The motor at B supplies a constant torque M which is applied to a 325-mm-diameter internal drum around which is wound the cable shown. This cable then wraps around a pulley which has a mass of 72 kg and is attached to a cart which has a mass of 120 kg carrying 640 kg of rock. The motor is able to bring the loaded cart to a cruising speed of 1.8 m/s in 4 seconds. What torque M is the motor able to supply, and what is the average value of the tension in each side of the cable which is wrapped around the pulley at O during the speed-up period? The cable does not slip on the pulley and the centroidal radius of gyration of the pulley is 385 mm. What is the power output of the motor when the cart reaches its cruising speed? 650 mm A 15° Answers: M= Ttop i Nom N Tbot= N P = kW B

Q: 16. When a liquid is at a temperature lower than its saturation point, it is said to be

A: When the liquid is at a temperature lower than the saturation point then it is called Compressed…

Q: 1 "16. You have just moved to a hot, dry climate where it is 37C and 20% rh, and the heat is…

A:

Q: b) The bore diameter of each cylinder in a six-cylinder four-stroke internal combustion engine is 32…

A:

Q: Convert each temperature. 22 °C to K (approximate room temperature)

A: Given, temperature = 22oC we know 1oC = 273 K

Q: If FB = 560 N and Fc = 700 N, determine the magnitude and coordinate direction angles of the…

A:

Q: A power plant turbine releases its discharge into a condenser operating at 20C at 100% saturated…

A: It is given that:condenser temperature is 20°C. Steam enters condenser as 100% saturated vapor.Mass…

Q: 1. A pressure transducer is used multiple times to measure the pressure in a tank. It turns out that…

A: Accuracy is how close the measurement to the true values. While precision is how consistent or how…

Q: The bore diameter of each cylinder in a six-cylinder four-stroke internal combustion engine is 32 mm…

A: Find  Mean effective pressure, Indicated Power

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.