velocity of balls.

Q: LESSON: AUTODESK FUSION 360 Identify the feature displayed in the picture, and choose from choices…

A: Identify the feature displayed in the picture, and choose from choices below.

Q: GIVEN: ISOMETRIC PICTORIAL VIEW. SKETCH THE SIX REGULAR ORTHOGRAPHIC VIEWS. Be sure to show hidden…

A:

Q: What is the sketch of the right face

A:

Q: Please create a simple ping pong ball launcher where there is a mechanism for the trigger. And…

A: We have to given a initial launch angle and a launch initial velocity. And according to the initial…

Q: Pls use any CAD software to draw the sectional view of the solid attached in the image below.

A: FindWe need to draw the sectional view of the given object using CAD software.

Q: Piping isometric is produced:

A: This question is based on the concept of the piping isometric.

Q: In the moment calculation, why did you take away the h* from 8?

A:

Q: Draw a perspective,isometric(with 30 angle), & oblique(with 45 amgle) view of a cube.

A: Draw a perspective,isometric(with 30° angle), & oblique(with 45° angle) view of a cube.

Q: 1. Sketch the CAVALIER OBLIQUE of the given object. Use corner "A" for orientation.

A: according to the details provided in the question, we need to draw a cavalier view of the given…

Q: 2.3 Please help. Written on paper not typed on computer or keyboard please. Need help both…

A: ## Determining the Net Torque on the Wheel (Considering the Image)The image  shows a wheel with…

Q: Use the image below to do the following  i.  draw 3 positions on a piece of paper. ii.  Chose a…

A: Find three positions and corresponding distances based on the reference point.Alos find linear…

Q: What is the v-velocity at the centerline after refining the mesh

A: To explain: What is the v-velocity at the centerline after refining the mesh.

Q: Using autocad draw necessary views. Kindly all the views I'll rate your solution

A: Orthographic Projection It is a form of presenting a three-dimensional object into Two dimensional.…

Q: Match each drawing to the term that describes it. Answers are used only once. NOTE: I asked this…

A:

Q: Name the feature shown below.

A: The given figure is of

Q: Example 4 Draw sectional front view and side view of a bevel gear with 36 tocth, pitch angle 45°,…

A: Given Beval gear draw a solid work design of front and side view of gear Teeth :36 Pitch angle :45°…

Q: Write the Compatibility Equations?

A: Compatibility Equations…

Q: question from ENGINEERING DRAWING BY N.D BHATT     Write all steps of drawing following 3D model in…

A: Given: geometry as shown

Free Body Diagram

The system of forces acting on a body tends to either rotate it or make the body undergo motion. In general, when an external agent exerts a force on a body, the body undergoes translational motion and rotational motion. The body has six degrees of freedom under the influence of that force. Here, three degrees of freedom are from the translational motion while the other three are from the rotation motion. However, sometimes the bodies are not allowed to undergo any motion and are fixed, under such conditions the body is said to be constrained.