Two impedances Z1 = - 2 +j 8 ohms and Z2 = 6 - j12 ohms are connected in a circuit so that they are subtractive. Find the resultant impedance. O-8- j4 ohms O 4 + j20 ohms O-8+ j20 ohms O 4- j4 ohms

Q: Find the equivalent impedance for the circuit element group below if the frequency is 600 F R2 4k L1…

A:

Q: Solve the power triangle at Z6 in the circuit diagram below.

A:

Q: By Nodal Analysis, determine the voltage V₂ of the circuit

A: The required parameter can be calculated by applying kirchhoff's current law to the nodes we will…

Q: Express R1 using Rx, Ry, and Rz when performing wye to delta conversion R3 no Rx Rz R2 R1 Ry O A.…

A: we need to express R1.

Q: Find the equivalent impedance Z in figure 1 when w=2000rad/s. Express the results in both…

A: Z = R1 + j XL1 + R2×j XC1R2 + j XC1 ----------- 1) XL1 = W×L1 -------- 2) Putting value in equation…

Q: 14) Find effective impedance? R6 L1 m. Vsupply 300 47mH 120 Vrms L2 60 Hz 0° 60mH

A: Given circuit,

Q: Find the maximum power that this circuit can deliver to a load if the load can have any complex…

A: The circuit diagram is shown below,

Q: 근6 Z.

A: Kirchhoff's current law also indicates law of conservation of charges and also be stated as at any…

Q: A load has an in its load. Determ

A: Load impedance RL=10 Ω. Supply voltage V1=15 V. In question it is given that supply voltage must not…

Q: A non-sinusoidal current source (iT=2+1.5sin1000t+ 1cos3000t-0.5sin4000t) A is applied to the…

A:

Q: R. Ro b. Toad the circuit in the a lo ad f ormed by figure, there 's seric s Ro and the in ductance…

A:

Q: Two impedances of Z1 = 100 +j50 Q and Z2 = 20 -j20 Q are connected in series what is the magnitude…

A: Given: The two impedance connected in series are Z1=100+j50 ΩZ2=20-j20 Ω

Q: Solve the power triangle at Z6 in the circuit diagram below.

A:

Q: Two impedances, Z1 = 2+j6 N and Z2 = 6-j12 N are connected in series with a 220-V 60-Hz supply. At…

A:

Q: Three impedance Z1=1-j4, z2=-6. and z3 = 4 +j3 respectively are connected in series parallel. Z1 is…

A: In this question,  We need to determine the voltage across the parallel of Z2 and Z3.  If Three…

Q: Consider the circuit below: Simplify the circuit and write the super position circuits for I1, 12,…

A: In superposition theorem, we draw multiple circuits such that in each circuit only one independent…

Q: - The Voll-age V: 100210°V is applied V= l00210v is applied across a capacilive 1oad . The Load 1-a…

A: The given data is: Voltage, V=100∠10°V,Apparent Power,S=500VA,Power Factor,pf=0.8 leading

Q: For the circuit of the following figure, if R=26 0, Zc=-J26 0, and ZL=J30 0, and if the value of the…

A: you know, S =VI* =P+jQ where S = complex power            V = Supply voltage             I = CURRENT…

Q: Find the current through the load in polar form. R1 L1 R3 C1 100 150mH 250 30uF .R 502 E1 120 V ms…

A:

Q: Z2 Z6 240 V 60Hz (N) Z4 (N) 200V 60HZ 180V 60 Hz Given : VI = 240 V 180 V 5+j62 f-60 Hz %3D 3- J62…

A:

Q: Find the equivalent impedance for the circuit element group below if the frequency is 600 Hz R2 4k…

A: In this question,  Find the equivalent impedance Z  If 2 impedance are connected in parallel, then…

Q: Here R = 5 ohm C = -j 20 ohm L = j 20 ohm So find Zequivelent if all these element are in…

A: Given circuit is parallel RLC circuit and XL and Xc are also equal means that the circuit is…

Q: Find the total impedance of the circuit below. -j5 a 52 100/0 V(A) 50 j4 2 120/13 + j15/13 ohms…

A: The solution is given below

Q: 1. Three impedances Zı = 1– j4 , Z2= 0 – j6 and Z3 = 4 + j3 ohms respectively are connected in…

A: This question belongs to circuit theory . It is based on the calculation of equivalent impedance of…

Q: Three impedance Za= (3+j4) ohms, Zc= (4-j4) ohms and Zr=0+j3 ohms are connected in parallel. Solve…

A: Here, Za= (3+j4) ohms, Zc= (4-j4) ohms and Zr=0+j3 ohms are connected in parallel

Q: Solve the power triangle at Z6 using the following network law below.

A:

Q: SOLVE ALL CURRENT USING NODAL ANALYSIS.

A: The required parameters can be calculated by applying kirchhoff's current law to the nodes.

Q: In the circuit shown below power factor is

A:

Q: i(t)=12cos(2t-30") , v,(t)=180cos(2t+10°) : element1=..... element2= ... .... a- R=11.542 , C=51.6mF…

A: Taking cosine as reference , I in phasor form is 12<-30         and           voltage Vs…

Q: Two impedances Z1 = 2 + j2 ohms and Z2 = 5cis(-45) ohms, if they wil be in parallel, what would be…

A: In this question,  We need to determine the equivalent impedance Zeq   We know if two impedance Z1…

Q: Vs= 40 V Z1 = 1 0hm Z2 = j2 Ohm Z3 = 2 Ohm Z4 = -j4 Ohm Z5 = 1 Ohm Z6 =j2 Ohm Z7 = 2 Ohm Z8 = -j4…

A:

Q: O Find V i the olait it oporadng @1Hz load 1: 1oow 0-8PF Lag Lead 2. 20w@ 0s PFLag Load 3: 21 m senc…

A:

Q: Solve the power triangle at Z6 using the following network law below.

A:

Q: Determine the current 12. 6 -j8 6-j8 100/0 2+ j14 Z, 4.47L63.43 A O 4.47426.57 A O 4.47L-26.57 A O…

A:

Z parameter

The Z-parameters that are the impedance parameters of a two-port network are defined by expressing the two-port voltages V1 and V2 in terms of two-port currents I1 and I2. The Z-parameters are calculated by open circuiting one of the two ports at a time henceforth they are called open-circuit impedance parameters.