Two solid cylindrical rods (1) and (2) are joined together at flange B and loaded as shown. If the normal stress in each rod must be limited to 220 MPa, determine the minimum diameter d2 required for rod (2). 80 KN O 35.7 mm O 34.0 mm O 46.4 mm O 39.2 mm Ⓒ25.4 mm 140 KN 140 KN

Q: Ex : Two solid cylindrical rods AB and BC are welded together at B and loaded as shown , Knowing…

A:

Q: 2. For the bone shown to the left, assume the cross-section at C can be approximated as annular,…

A: Given:Average normal stress, σ=3.8 MPaLoad applied, P=1200 Nouter diameter, d=25 mm

Q: Two solid cylindrical rods (1) and (2) are joined together at flange B and loaded as shown. If F₁ =…

A: Given data: Load acting , F1 = 15 kips   and F2 = 34 kips Normal stress has to be limited to 17 ksi.…

Q: A rod composed of an aluminum section rigidly attached between steel and bronze section. Axial loads…

A: Given data as per the question  P=3000 lb  Area of rod =0.5 in2

Q: 2.17 In using this leg curl machine the exertion of the legs results in a torque M 120 lb-ft on the…

A:

Q: 2. Determine the maximum force P that can be exerted on each of the two pistons so that the…

A: Given: The radius of the piston is R=45 mm. The wall thickness is t=2 mm. The circumferential stress…

Q: Three forces, each of magnitude P = 3 kN, are applied to the structure shown. Determine the…

A: Solution.jpg

Q: For the clevis connection shown, the shear stress in the 5/16-in.-diameter bolt must be limited to…

A:

Q: For the stress shown below, determine the cross-sectional areas of bars BE, BF and CF so that the…

A: For the stress shown below,Determine the cross-sectional areas of bars BE, BF and CF so that the…

Q: Determine the largest weight W that can be supported by the two wires AB and AC: The working…

A:

Q: The rectangular bar is connected to the support bracket with a 17-mm diameter pin. The bar width is…

A: Diameter of the pin: 17 mmWidth of the rectangular bar: w = 85 mmThickness of the rectangular bar:…

Q: B The two rods AB and AC have diameters of 10 millimeters and 8 millimeters. Determine largest…

A:

Q: Axial loads are applied to rigid bearing plates in a system of steel bars. The cross-sectional area…

A:

Q: Rod BD is made of steel (E= 29 × 100 psi) and is used to brace the axially compressed member ABC.…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.