A pipe, inside diameter 1.27 cm, water flows through the pipe at a rate of 0.5 liters per second at 20 C. a. What is the velocity of the water (average) in the pipe? b. What is the Reynolds number value? c. Is the flow laminar or turbulent?

The measured flow rate of water through a 20 mm diameter pipe is 75 L/min. What is the Reynolds (Re) number?

Water is flowing at a velocity of 1 m/s in a pipe 0.4 m in diameter. In the pipe is an orifice with a hole diameter of 0.2 m. What is the measured pressure drop across the orifice?A. 1.76 psiB. 2.21 psiC. 2.83 psiD. 3.76 psi

nd the diameter of the pipe in mm. The discharge of the pipe is  20 lit/sec with the velocity of water 4.75 m/s The diameter of the pipe in mm

fluid mechanics

Please answer it fast, Include the diagram to show the points where the Bernoulli equations were applied.

Medium oil with kinematic viscosity 6.10 × 10^-6 m^2/s, flows through a strsight pipe at a rate of 6.0 liters/s. For laminar flow comditions, what is the least diameter of the pipe. A. 64cm B. 62cm C. 60cm D. 66cm

What is the volumetric flow rate of oil in a 12m diameter pipe?  The velocity of the oilis 5m/s.

C2. A conical tube is fixed vertically with its smaller end upwards and it forms a part of the pipeline. The velocity at the smaller end is 4.9 m/s and at the larger end is 2.5 m/s. The length of the conical tube is 1.3 m and the flow rate of the water is 127 liters/s. The pressure at the smaller end is equivalent to a head of 10.1 m of water. Considering the following two cases: (1) Neglecting friction, (without head loss) determine (i) the diameter at the smaller end in meter, (ii) the diameter at the larger end in meter, and (ii) the pressure at the larger end of the tube in m of water. (2) If a head loss (with head loss)in the tube,h = 0.0153(V1-V2)2, where V1 is the velocity at the smaller end and V2 is the velocity at the larger end, determine (iv) the head loss in m of water and (v) the pressure at the larger end of the tube in m of water. 6) the diameter at the smaller end in meter (ii) the diameter at the larger end in meter (iii) the pressure head at the larger end of the…

Industrial pipes Do the guides allow movement of a pipe only in two directions (in a plane)?