Two steam turbines each of 20,000 kW capacity drive a total load of 30,000 kW. The steam rates in kilogram per hour are 1 TP₁=2000+ 10 P₁ -0.0001 P₁2 TP₂=5,000 + 7 P₂ - 0.00005 P₂2 The best division of the load will be

Two steam turbines each of 20,000 kW capacity drive a total load of 30,000 kW. The steam rates in kilogram per hour are 1 TP₁=2000+ 10 P₁ -0.0001 P₁2 TP₂=5,000 + 7 P₂ - 0.00005 P₂2 The best division of the load will be

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A 4 pole generator rotates through 120 mechanical degrees in 1.65ms. Find the frequency of the…

A: Given θ=120°(mech). The angle in electrical degrees is converted as θe=P2*θ=42*120°=240°.…

Q: Question 4 In an AC generator, the wire loops are called through magnetic and , they are connected…

A: Steam turbines, gas turbines, and combustion engines serve as the AC generator's input sources for…

Q: What is the difference between direct and alternating current? p 3:01 Why are alternating current…

Q: To change the direction of rotation of a series wound DC generator the general rule is to

A: To change the direction of rotation of a series wound DC generator Note: we always change the…

Q: A 4-pole DC generator has 1,000 turns on its rotor. It is being turned by a prime mover at 4,000 RPM…

Q: Q/ 16 pole nine slot per pole 500 rpm Turns/phase 360 Flux per pole 0.0534 web Tow slot Find :- Kd…

Q: The frequency of an ac generator is when running at 600 rpm is 50 Hz. What is the number of poles?

Q: An alternator is generating an emf per phase of EO while the rotor is rotating at a speed of 3000…

A: We know that Ephase=4.44Kpkdfrequency*flux*turn frequency=speed*no of pole /120

Q: 18. If the rms value of AC current through a 10 k2 resistor is 5 mA, the rms value of voltage drop…

A: 18) If the rms value of AC current through a 10 k ohm resistor is 5 mA, the rms value of voltage…

Q: Find the equivalent resistance seen by the generator 10v. 52 50 Ic 10V 302 42 122 Vo 59 72

A: given data:

Q: Determine the magnitudes and directions of the indicated currents in the 5 mA 7 MA 15 mA R₁ I1 12 X…

Q: QUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function…

Q: Calculate the RMS current through R2 in the diagram IR1 = 6.06mA peak, R2 = 2.7 kohms, total…

Q: SINE(0 6Vp-p 1.5K) R₁ LL 2.5 mH 100 PL On the load, find the Power (P) in Watts (W) R A 180//180 Ω…

A: Given Data: A series RL circuit with, Peak-to-peak voltage Vpp=6 V Frequency f=1.5 kHz To Find:…

Q: A tree-phase generator has a load 100 kw per phase at a power factor 80 percent,lagging what is the…

A: The active power consumed by a 3ϕ load is equal to the sum of active power consumed by each load.…

Q: In a D.C. generator if the field resistance is increased, then output voltage will decrease remains…

A: In a D.C. generator if the field resistance is increased , then output voltage will.....

Q: What component of a DC generator rectifies the internally produced alternating current into DC

A: In a DC generator, AC current is produced inside the rotor winding. The current is taken out from…

Q: An alternating current is given by I = 22sin222t. What is the time to generate 3 cycles of current?…

A: Given: An alternating current , I = 22sin222t. To calculate the time to generate 3 cycles of…

Q: If a load is leading, which statement is NOT true? a. The load is capacitive. b. It’s reactive…

A: We are given a MCQ and we need to select the correct option out of four given option.

Q: when a generator is being driven at 1200rpm, the generated emf is 230V. What is the generated emf if…

A: Given, Speed of the generator (N) = 1200rpm Generated emf (E1) = 230V Let the initial field flux be…

Q: For a ferromagnetic materials to become magnetic it's magnetic domains must be aligned

A: When ferromagnetic material is magnetized, some of the magnetic domains align parallel to one…

Q: An electric generator has 1 500 rectangular loops of dimension 0.20 m x 0.30 m. The loops are then…

A: In this question we will find maximum voltage output of given generator....

Q: Sinusoidal voltage (or emf) is generated by rotating a conductor by means of a spindle in a uniform

A: In this question we need to complete the given statement .

Q: Need asap. If the generated voltage of a separately excited generator is 100 v at 1200 rpm at what…

A: The solution can be achieved as follows.

Q: A synchronous machine is generating power of 2.6 MW, If the machine can deliver a maximum power of…

A: Given: P=2.6 MWPem=3.7 MW

Q: Find the Apparent Power (rounded to 2 significant digits) for the following circuit: VT = 120V RMS,…

A: The solution is given below

Q: An AC generator produces. cycle(s) per revolution for each pair of poles.

