vertical 150 mm pipe leaves a water tank of surface elevation 24. Between the tank and elevation 12, on the line, 2.4 m of head are lost when 56 Fs flow through the line. If an open piezometer tube is attached to the pipe at elevation 12, what will be the elevation of the water surface in this tub

vertical 150 mm pipe leaves a water tank of surface elevation 24. Between the tank and elevation 12, on the line, 2.4 m of head are lost when 56 Fs flow through the line. If an open piezometer tube is attached to the pipe at elevation 12, what will be the elevation of the water surface in this tub

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Flow Measurement Question 6 For a pitot tube, the stagnation pressure head is 6.8 m, the static…

A: Given- Stagnation pressure head hstag=6.8 m, Static pressure head hstatic=5 m, Cv=0.9, g=10 m/s2,…

Q: Piezometric tubes are tapped into a pipe section as shown in the figure below. The liquid is…

Q: Determine the elevation difference, Ah, between the water levels in the two open tanks shown in the…

A: The answer is found to be Difference in level of two tank = 7.6 cm For explanation please refer the…

Q: A very large and open reservoir feeds into a horizontally laid pipe which discharges into the…

Q: A 12 inch diameter well was installed in an unconfined aquifer consisting of a 60 foot thick layer…

Q: Question 2 Refer to Figure 2 below. If the water surface elevation in reservoir B is 110 m, what…

Q: 1) Find the rate of seepage beneath the dam in m/day/m 2) If a standpipe piezometer is installed at…

A: Nf = Number of flow channels= 5 Nd = Number of potential drops= 16 K = hydraulic conductivity =…

Q: In a reservoir system with a very large accumulation volume for the ideal fluid (water), a) Since…

A: Solution: “Since you have posted a question with multiple sub-parts, we will solve first three…

Q: Calculate the value of pressure ∆p onside the rain water droplet , if we know the radius R=0.2mm and…

A: GIVEN- r=0.2mm δ=0.074N/m=7.4×10-5N/mm2∆P=?

Q: A vertical 150-mm-diameter pipe leaves a water tank that has a surface elevation of 12m. Between the…

A: Velocity of flow at 0 elevation=Q/A Area=A=πd24 d=150/1000=0.15 m A=3.14×0.152/4=0.0177 m2…

Q: A circular column is subjected to an un-factored load of 1600 kN. The effective length of the column…

Q: A confined aquifer of 15 m constant thickness is sandwiched between two aquicludes as shown in the…

Q: soil sample 15 cm in diameter is placed In a tube 2 m long. A constant supply of water is allowed to…

Q: Pressure in a pipe carrying oil (Specific Gravity 0.92) is 20 kN/m². A piezometer is connected to…

A: Given data : Pressure (P)=20 KN/m2Specific gravity (S.G)=0.92Density of water (ρWater)=1000 kg/m3

Q: 5. In a deep saline water aquifer, there is a zone of fresh water of 100 ft depth. A well is drilled…

A: Given data Depth of saline water = 100 ft Depth of well = 80 ft Discharge from well = 0.5 cfs…

Q: Qhaving the flow net shown for H= 7 m, compute: a. the seepage quantity under the dam b. the…

Q: The sludge hopper of a sedimentation tank is approximated as a truncated square prism provided with…

A: Solution: Orfice daimeter=100 mm=0.1 mCd=0.62 As per Diagram

Q: During a test in a laboratory, the water which passed through a vertical venture-meter flows over a…

A: Right angle V-notch :Angle of notch (θ) = 90°Head in Notch (H) = 18 cm = 0.18 mCD (Notch) =…

Q: A 0.5 m diameter well fully penetrates an unconfined aquifer whose bottom is 150 m below the…

Q: (viscosity: v = 1 × 10-6 m² /s, SG = 0.9) flows from the upper voir at a rate of 0.028 m³/s in the…

Q: A tube well is constructed in a confined aquifer. The discharge of the tube well is 10 L/s, where…

A: Required :- Diameter of the well, dw

Q: A 2 ft diameter well penetrates vertically through a confined aquifer 50 ft thick. When the well is…

A: The flow of fluid includes movement of an unbalanced fluid. As long as unequalled forces are in…

Q: SG = 0.90 Determine the elevation difference, between the water levels in the two open tanks shown…

Q: 3. An unconfined aquifer has a hydraulic conductivity of 25 mm/sec. There are two observation wells…

Q: Please answer with complete solution and Fbd. A field sample of an unconfined aquifer is packed in a…

A: Given data, Length L = 60 cm Diameter d = 8 cm = 0.08 m Head difference dh = -18.5 cm Time period…

Q: Assume a chemical solvent, which is denser than water is spilled into the reservoir. How many days…

A: Given:- The thickness of the silty sand stratum = 3.2 m The hydraulic conductivity of the stratum =…

Q: A pump well is dug through a confined aquifer having a thickness of 32 meters. The piezometric…

A: Given data- Confined aquifer- Thickness of aquifer (D) = 32m Depth/Height of aquifer (H) = 18 m…

Q: Q-26: A 0.5 m diameter well fully penetrates an unconfined aquifer whose bottom is 150 m below the…

Q: A 300 mm diameter test well penetrates 24 m. below the static water table. After 24 hours of pumping…

Q: Fig. shows an aquifer inclined at 10° to the horizontal. The difference of water levels in two…

A: We knowQ=kiAi=hydraulic gradient=h2-h1LsLs=60cos10=60.92mArea=W×Depth=1×2.951=2.951m2so,

Q: A 300-mm diameter static test well penetrates 27 is pumped at liters per second for 24 hrs. The…

