Two wooden planks, each 12 mm thick and 225 mm wide, are joined by the dry mortise joint shown. Knowing that the wood used shears off along its grain when the average shearing stress reaches 20 MPa, determine the magnitude P of that axial load which will cause the joint to fail. provide your answer in kN with precision to two decimal points. 16 mm 16 mm ـة P 25 mm 50 mm 225 mm P 50 mm 25 mm

Two wooden planks, each 12 mm thick and 225 mm wide, are joined by the dry mortise joint shown. Knowing that the wood used shears off along its grain when the average shearing stress reaches 20 MPa, determine the magnitude P of that axial load which will cause the joint to fail. provide your answer in kN with precision to two decimal points. 16 mm 16 mm ـة P 25 mm 50 mm 225 mm P 50 mm 25 mm

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

i will upvote who can answer this
SHOW COMPLETE SOLUTION AND ILLUSTRATION
Please answer quickly! Thanks
Hello, Please help in solving this question. Add Fbd if possible
Solve the problem-CIvil Thanks
SHOW COMPLETE SOLUTION
What is the nearest magnitude of strength of a 6 mm fillet weld of 100 mm length made between two flats each 10 mm thick? The allowable shear stress on the weld is 110 MPa.
Two wood boards, each 18 mm thick, are joined by the glued finger joint shown. The finger joint will fail when the average shear stress in the glue reaches 1080 kPa. Determine the shortest allowable length d of the cuts if the joint is to withstand an axial load of P = 4.2 kN. Use a = 18 mm and b = 144 mm. d Glue b P P Answer: d = i mm
The two pieces of wood, 2.94in. by 4.76 in., are glued together along the 48ᴼjoint. Determine the maximum safe axial load P (in lb) that can be applied if the shear stress in the glue is limited to 275 psi. Round off the final answer to three decimal places.
I. Problem Solving: Answer what is being required. Show you complete solution. 1. Compression test was applied to a certain type of wood. Compute the stress based on the following dimensions. The grains are parallel with the length. а. Dimension (mm) Load (N) Compressive stress (МРa) Compression Test L = 50 Parallel to the grain B = 75 130,000 W = 75 L = 50 Perpendicular to the B= 75 W = 75 35,000 Grain b. What would be the shear stress for a single shear for the same data in a.? c. What is the modulus of rupture if the width of the specimen is 50mm, depth is
1) Identify the Yield Strength of the material using a 0.2% Offset line
Please show your solution clearly thank you