A: it is asked to find the cycle(s) per revolution for each pair of poles in An AC generator

Q: True or False Salient pole generators rotate faster than other generators

A: Salient pole generators rotate faster than other generators. State true or false

Q: 2. Determine the electric current that flows in the circuit as the direction of the clockwise…

Q: The hot steam from the turbine is converted in to water in

A: The hot stream from turbine is converted in to water in condenser

Q: Problems: Fl- A 500 V dc generator supplies a load 800 A at point A through 0.025 2 distributor and…

A: Let the required current be i 500-VA0.025=800+i⇒i=500-VA0.025-800

Q: Determine the magnitude of the resulting magnetic field in the stator at time wt=60, 90 and 120

Q: The voltmeters in the figure measure RMS voltages. If V1 = 13 V and V2 = 3.5V what is V3? R L VI V2

Q: Need asap. If the generated voltage of a separately excited generator is 100 v at 1200 rpm at what…

A: The answer as given below:

Q: Tor F AC voltages and current listed on ac products are generally rms values.

A: We need to about the given statement is true or false.

Q: If the resistance of the field winding of a dc generator is increased the output voltage will data…

Q: When an electric generator is in operation, it is driven or rotated by a mechanical machine that…

A: We need to tell about the system which converts the chemical energy to mechanical energy .

Q: The sinewave has a peak voltage of 7 A and a Half cycle value of 9.3333 ms. What is the period?…

A: Given: Sine wave has half cycle time period = 9.3333 ms, peak voltage = 7 V, To find: Period of the…

Q: 1. The resistor R₁ is adjusted until it absorbs the maximum average power. Calculate R₁ and the…

A: Given figure,

Q: A 107 hp, 257 V de shunt motor has the magnetization curve in the graph. The armature circuit…

A: Construction of D.C machines Magnetic frame or yoke Pole core and pole shoe Armature core…

Q: The following question 6-12 refers to the circuit shown in Figure 2. 2H ww iz 10 cos 2t V 0.25 F 6…

A: The circuit this is excited the use of alternating supply is referred to as an AC Circuit. The…

Q: The power factor of an alternator depends on

A: The solution is provided in the following section:

Concept explainers

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.

Question

Please solve Last time Rejected:
Two steam turbines each of 20,000 kW capacity drive a
total load of 30,000 kW. The steam rates in kilogram per
hour are
1
TP₁= 2000 + 10 P₁ -0.0001 P₁2
TP₂=5,000 +7 P₂ - 0.00005 P2
The best division of the load will be

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Winding and Construction of the Rotor and Stator

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In experiment 5, the terminal voltage of the generator increases with in load.
There is 50 mA of current through a coil with 250 turns. The flux is 150 µWb. What is the mmf? What is the reluctance of the circuit? A. Fm = 1.25 At - R=4.3x10-3 At/Wb B. Fm = 2.25 At - R=8.3x10-3 At/Wb C. Fm = 1.25 At - R=8.3x10-3 At/Wb D. Fm = 1.25 At - R=8.3x10-2 At/Wb
To generate electricity with 50HZ generator should run at 350 rpm ? True or flase
The shunt dc generator runs, but there is no output voltage because of Select one O a all mentioned answers are right Ob reversing in speed of rotation Oc no residual flux Od reversing in polarity PE jo 17
how would i find the power of a savonius wind turbine with each rotor blade having an area of 1.19m^2
POLE 'P'=2 Freq -F=50 Power in MW=180 Power Factor cosϕ=0.86 Moment of inertia J=18000
A 12 V generator has an internal resistance of 0.05 ohm. Two loads are connected in parallel to its terminals, one drawing a 12 A current and the other dissipating energy at the rate of 200 W. What is the terminal voltage of the generator with this load? Ans. 0.82 volts
Show solution When the speed of an alternator is changed from 3600 rpm to 1800 rpm, the generated emf per phase will become. ½ 2x 4x 1/4
One single phase energy meter operating on 230 V and 5 A for 5 hours makes 1940 revolutions. Meter constant in revolution is 400. The power factor of the load will be:
26. Determine the rms voltage across R3 in Figure 11-82. Figure 11-82 30 V (peak) R₁ 1.0 ΚΩ 16 V (peak-to-peak) RA 560 Ω R₂ 5 V (rms) R3 www
Draw the magnetization curve of the generator results of IF 1 ක. 0.02 2.07 0.12 0.17 0-36 0.55 V 109 yo bo +41 11,0 Ifv 0.06 0.09 0.15 0.21 0.32 S5
Quèstion 3 In a D.C. generator the critical resistance can be increased by increasing its field resistance increasing its speed decreasing its speed decreasing its field resistance