Warner is employed as a network engineer and part of his job requires him to measure the RSSI (received signal strength indicator) on the receiver's end. Warner is required to measure the RSSI and fill out a form indicating whether the signal is acceptable or not. During one such visit, the client's device's RSSI level reads -80 dBM. Analyze what Warner should report in such a scenario.       Mark the rating as excellent   Mark the rating as good   Mark the rating as acceptable   Mark the rating as not good

Q: With the ________ mode if there is an error in a block of the transmitted ciphertext only the…

A: Cipher Text: In cryptography, ciphertext is the data that has been encrypted using a cipher. Ciphers…

Q: Select the best answer: For SMB relay to work, what must SMB signing be set to on the target system?…

A: The objective of the question is to identify the correct setting for SMB (Server Message Block)…

Q: Use the Cyclic Redundancy Check (CRC) on the following input.  Divisor = 1101, Data to send =…

A: I will provide the calculation through my hand written notes :-

Q: when diagnosing intermittent faults, why is it important to know the condition to run a DTC and what…

A: Introduction it's crucial to understand the precise circumstances in which an intermittent fault…

Q: What three fields guarantee successful data transmission and data integrity within the TCP header?…

A: TCP stands for Transmission control protocol, it is reliable and connection oriented transport layer…

Q: A small research  company is working  to develop a new method of mass storage to replace current…

A: Data Sharing outside the company:  Employees sharing sensitive data wither publicly or with third…

Q: Match error detection and correction to the best corresponding terms Helps to increase net…

A: Error detection and correction are fundamental techniques employed in the field of data…

Q: Please let us know if you believe each of the following assertions to be accurate or false, and…

A: Alternating-bit protocol and Selective repeat (SR) protocol are two protocols commonly used for…

Q: Consider a message 11100011 and a divisor 110011, then use mod 2 binary division method to…

A: Cyclic redundancy check:- CRC is an error detection algorithm which appends the remainder in the…

Q: An IP fragment with 100 bytes of data (not including IP header) is received with the following…

A: - We need to choose the original data length here.

Q: Given a effective delay of 20ms when network usage is 38%, what is the effective delay when network…

A: The answer is in step 2:

Transmission Delay

Data is an essential part of network communication. To effectively transmit data through all kinds of networks, it must be streamlined into smaller data packets. Instead of sending a whole file to the other side, these variably-sized packets are sent across the network path to reduce transmission latency. Once they reach their destination, these packets are reconstructed into a complete file. This process is called packet-switching.

Coding Theory

Code is an alternative representation of some information—like a word, image, sound, and so on—that follows a set of rules. While  coding theory may refer to the practice of studying such codes and their applications, in recent years, the term pertains to error-correcting codes.