Two plates are joined by four bolts of d=20-mm diameter, as shown in the figure. The shearing stress is limited to 70 MPa, tensile stress is 100 MPa and bearing stressis limited to 130 MPa. Determine the maximum load P.

Q: toonges as aasm 12 mm thick plate is conected to two 8 mm thick plates, on either side through a 16…

A:

Q: determine the tensile stress in each segment of the bar shown. Segment AB cross section 2in x 2in.…

A: Segment AB cross section 2in.×2in. Segment BC cross section with a dia. of 1.75in. Tensile load (P)…

Q: 1. Determine the nominal load P that will cause failure of the beam shown below. As part of your…

A:

Q: The rigid beam is supported by the two bars shown in a horizontal position before the load P is…

A:

Q: 1. The assembly is shown is attached to supports at A and D. Section BCD is a solid 2" diameter…

A:

Q: A simply-supported beam is subjected to a loading resulting in the bending moment diagram shown. The…

A: The maximum bending stress is given by: σc max=M×yI M = Maximum compressive bending moment y =…

Q: A bolted connection between a vertical column and a diagonal brace is shown in the figure below. The…

A: Average shear stress = VA a. Find Shear force in one bolt ; V = 13 * P2 P = 6 k So, V = 1 k b. Find…

Q: Consider the beam below. If the beam is subject to a 20kN internal shear force, determine the…

A: Given:- V= 20 KN  thickness of all pieces= 30 mm  To find:- The maximum shear stress

Q: A wooden beam is fabricated by bolting together three members. The cross-sectional dimensions are…

A: Given:  Diameter of bolt=7 mm Area of bolt A=π4×72=38.484 mm2 Spacing of bolts s=100 mm Shear force…

Q: . For the riveted connection shown in the figure using  elastic analysis a. Determine the safe value…

A: Diameter of rivet = 25 mmAllowable shear stress = 150 MPaloading = 50 KNOther Data are given in the…

Members with compression and bending

Compression members are structural elements that carry compressive axial force. They are the vertical members of a building that support beams and their design, which is governed by buckling and strength. Columns are known as struct or compression members, which are subjected to compressive forces. These members provide stiffness to the building and avoid any imperfection regarding the transfer of axial load. For instance, webs in a truss, braces in a framed structure, tiers, and so on.