The system shown below consists of a 1 kg block B on a 30° smooth slope attached to a cable which is wrapped around a 1 kg drum. The system is originally at rest. If a 100 N. m couple is applied to the drum A, determine the speed vB2 of the block after it has moved 6 m up to the slope.

The system shown below consists of a 1 kg block B on a 30° smooth slope attached to a cable which is wrapped around a 1 kg drum. The system is originally at rest. If a 100 N. m couple is applied to the drum A, determine the speed vB2 of the block after it has moved 6 m up to the slope.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

3. The two blocks shown start from rest. The horizontal plane and the pulley are frictionless, and the pulley is assumed to be of negligible mass. Determine the acceleration of each block and the tension in the cord. A 140 kg D C 400 kg B
NOTE: Please answer problem #2. Prob#1: Determine the time required that the elevator travels at any instant at a distance of 8 meters. The weight of the elevator is 10,000 N moving downward from rest until its velocity is 15 m / sec. (sec.) Please answer this question only: Prob#2: In Problem 1, determine the force exerted in the cable to support the elevator. (kN)
Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Block A has a mass of 16 kg, and blocks B and Chave masses of 8 kg each. Assume that the blocks are initially at rest and that B moves through 3 m in 2 s. Neglect the masses of the pulleys and the axle friction. B P D C Determine the tension in the cord AD. The tension in the cord AD is TEN.
Q5) The 50-kg crate shown rests on a rough horizontal surface for which the coefficient of kinetic friction is #x=0.3. An electrically powered winch is utilized to accelerate the crate at a constant rate until it attains a speed of v-Sm's within a distance of s=20m. If the motor and the winch have an efficiency of n-0.70, determine the power that must be supplied to the motor when s= 20 m. 20 m 50 kg D
Block A weighs 10 kg and Block B weighs 100 kg. They are mounted to frictionless pulleys When the blocks are released; block B drops down while Block A goes up. (using simul equation and 2 unknowns at calculator) Determine the acceleration of Block A Determine the acceleration of Block B Determine the tension of the cable.
It takes 34 s for the 60-Mg tugboat to increase its speed uniformly to 25 km/h, starting from rest. The propeller provides the propulsion force F which gives the tugboat forward motion, whereas the barge moves freely. The barge has a mass of 84 Mg . (A) Determine the force of the rope on the tugboat. Express your answer to three significant figures and include the appropriate units. (B) Also, determine F acting on the tugboat. Express your answer to three significant figures and include the appropriate units.
A small block with mass mm slides without friction on the inside of a vertical circular track that has radius R. What minimum speed must the block have at the bottom of its path if it is not to fall off the track at the top of its path? Express answer in terms of some or all of the variables m, R, and acceleration due to gravity g.
The two block shown in figure are originally at rest. Neglecting the masses of the pulleys and the effect of friction in the pulleys and between the blocks and the incline, Determine (a) the velocity of block A after it has moved 4m, (b) the tension in the cable. 90° 300 kg 200 kg 20°
A 1.4-lb slider is propelled upward at A along the fixed curved bar which lies in a vertical plane. If the slider is observed to have a speed of 8.2 ft/sec as it passes position B, determine (a) the magnitude N of the force exerted by the fixed rod on the slider and (b) the rate v at which the speed of the slider is changing (positive if speeding up, negative if slowing down). Assume that friction is negligible. B 32 3.1' Answers: N = i Ib i ft/sec?
B8
2. (25) The small 2-kg block A slides down the curved path and passes the lowest point B with a speed of 4 m/s. If the radius of curvature of the path at B is 1.5 m, and the coefficient of friction between the block and path is 0.3, determine (a) the normal force exerted on the block by the path at B, and (b) the rate of change of speed at this point. B
The two blocks shown start from rest. The horizontal plane and the pulley are frictionless, and the pulley is assumed to be of negligible mass. Determine the acceleration of each block and the tension in each cable. A Cable 1 100 kg Cable 2 300 kg в