Two rescrvoirs are connected with a cylindrical pipe. What is the velocity at A? . What is the flow rate at A? . Suppose the depth of location A is no longer at 0.5 m, but rather its depth, y, can vary relative to the bottom of the pipe. Solve in general for Va in terms of the rescrvoir water level clevations (Z, and Za) and demonstrate mathematically that VA does not depend on y.

Two rescrvoirs are connected with a cylindrical pipe. What is the velocity at A? . What is the flow rate at A? . Suppose the depth of location A is no longer at 0.5 m, but rather its depth, y, can vary relative to the bottom of the pipe. Solve in general for Va in terms of the rescrvoir water level clevations (Z, and Za) and demonstrate mathematically that VA does not depend on y.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Q2(b) Water (density,p = 1000 kg/m^3) is flowing in a straight new cast iron pipe of 100 mm diameter and its length is 520 m. The flow velocity is 2.5 m/s. Given the friction factor is 0.0066 and the dynamic viscosity is 8.9x10^−4 Pa.s. Calculate the Reynolds number (determine the state of flow) and the friction head loss using the Darcy-Weisbach formula.
Bernoulli's theorem demonstration: 5 L of Water is flowing through a venturimeter in 6.5s. What is the pressure difference (p1- P2) (in kPa) for this flow? D=32 mm, d=23 mm, g = 9.8 m/s² and y=9.8 kN/m³
Consider the two-dimensional flow of an inviscid, incompressible fluid described by the superposition of a parallel flow of velocity V0, a source of strength q, and a sink of strength −q, separated by a distance b in the direction of the parallel flow, the source being upstream of the sink. (a) Find the resultant stream function and velocity potential. (b) Sketch the streamline pattern. (c) Find the location of the upstream stagnation point relative to the source.
8. Water is flowing in a 100 mm diameter Mild Steel (MS) pipe of length 180 m as shown in the figure. The reservoir water level remains constant. Determine the flow rate. Use the following methods: (a) Darcy Weisbach formula with loss coefficient method, (b) Darcy Weisbach formula with effective pipe length method, (c) Hazen William's formula with loss coefficient method, and (d) Hazen William's formula with effective pipe length method. (Ans.: 28.27 liter/s, 28.33 liter/s, 32.04 liter/s, 32.67 liter/s) EL85 m EL = Elevation Gaie valve Butterfly valvé opened EL50 m
A venturimeter is: efully designed pressure difference is a measure of flow volume rate in a pipe. Using Bernoulli's equation for steady, incompressible flow with no loses, show that the flow rate is related to the manometer reading 2gh(p_ - p) h by Q =- where pm is the density of the manometer fluid.
6. Freshwater and seawater flowing in parallel horizontal pipelines are connected to each other by a double U-tube manometer, as shown in figure. Determine the pressure difference Pfresh water- Psea water= ?(kPa) between the two pipelines. Take the density of seawater at that location to be P = 1035 kg/m³. (2 decimal)
2-A water well is fully penetrates a confined aquifer, as shown in the figure, the external radius of the gravel pack around the water well is 35cm. The length of well screen is 25m and the well discharge is 0.15m3/s. Assess the validity of Darcy's law for this flow. Jse p=1000 kg/m³, µ =1.14×10-3 pa.s, d=1mm)
Problem 2: Manometer and Pipe S = 0.8 300 mm dia Water flows past a manometer as shown. The manometer fluid is oil with s = 0.8. If the manometer reading Rm= h = 0.12 m, what is the water velocity at the centerline of the pipe?
1- Water flows through a horizontal pipe at a rate of 9.1 L/s. The pipe consists of two sections of diameters 10.16 cm and 5.08 cm with a smooth reducing section. The pressure difference between the two pipe sections is measured by a mercury manometer. Neglecting frictional effects, (a) determine the differential height of mercury between the two pipe sections. (b) How would the reading change if the manometer on the 2in pipe is replaced by a pitot tube? 10.16 5.08 h
Water flow passes under the sluice gate. Suppose that y₁ = 6 m and y2 = 1.9 m. (Figure 1) Figure Y₁ 4 m Y₂ 1 of 1 Part B Determine the critical depth of the flow downstream from the gate. Express your answer to three significant figures and include the appropriate units. Ye= 3.095 Submit m Previous Answers Request Answer X Incorrect; Try Again; 4 attempts remaining
Question 1: The PVC pipeline (ε = 0.0015) depicted in figure below is 150 m. Determine the diameter of the pipe that can provide a flow rate is 0.8 m³/s if the height h is 12 m. Ignore minor losses. water temperature is 4°C. U= h 497 x 10-6 (T + 42.5)1.5 2 m
At Point A, in a pipeline carrying water (y=62.4 Ib/ft^3) the diameter is 4.0 ft, the pressure is 10 psi, and the velocity 4 ft/s. At point B, 6ft higher than point A, the diameter is 2 ft and the pressure is 2psi.determine the following:(a)quantify the losses in this system and (b) is the flow going from Point A to Point B or from point B to point A. why?