Velocity of flow in closed conduits are inversely proportional to the pipe diameter.       Flow in open channels depend largely on slope.       Flow of water through a pipe, where the water surface

Q: In the chamber shown, section (1) has a diameter of 4.2 in., and the flow is 2.61 ft3/s. Section (2)…

A:

Q: Fluid flows into a junction at a flowrate Q, and exits via two pipes of equal diameter, as shown in…

A:

Q: A 10 cm diameter pipe is to carry water at a Reynolds number of 105. The entrance length required…

A: A pipe carrying water-Diameter of the pipe d = 10 cm=0.10 m,Reynold's number Re = 105To Find-The…

Q: At point A in a pipeline carrying water, the diameter is 1m, the pressure is 98kPa and the velocity…

A:

Q: 4) A 150mm x 50mm venturi meter set up is installed in a vertical pipeline. Determine the flow if…

A: To determine the flow-

Q: Situation 2: Give the discharge/flow rate in (m3/s) of the system with a constant velocity of 2.5…

A:

Q: 11. Estimate the type of flow in a channel having cross sectional area of 50m² and top

A: To find : Type of flow in channel.

Q: Q4. B) Plotting the Energy Gradient Line (EGL) or Total Energy Line(TEL) and Hydraulic Grade Line…

A: Given, V1 = 36 ft/s  Hm = 0.25 ft

Q: Question A horizontal pipe of non uniform cross section has water flow through it such that the…

A:

Q: A fluid of constant density flows at the rate of 15 li/sec along a pipe AB of 100-mm-diameter. This…

A:

Q: which of the following mostly depends on headloss? a. pressure head b. elevation head c. velocity…

A: Given data in question  Headloss Uniform sized pipe Compressible fluid To be discussed  Which is the…

Q: Using the loop method, determine the flow rate in each pipe in the figure. Please use the Hazen-…

A: This question related to subject fluid mechanics. In this question find out flow rate using hazen-…

Q: aState the three types of flow and explain them.

A: Answer:-  Types of fluid flow:- The classification of fluid flow according to their fluidity is…

Q: SITUATION 1: The total head lost from points A to E in the figure shown is 15m. Assume f = 0.02 for…

A:

Q: Classify the following flows Terminal flow in a very long prismatic channel Constant discharge in…

A: For analysis and prediction of fluid behaviour in various situations as well as for the design of…

Q: A circular pipe of diameter 60 cm carries a discharge of 2.5 m/s. What is the velocity of flow (m/s)…

A: given- dia of circular pipe D=60 cm=0.60 mDischarge Q=2.5 m3/s

Q: At two points '1' and '2' in a pipeline, the velocities of fluid are v and 3v respectively. Both…

A: Bernoulli's theorem : According to Bernoulli's theorem, if the fluid flows horizontally with no…

Q: ) Draw the flow pattern of laminar flow around a cylinder with turbulent flow separation.

A:

Q: The pressure in the outlet pipe from the reservoir is 61.3 kPa abs and h =15 m. Because of the…

A:

Q: 1. If liquid is flowing into an inverted cone at a constant rate, the rate at which the water level…

A:

Q: The velocity components in the x and y directions for an incompressible flow are given as u = (-5 +…

A: Given:  velocity component in x direction= u= -5+6x Velocity component in Y direction = v= -(9+6y)…

Q: 10 m +6m + 6 m Q: If the flow discharge of a trocar (trapezoid) is shown in the figure below (80…

A:

Q: For fully developed laminar pipe flow in a circular pipe, the velocity profile is given by u(r) = 2…

A: Given data Diameter=3.6cm

Q: At two points 1 and 2 in a pipeline the velocities are V and 2V, respectively. Both the points are…

A: Given- Two points 1 & 2velocities V & 2V respectively.same elevationfluid density ρIt is…

Q: 7. A stream having a discharge of 280L/sec per meter width of channel has a depth after the jump of…

A: Let V1 be the velocity of water before jump. y1 be the depth before jump. - Find Depth before jump…

Q: The water conveyed by a circular cross section pipe flows through the full section. The diameter of…

A: Reynold's Number is defined as the ratio of inertia force to viscous force.  V – Velocity of flow…

Q: 6. Determine the flow rate and the velocity in each pipe if 4 of the flow goes into pipe 2 with a…

A:

Q: Variation of water depth (y) in a gradually varied open channel flow is given by the first order…

A: →First order differential order as ;dydx=1-e-103lny250-45e-3lny       ....eqn 1→General initial…

Q: A flow occurs between an inner solid cylinder of radius 'b' and an outer pipe with a diameter 'a'

A:

Q: The top width and the depth of flow in a triangular channel were measured as 4 m and 1 m,…

A: A triangular channel- Top width=4 m, Depth of flow =1 m, Velocity at surface- V=0.7 m/s, Velocity at…

Q: 2. The diameter of a 3 meter pipe decreases from 450 mm to 150 mm. If the velocity is to decrease…

A: As per the question, it is given that the velocity should be decrease uniformly along the direction…

Q: Li Di L3 D3 L2 D2 f = 0.020 La Da Pipe Length, ft 1 980 2 490 3 250 4 980 5 1480 Diameter, in 8 8 8…

A: Head loss through pipe 1 HL1=fL1V122gD1Q=AV; V=QA=0.02×980×2π4812222×32.174×812=15.01ft Head loss…

Q: 5) A 150mm x 50mm venturi meter set up is installed in a vertical pipeline. Determine the flow if…

A:

Q: The velocity components in the x and y directions for an incompressible flow are given as u = (-5 +…

A: Please refer the attached image for complete solution. THANK YOU.

Q: What is the magnitude of the velocity where the flows are fully mixed?

A: Continuity equation: - In this equation principle of conservation of mass is applied that is AV =…

Q: P At point A in a pipeline carrying water, the diameter is 1m, the pressure 100kPa, and the V…

A:

Q: The diameters of a pipe at the sections 1 and 2 are 15 cm and 20 cm respectively. Find the discharge…

A: Given- Diameter of pipe at section 1 D1=15 cm , Diameter of pipe at section 2 D2=20 cm, Velocity of…