Q: Which of the following describes the water divide in an unconfined aquifer with recharge? Select the…

A: this question asking about statement that describe about water divide in an unconfined aquifer with…

Q: Which of the following is true about the Water-Table well in the unconfined aquifer? Mark all that…

A: Given that:

Q: A town is planning to develop a new water supply from an aquifer. Two observation wells installed…

A: Calculation of total ground water discharge/ volumetric flow rate:

Q: Water at 300C flow in a Venturi meter with the velocity 3 m/s. The tube diameter at station 1 is D1…

A: velocity at station 1V1=3 m/stube diameter of station 2D2=30 cmpressure at station 1P1=30 Kpa…

Q: A single ideal pumping well, with radius of 1.0 ft and flow rate of 155 gpm, exists in an ideal…

A: Given:- Confined aquifer The radius of pump rw= 1 ft Flow rate q= 155 gpm Thickness D= 82 ft Sw= 42…

Q: A syphon of diameter 200 mm connects two reservoirs having a difference in elevation of 15 m. The…

A: Given- Diameter of syphon d=200 mm, Difference of elevation of two reservoirs=15 m, Total length of…

Q: A Venturi meter with a throat of 15 cm is used to measure the flow rate of water along a horizontal…

A: Step 1

Question

A vertical 150 mm pipe leaves a water tank of surface elevation 24. Between the tank and
elevation 12, on the line, 2.4 m of head are lost when 56 Fs flow through the line. If an open
piezometer tube is attached to the pipe at elevation 12, what will be the elevation of the water
surface in this tube?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Introduction

VIEW

Step 2: To find the elevation of water level

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

CALCULATION USING DARCY'S LAW An aquifer system is formed by two horizontal layers. Two piezometers were installed for monitoring, the distance between them is 885m. The upper layer (A) has a thickness of 39m and K = 1.3 x 10-5 m/s and the lower layer (B) has a thickness of 25m and K = 2.7 x 10-6 m/s. THE hydraulic load in the PZA is 60m and in the PZB it is 40m. Calculate the flow and the transmissivity of each layer.
Example 3 q=3m³/s/m { calculate the following parameters for the bed level raise. = 2m y₁ = Y₂ = ? AZ = 0.2m a) determine the specific energy at section 2 (E₂) b) determine the downstream depth, (Y₂) e) interpret the results in £₁ = E₂ + 4E c) determine the absolute change in the water surface level (d) determine the downstream. Frade number (Fr₂) the context of E-y (Ay) ут= Угт ду curve.
Calculate the equivalent hydraulic conductivity for the following soil sample: 1.5 ft Water O: K-2x10* ft/sec O: K=3x10* ft/sec O: K-4x10 ft/sec : K-5x10 ft/sec Water (2) 4 layers@ 0.5 ft thick each 10 ft O 0.00035 ft/sec O 0.00031 ft/sec O 0.00003
If the pore velocity in the intermediate zone is 0,5 m/day and the water content is 0.18. the tensiometer experiment used two points under surface with level difference of 1m. Hydraulic conductivity is 0.02 m/day. The difference in suction head between the two points is equal to
Q1) The reservoir has the following data: Evaporation by mass transfer = 4.5 mm/day Emitted solar radiation 7.25 MJ/m2.day Shortwave radiation reflection from water body 5.2 MJ/m2.day - Albedo = 0.723 Longwave radiation backed to the atmosphere 1.65 MJ/m2.day Air temperature 25 °C Water temperature 10 °C %3D %3D Bown's ratio = 0.7 y = 0.066 kPa/°C Calculate the evaporation by using Penman's equation?
Q3. A 200 mm diameter well which fully penetrating a confined aquifer of thickness 25 m is pumped at a constant rate of 2000 m3/day. The steady state drawdown in the well is 8 m and the drawdown in a piezometer 100 m from the well is 1.4 m.(a) Ignoring well losses, calculate the transmissivity of the aquifer, the hydraulic conductivity of the aquifer material and the radius of influence of the well.(b) Repeat the calculation for an unconfined aquifer with saturated thickness 25 m
A confined aquifer of 15 m constant thickness is sandwiched between two aquicludes as shown in the figure (not drawn to scale) 55.2 m BT Peizometer P Reference Datum Aquiclude Piezometric Surface Aquiclude Peizometer Q L = 2500 m 34.1 m ונטוב SOM The heads indicated by two piezometers P and Q are 55.2 m and 34.1 m, respectively. The aquifer has a hydrau- lic conductivity of 80 m/day and its effective porosity is 0.25. If the distance between the piezometers is 2500 m, the time taken by the water to travel through the aquifer from piezometer location P to Q (in days, round off to 1 decimal place) is
A circular tube of length 500 mm and cross-sectional area 50 cm2 is placed horizontally and filled with soil A of length 200 mm and soil B of length 300 mm. The head difference between the inlet and outlet of tube is 20 cm. The coefficient of permeabilities of soil A and soil B are 2 mm/s and 2.5 mm/s respectively. The discharge taking place through the soil A is cm3/s.
A well in an unconfined aquifer is pumped at the rate of 50 L/s ( 800 gal/min.). The thickness of the aquifer is 30 m. and the elevation of the phreatic surface is 25 m. above the underlying aquiclude at an observation of well 20 m away from the well and 34.6 m above at a well 50 m. away. What is the value of K for this aquifer?
Situation 2: An open cylinder vessel 1.2 m in diameter contains water at a depth of 3.75 m. 3) If it is rotated at a speed of 85 rpm about its vertical axis, determine the least depth (m) of the vessel so that no water will be spilled out. A) 4.0 B) 4.2 C) 4.5 D) 4.7