The toy sprinkler consists of a 0.2 kg cap and a hose that has a mass per unit length of 30 g/m. Determine the required rate of flow of water through the 5-mm-diameter tube so that the sprinkler will lift 1.5 m from the ground and hover from this position. Neglect the weight of the water in the tube. pw = 1 Mg/m. 1.5 m

The toy sprinkler consists of a 0.2 kg cap and a hose that has a mass per unit length of 30 g/m. Determine the required rate of flow of water through the 5-mm-diameter tube so that the sprinkler will lift 1.5 m from the ground and hover from this position. Neglect the weight of the water in the tube. pw = 1 Mg/m. 1.5 m

Name: 10/12.100%5. The toy sprinkler consists of a 0.2 kg cap and a hose th
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: 10/12.100%5. The toy sprinkler consists of a 0.2 kg cap and a hose that has a mass per unit length of 30 g/m.Determine the required rate of flow of water through the 5-mm-diameter tube so that the sprinklerwill lift 1.5 m from the ground and hover f

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Air is flowing in the wind tunnel in the laboratory. The temperature in the laboratory is 22°C and the height of the column of mercury in the barometer in the laboratory is 634 mm. The liquid in the manometer being used to measure the vacuum in the wind tunnel is oil having a specific gravity of 0.826, and the manometer reading is 125 mm . The wind tunnel is on the CU campus in Denver where g = 9.796 m/s² . a) Find the atmospheric pressure of the air in the laboratory (answer: 84092 Pa). b) Find the absolute pressure of the air in the wind tunnel (answer: 83081 Pa). c) Find the density of the air in the wind tunnel (answer: 0.981 kg/m³). Air at 22°C → h = 125 mm Oil, SG = 0.826
An engineer must design the support system to hold the pipe junction. Determine the reactions to design this system. The system into the discharges (15%) atmosphere. V2=7m/s 45° V1=16m/s 18 cm 4D1-> P=60 kPa 20 cm V3-33 m/s
A boat having a mass of 80 Mg rests on the bottom of the lake and displaces 11.75 m^3 of water. Since the lifting capacity of the crane is only F = 550 kN, two balloons are attached to the sides of the boat and filled with air. The volume of a sphere is V =4/3πr^3. ρw = 1000 kg/m^3.Determine the smallest radius r of each spherical balloon that is needed to lift the boat. Neglect the mass of air and of the balloon for the calculation required for the lift and What is the mass of air in each balloon if the air and water temperature is 12∘C? The balloons are at an average depth of 20 mm. The gas constant for air is R= 286.9 J/(kg⋅K)
4. Two reservoirs, A and B, are connected by a pipeline which is 1300 m long. The surface of reservoir B is 10 m lower than that of reservoir A. There is a small hill between the two reservoirs with the highest point at 500 m along the pipe from A. If the pipeline has a diameter of 300 mm and a friction factor of λ = 0.008 then determine the following: (Ignore the minor losses and assume that the pipe is already flowing full and at a steady flow) (a) The flow in the pipe (b) If the lowest permissible absolute pressure head in the pipeline is 2.5 m of water, determine how high above reservoir A surface level the pipe can be laid so that the minimum pressure condition is satisfied. (Assume atmospheric pressure of 105 Pa.)
Pa QUESTION 1 An aircraft has a wing area of 20 m² and whose wings resemble the NACA 23012 with no flaps and is flying horizontally (0° angle of attack) at a constant speed of 250 km/h. To gain height the pilot adjusts the controls so that the angle of attack becomes 10°. Take the density of the air as 1.23 kg/m³. Determine the total power required to execute this action at the same constant speed.
Please answer quickly. Thanks
Q/ 1000 kg car requires eight seconds to change its speed from 0 km/h to 140 km/h. What is the powered delivered by the Engine during this time?
A sled with two runners slides along a thin horizontal layer of water between the ice and the runners. The horizontal force that the water puts on the runners is equal to 2.4 lb when the sled's speed is 50 ft/s. The total area of both runners in contact with the water is 0.04 ft2, and the viscosity of the water is 3.5x10 lbs/ft2. Determine the thickness of the water layer under the runners. Assume a linear velocity distribution in the water layer.
Determine the mass of air that has entered the rigid tank if it has a volume of 0.75 m3 and initially contains air whose density is 1.18 kg/m3. The tank is connected to a high-pressure supply line through a valve. The valve is opened, and air is allowed to enter the tank until the density in the tank rises to 4.95 kg/m3. Express your answer in 2 decimal places and in kg.
As shown in Figure 2.3, the total height of the liquid in the canal in Part (a) is now increased to 3R. Determine the minimum force F applied at B to prevent the gate ABC from opening (i.e. turning anticlockwise about the hinge A). Neglect the weight of the gate and friction in the hinge. F- 2R Air с B Gate R Air Liquid Hinge Figure 2.3 Р 777. gv
fluid mechanics Question 3- The hot air balloon A hot air balloon is stationary about 3 m above the ground when a gust of wind suddenly arrives with a speed of 40 km/h. Determine the horizontal initial acceleration. The balloon is designed as a sphere with a diameter of 10 m. It is filled with 80°C air. Ambient air has a temperature of 10°C. The actual fabric balloon and basket with cargo has a mass of 200 kg.