20°C) is flowing from a large tank, through a horizontal pipe, and then…

A: given data:- air at 20°C length = 50 m velocity = 10 m/s friction factor = 0.015. find the pressure…

Q: (1) Complete the following sentences; 1. Sound insulator usually covers ---------- surface of the…

A: 1.sound insulator usually covers............surface of the wall. Answer :- Dry wall  The best…

Q: A-Given that the volumetric flow rate for a fluid within a circular cross-section tube can be…

A: Given:The volumetric flow rate for a fluid, Q=πr4∆P8μLLength of the tube, L=1 mTube diameter, d=23…

Q: A Process fluid is pumped from the bottom of one distillation column to another, using a centrifugal…

A:

Q: In compressible fluids, which is not assumed to simplify calculation  a. Steady flow b.…

A: Compressible fluids are the ones which can be compressed whose volume decreases and density…

Q: Pure milk at 293 K has a density of 1030 kg / m3 and a viscosity of 2.12 cp flowing at a rate of…

A: Write the given data with suitable variables: ρ=1030 kg/m3μ=2.12 cp=2.12×10-3 Pa-s10-3 Ps-s1…

Q: Pure milk at 293 K has a density of 1030 kg / m3 and a viscosity of 2.12 cp flowing at a rate of…

A:

Q: Wall Shear Stress and Pressure: The average blood velocity through an internal carotid artery with a…

A: Given data: D=5 mm u=15 cm/s μ=3.5 cp

Q: Consider the residential heating, ventilation, and air conditioning (HVAC) system at right. A blower…

A: Given:To find:

Q: 2. Calculate the nozzle flow exit velocity for a rocket motor operating at 68 atmospheres chamber…

A: Given: Po = 68 atm Pe = 1 atm To = 1600 K

Q: Identify examples of steady flow with accelerated fluid particle. Multiple Choice Fluid Flow in a…

A: The term "steady flow" refers to a type of flow in which the parameters of fluid flow do not vary…

Q: Question 1: B The diagram shows water leaving a tank through an inverted V-tube. (All answers to be…

A:

Q: A large commercial air-conditioning unit processess 5 kg/s of atmospheric air. The air enters at a…

A: GIVEN:m'=5kg/sP2=100kPaDBT2=20'CWBT2=10'CFrom psychometric chart,from THERMODYNAMICS DATABOOK, BY…

Q: 12. A mixture of oil and gas flows through a horizontal pipe with an inside diameter of 150 mm. The…

A: We have mixture of oil and gas.Let assume that we have gas in x fraction of area.then (1-x) fraction…

Q: FLUID MECH Support your answer with the appropriate solution and diagram. 4. The water level in a…

A:

Q: A "spa tub" is to be designed to replace bath tubs in reno- vations. There are to be 6 outlet…

A: Flow area of the pump is A1=π4D12 The flow rate for the suction is Q=A1v1=π4D12v1⋯⋯⋯(1) Discharge…

Q: How long (in minutes) can a 75.0 US gallon receiver supply 8.5 SCFM of compressed air if the…

A:

Q: Air at a temperature of 25° C and standard atmospheric pressure of 101.3 kPa flows through the…

A: K=1.4To find:The mass flow rate in the pipe

Q: Show and expalin all steps in solution.Iso-butane at initial temperature of 10C is flowing with the…

A:

Q: Describe the factors influencing the flow rate and pressure in pressurized flow systems, such as…

A: The relationship between flow rate and pressure is strong in pressurized flow systems, such as pipes…

Q: An engine cooling system consists of the following components and associated losses; Engine Block…

A: Answer: The total head loss associated with piping system is 27.79 m. Hence, the correct answer is…

Q: You are designing a vacuum system with a desired equilibrium pressure of 10-7 torr. The…

A: Write the pressure of the system.   P=10-7 torr   Write the pumping speed of the system.   v=400 L/s…

Q: pure water at 20 c is flowing down an inclined wetted - wall ( making an angle of 60 with horizontal…

A: Given:Pure water at 20οC has following properties:Dynamic…

Q: Production tubing diameter has no effect on the inflow performance of a reservoir. Select one: True…

A: