Two blocks of mass M1 and M2 are connected by a masslessstring that passes over a massless pulley as shown in thefigure. M1 has a mass of 8.75 kg and rests on an incline ofM201 = 63.5°. M2 rests on an incline of 02 33.5°. Find the%3DM,mass of block M2 so that the system is in equilibrium (i.e.,not accelerating). All surfaces are frictionless.0,Figure is not to scale.kgM2 =

Answered: Image /qna-images/answer/90ef1e1c-3824-466e-8f3c-57e08cd2508a.jpg

Answered: Two blocks of mass M and M2 are…

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Here we have successfully built up a problem that uses one topic from each of the four quarters of material we have covered. A block with mass m1 a horizontal table and is attached to a rope. m1 3.00 kg sits on The горe then passes over a Isolated Air MASSIVE pulley and is attached to a block of mass m2 = 2.00 kg, which hangs vertically (see picture). The coefficient of kinetic friction of the interface between the table and m¡ is 0.1. You may assume the pulley section is a disk with a mass of 2.00 kg. We will keep the pulley frictionless for brevity. with Q added m2 Ideal disk pulley with mass of 2.00 kg This time, however, mị is a piston attached to an isolated volume of air that is heated in such a way that the air is always allowed to expand ISOBARICALLY. The pressure of air inside AND outside the chamber is 1 atm. The initial volume of air is 0.100 m³. The cross-sectional area of the m, piston on either side perpendicular to its motion is 0.0100 meters.
Assume that all quantities are good to 3 significant figures...do not start rounding off too early or too much! All numeric answers should be entered rounded to 3 significant figures and assuming proper SI Units unless otherwise stated. Consider just these 2 forces acting on a mass of 2.79 kg. F1 = 8.36 N @ 21.5 degrees and F2 = 6.80 N @ 76.7 degrees where the angles are measured relative to the +x direction. What is the magnitude of the acceleration produced considering only these 2 forces acting?
A telephone pole has three cables pulling as shown from above, with F₁ = (300.0 N, 500.0 N), F2 = (-200.0 N, 0.000 N), and F3 = (0.000 N, -800.0 N). Find the magnitude and direction of this net force. Note: The angle measured from the positive x-axis into the counter-clockwise direction is positive. 316.2 N, -71.57⁰. 316.2 N, 71.57⁰. 320.0 N, -71.57⁰. 316.2 N, -288.4⁰. 316.2 N, 18.43⁰. 316.2 N, -18.43⁰. 320 N, - O 320.0 N, -72.00⁰. -70⁰.
Objects with masses m1 = 13.0 kg and m2 = 6.0 kg are connected by a light string that passes over a frictionless pulley as in the figure below. If, when the system starts from rest, m2falls 1.00 m in 1.37 s, determine the coefficient of kinetic friction between m1 and the table.
on 1 of 8 Two blocks, M, and M,, are connected by a massless string that passes over a massless pulley as shown in the figure. M, has a mass of 4.25 kg and rests on an incline of 0, = 69.5°. 27.5°. Find the mass of block M2 rests on an incline of 0, M2 M2 so that the system is in equilibrium (i.e., not accelerating). All surfaces are frictionless. м, M. kg M2 Figure is not to scale. contact us help privacy policy 12 about us careers 4/ a
question 24 from the image
A 4.00-kg block rests between the floor and a 3.00-kg block as shown in the above figure. The 3.00-kg block is tied to a wall by a horizontal rope. If the coefficient of static friction is 0.800 between each pair of surfaces in contact, what force must be applied horizontally to the 4.00-kg block to make it move?
11. A tractor has mass 750.0 kg, while cart A has mass 350.0 kg and cart B has mass 150.0 kg. The driving force acting for a brief period of time accelerates the system from rest and acts for 1 minute. (a) If this driving force is given by F = 1000t N, find the speed after 5.00 seconds. (b) What is the horizontal force acting on the connecting cable between the tractor and cart A at this instant?
The block of mass m = 10.2 kg shown in the figure (Figure 1) is held in place by the force applied to a massless rope passing over two massless, frictionless pulleys. Figure T₂ T₁ 772 T4 Ts TE 1 of 1 Find the tensions T₁ to T and the magnitude of force F. Enter your answers in newtons separated by commas. 17 ΑΣΦΑ T1, T2, T3, T4, T5, F = Submit Previous Answers Request Answer X Incorrect; Try Again Provide Feedback ? N
A block of mass ?=2.80 kg is being pulled by a force ?⃗of magnitude 12.0 N on a horizontal, smooth (frictionless) surface. The force makes an angle ?=30.0° abovethe horizontal, as shown in the figure. 1. Find the magnitude of the normal force exerted by the surface on block. 2. Find the acceleration of the box. 3. If the box starts from rest, what would be its speed after it travels 2.00 m?
Two objects with masses of m1 = 2.00 kg and m2 = 6.40 kg are connected by a light string that passes over a frictionless pulley, as in the figure below. Answer all of the follwing questions. (a) Determine the tension in the string. (Enter the magnitude only. Due to the nature of this problem, do not use rounded intermediate values in your calculations—including answers submitted in WebAssign.) N(b) Determine the acceleration of each object. (Enter the magnitude only.) m/s2(c) Determine the distance each object will move in the first second of motion if both objects start from rest. m
The m = 8.40 kg block in the figure(Figure 1) is held in place by the massless rope passing over two massless, frictionless pulleys. Figure T₂ TA T m T3 Ts F 1 of 1 Part A Find the tensions T₁ to T and the magnitude of force F. Enter your answers numerically separated by commas. 15| ΑΣΦ T1, T2, T3, T4, T5, F= 82.32,41.16 Your submission doesn't have the correct number of answers. Answers should be separated with a comma. No credit lost. Try again. Submit Previous Answers Request Answer Provide Feedback P Pearson ? N Next >

SEE MORE QUESTIONS

Recommended textbooks for you

College Physics

Physics

ISBN:

9781305952300

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

University Physics (14th Edition)

Physics

ISBN:

9780133969290

Author:

Hugh D. Young, Roger A. Freedman

Publisher:

PEARSON

Introduction To Quantum Mechanics

Physics

ISBN:

9781107189638

Author:

Griffiths, David J., Schroeter, Darrell F.

Publisher:

Cambridge University Press

College Physics

Physics

ISBN:

9781305952300

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

University Physics (14th Edition)

Physics

ISBN:

9780133969290

Author:

Hugh D. Young, Roger A. Freedman

Publisher:

PEARSON

Introduction To Quantum Mechanics

Physics

ISBN:

9781107189638

Author:

Griffiths, David J., Schroeter, Darrell F.

Publisher:

Cambridge University Press

Physics for Scientists and Engineers

Physics

ISBN:

9781337553278

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

Lecture- Tutorials for Introductory Astronomy

Physics

ISBN:

9780321820464

Author:

Edward E. Prather, Tim P. Slater, Jeff P. Adams, Gina Brissenden

Publisher:

Addison-Wesley

College Physics: A Strategic Approach (4th Editio…

Physics

ISBN:

9780134609034

Author:

Randall D. Knight (Professor Emeritus), Brian Jones, Stuart Field

Publisher:

PEARSON

SEE MORE TEXTBOOKS