Two blocks with masses M1 and M2 are connected by a massless string that passes over a massless pulley as shown. M1 has a mass of 2.25 kg and is on an incline of 01 = 41.5° with coefficient of kinetic friction µ = 0.205. M2 has a mass of 5.35 kg and is on an incline of 02 = 34.5° with coefficient of kinetic friction µ, = 0.105. The two-block system is in motion with the block of mass M2 sliding down the ramp. Find the magnitude a2 of the acceleration of M2 down the incline. a2 = m/s2

Two blocks with masses M1 and M2 are connected by a massless string that passes over a massless pulley as shown. M1 has a mass of 2.25 kg and is on an incline of 01 = 41.5° with coefficient of kinetic friction µ = 0.205. M2 has a mass of 5.35 kg and is on an incline of 02 = 34.5° with coefficient of kinetic friction µ, = 0.105. The two-block system is in motion with the block of mass M2 sliding down the ramp. Find the magnitude a2 of the acceleration of M2 down the incline. a2 = m/s2

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter14: Fluid Mechanics

Section: Chapter Questions

Problem 91P: (a) Calculate the retarding force due to viscosity of the air layer between a cart and a level air...

See similar textbooks

Similar questions

What is his terminal speed if he falls feet first? Use ρ = 1.2 kg/m3 for the density of air at room temp.
What is most nearly the terminal velocity of a 50mm diameter solid aluminum sphere falling in air? the sphere has a coefficient of drag of 0.5, density of aluminum is 2650 kg/m^3 , and density of air is 1.225 kg/m^3.Answer: 53 m/s
The drag force, D, on a plate moving with a velocity of (40.0 ± 0.2) km/h through air of density p = ( 1.200 ±0.010) kg/m3, with a surface area of (100.00 ± 0.5mm) x (30.00 ± 0.05cm) is given by D = Cd p AV² where Ca= 2.1 is a non-dimensional constant. What is the drag force D? 30.00 cm 100.00mm O D = 9.33 ± 0.233 N D = 8.9±0.2kg D =0.89±0.22 N D = 9.33 ± 2.33 x 101 N D = 9.3 ± 0.2 N
A cup cake liner with a mass of 0.397 g, cross section area A = 42.3 cm² and a drag coefficient of D = 0.644 is dropped from rest. Find the magnitude of its terminal velocity in m/s. Use g=9.806 m/s² and an air density of 1.20 kg/m³. Enter the number only, without the unit.
A tennis ball (typical mass 57.5 g) flying through the air may be affected by air resistance. The drag force applied to the ball can be approximated as: F drag C₁pAv² Where: Fdrag Drag force (N) Cd = Coefficient of drag, which for a tennis ball is around 0.55 p = The density of air, which at ground level at 25°C is around 1.2 A = The presented area of the tennis ball in the direction of travel, around 3500 mm² v = The velocity (by convention in the positive direction) in m/s (a) Draw a free-body diagram of the tennis ball during flight, including air resistance. Also include a separate vector showing the direction of travel (v) at an arbitrary angle (theta) from horizontal. (b) Write Newton's second law for the x and y directions, and from this state the first-order differential equations (in each coordinate) that govern the motion of the tennis ball The tennis ball is at a vertical height of 1.4 m above the ground when it is struck with a racquet. The initial velocity as it leaves the…
A skydiver will reach a terminal velocity when the air drag equals his or her weight. For a skydiver with a large body, turbulence is a factor at high speeds. The drag force then is approximately proportional to the square of the velocity. Taking the drag force to be FD =1/2 ρAv2, and setting this equal to the skydiver’s weight, find the terminal speed for a person falling “spread eagle.”
The seed pods of maple trees, also known as "helicopter seeds," spin as they fall, generating a leading edge vortex at the outer edge of each wing-like seed pod. This effect, similar to the vortices generated by hummingbird wings, can generate a sufficient lift force to keep the seed floating in air, allowing it to be dispersed by the wind. The figure below shows a pair of maple seeds L = 3.40 cm in length, with an angle of 70.0⁰ separating the seeds, as shown. If the outer edge of the seeds must rotate with a speed of 1.25 m/s for sufficient lift to be generated, what is the centripetal acceleration of the outer edge of the seeds (in m/s²) as they fall? (Enter the magnitude. Assume the seeds are symmetric about the vertical axis as they fall, as in the figure.) =
The large block shown is x = 17.0 cm wide, y = 19.0 cm long, and z = 29.00 cm high with a mass of 5.55 kg. This block is passing through air (density of air Pair = 1.43kg/m'). Calculate the terminal velocity of the block if it is traveling downward with a drag coefficient of I 0.872. See the hint panel for the drag force equation. terminal velocity: m/s
(a) A sphere made of rubber has a density of 1.18 g/cm³ and a radius of 9.00 cm. It falls through air of density 1.20 kg/m³ and has a drag coefficient of 0.500. What is its terminal speed (in m/s)? 63.8 At terminal speed, what is the acceleration? How are the weight and drag force related? How is drag related to speed, air density, and cross sectional area? Watch units when doing calculations with densities. m/s (b) From what height (in m) would the sphere have to be dropped to reach this speed if it fell without air resistance? m
Kayaking is a great example of multiple drag forces. Where a person has to deal with currents in the water and air to propel themselves forward. In this problem, the water is moving at a velocity of 1.7 m/s directly in the direction you are trying to row. When considering this water, the area in contact with the water is .05 m^2, the drag coefficient is 1.02 with normal water density. You are moving at a velocity of 3 m/s, while the air is blowing against you with a velocity of 2.7 m/s (head wind). For the air, you have an area in contact of .5 m^2, and a drag coefficient of 1.75. Normal air density is present. In order to accomplish your time goal, you need a net force propelling you downstream of 175 newtons, how much force are you applying with the paddle to achieve this goal?
Consider an object falling through air, where p, is the density of the object, pair is the density of the air, m is the mass of the object, A is the effective cross-sectional area of the object, vT is the terminal velocity of the object, and I is the drag coefficient of the object. How does the terminal velocity of the object change when these physical properties are changed? UT increases UT remains the same Ur decreases Answer Bank Po doubles I doubles A doubles m doubles Pair doubles Pair and A double m and A double
ο Σ-Τ-w=0 ο Σ,-w+ T;sin60 = 0 ο Σ,- ΤCOS60 + T, = m ο Σ,- wco560 - Tι = m ο Σ,- T;sin 60 + T, =0 ο Σ,-Τsin60 - T = 0 ο Σ-w- Τs =0