Three phase, 60 Hz 6600/1100 Y/2 connected transformer single phase visible on the high voltage (primary) windings side www Equivalent circuit parameters are given below. Each of the low voltage (secondary) windings of this transformer When a 5 ohm delta resistive load is connected and the rated voltage is applied to the high voltage windings, Find the transformer efficiency. Total iron losses of three phases will be taken as 2500 W. www. Primer sargı iç direnci (R1) Primer sargı kaçak reaktansı (X1) Sekonder sargı iç direnci Sekonder sargı kaçak (primere taşınmış) (R2') reaktansı (primere taşınmış) (X2') 0,95 2 0,65 2 0,95 2 0,55 2

Three phase, 60 Hz 6600/1100 Y/2 connected transformer single phase visible on the high voltage (primary) windings side www Equivalent circuit parameters are given below. Each of the low voltage (secondary) windings of this transformer When a 5 ohm delta resistive load is connected and the rated voltage is applied to the high voltage windings, Find the transformer efficiency. Total iron losses of three phases will be taken as 2500 W. www. Primer sargı iç direnci (R1) Primer sargı kaçak reaktansı (X1) Sekonder sargı iç direnci Sekonder sargı kaçak (primere taşınmış) (R2') reaktansı (primere taşınmış) (X2') 0,95 2 0,65 2 0,95 2 0,55 2

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

4. What are the advantages of Delta connection in high power transformer?
don't copy
What conclusions we come up with after doing open circuit test on single phase transformer.
formula for determining the power of a single-phase transformer
Justify if in a Yy transformer (without neutral wire on the supply side) there are homopolar components in fluxes, voltages and currents, and indicates whether this operation is satisfactory or not
B- the eddy current losses of 400V, 50 Hz transformer is 1600W and the total iron losses i 2500W. calculate the iron losses at 200V, 25 Hz.
Calculate the total equivalent resistance, in terms of the primary winding, of a 10 to 1 ratio transformer in which the primary copper loss is 20 per cent greater than the secondary copper loss, given that the resistance of the secondary (low tension) winding is 1.5 ohms.
b) The parameters of the transformer equivalent circuit are given bellow, Primary =1290. Secondary winding turns =130. The resistance of the primary winding =0.2 O. The resistance of the secondary winding =0.06 N. The leakage reactance of the primary winding =1.47 Q. The leakage reactance of the secondary winding =0.07 Q. using the above parameter values, referred to the primary winding, determine (a) Equivalent resistance, (b) Equivalent reactance, (c) Equivalent impedance and (d) The phase angle of the impedance.
In a single phase transformer when all parameter is shifted to primary side value of primary side resistance is 0.5 ohm and resistance which is shifted from secondary to primary is also 0.5 ohm. If full load current in primary side is 20(A) what is total copper loss in transformer.