The square wave voltage seen in figure 1 is applied to the combination of inductors seen in figure 2. (a) Find the equivalent inductance seen between terminals A and B. (b) Calculate and draw the current, i(t), instantaneous power p(t), and energy w(t) waveforms for this equivalent inductor. Assume that initially there is no energy stored in the inductors. (c) Calculate the energy stored in this circuit at 2ms.

The square wave voltage seen in figure 1 is applied to the combination of inductors seen in figure 2. (a) Find the equivalent inductance seen between terminals A and B. (b) Calculate and draw the current, i(t), instantaneous power p(t), and energy w(t) waveforms for this equivalent inductor. Assume that initially there is no energy stored in the inductors. (c) Calculate the energy stored in this circuit at 2ms.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: istance is R, the inductance is L, and the impressed voltage is E(t). (Use i for

Q: A single 50 mH inductor forms a complete circuit when connected to an ac voltage source at 120 V and…

A: Given that:L=50 mH=50×10-3 HVo=120 Vf=60 Hz

Q: In the circuit of the figure below, the battery emf is 55 V, the resistance R is 150 2, and the…

Q: In a purely inductiveAC circuit as shown in FigureP21.15, ΔVmax = 100. V.(a) The maximum currentis…

A: Part A:

Q: What percentage of the final current I0 flows through an inductor L in series with a resistor R,

Q: A) An RLC series circuit has a 2102 resistor a 15 mH inductor and a capacitor. At 6500 Hz, the phase…

A: RecallXL=ωLXC=1/ωCZ=R2+(XL-XC)2irms=Vrms/Z

Q: LET R=350ohms, L=60mH, C=0.425microF; determine the equation of the ff; a. eqn for voltage across…

Q: A capacitance of 0.4 µF is connected to an alternating e.m.f. of 100 c.p.s. What is the capacitive…

A: To find-Capacitive reactance (XC)=?Given-C=0.4 μFC=0.4×10-6 FaradFrequency (f)=100 c/s

Q: An RLC series circuit has a 250 2 resistor, a capacitor of 75 nF and an inductor. At 5500 Hz, the…

A: Given that - resistor Capacitor Phase angle Frequency To Find - Part(a)- We have to calculate the…

Q: The capacitance of capacity 0.4 µF is connected to an alternating e.m.f. of 100 cycles. What is the…

A: To find-XC=?Given-Capacity (C)=0.4 μF=0.4×10-6 Ffrequency (f)=100 cycles/s=100 Hz

Q: A series circuit contains a resistor and an inductor as shown in the figure. Determine a…

A: Let the current is flowing in the circuit.According to the mesh analysis,Put the value of in the…

Q: Please don't provide handwritten solution...

Q: In the given circuit, four identical resistors with resistance R= 3 ohm, one inductor with…

A: Given data: The resistance of resistor is R=3 Ω. The inductance of inductor is L=4 mH. The…

Q: ●Two coils, held in fixed positions, have a mutual inductance of 170 µH. What is the peak emf in one…

A: Inductors when placed close to each other will affect each other. The magnetic field generated on…

Q: The capacitance of capacity 0.4 µF is connected to an alternating e.m.f. of 100 cycles. What is the…

A: To find-The capacitive reactance (XC)=?Given-Capacity of capacitor (C)=0.4 μF=0.4×10-6 FFrequency of…

Q: After you disconnect the DC power supply from an LC circuit, it oscillates at a frequency of f. Now…

A: The LC oscillation frequency is given by : f=12πLC When the circuit is cooled, L and C are kept…

Q: A series RLC circuit is driven in such a way that the maximum voltage across the inductor is 2.30…

Q: Suppose you need to construct a resonant frequency of 52.5 Hz. What inductance in henries do you…

Q: In the L-C circuit in the figure, the ammeter reads a maximum current of I = 5.19 mA. The…

Q: Q. 1. A source of ac voltage V = Vosin oot, is connected across a pure inductor of inductance L.…

A: We know a source of ac voltage , is connected across a pure inductor of inductance L. Derive the…

Q: A series RLC circuit is driven in such a way that the maximum voltage across the inductor is 1.50…

Q: In the series circuit R = 200 Q, L = 450 mH, and C = 5.0 µF. The power supply voltage is given by...…

Q: Suppose that the resistance is 12 ohms and the inductance is 4H, and a generator that produces a…

Q: A large superconducting magnet, used for magnetic resonance imaging, has a 50.0 H inductance. If you…

A: Write the formula for the time constant.

Q: For the coaxial line filled with two dielectric media as shown in figure below, a) Find the…

A: Given:inner radius of the conductor, adielectric 1, has permittivity, ε1it has a radius of…

Q: EXERCISE HINTS: GETTING STARTED I'M STUCK! An AC generator is to have a maximum output of 329 V.…

A: EXERCISE Given that The maximum output voltage,εmax=329 V Area of the coil,A=0.110 m2…

Q: At sliat frequency is the reactance of a 20 - μF capacitor equal to that of a 10-mH inductor?

A: Given that-The capacitance of the capacitor is 20μFInductance of the inductor is 10 mHWe know…

Q: Use the worked example above to help you solve this problem. An AC generator consists of eight turns…

A: Since you have asked multiple questions we will solve the first question for you. If you want any…

Q: Let I, r, c and v represent inductance, resistance, capacitance and voltage, 1. respectively. The…

Q: an 8.5nF capacitor is initially charged by connecting it to a 120V power supply amd then…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

The square wave voltage seen in figure 1 is applied to the combination of inductors seen
in figure 2.
(a) Find the equivalent inductance seen between terminals A and B.
(b) Calculate and draw the current, i(t), instantaneous power p(t), and energy w(t)
waveforms for this equivalent inductor. Assume that initially there is no energy stored
in the inductors.
(c) Calculate the energy stored in this circuit at 2ms.
18V
v(t)
2 3
t (ms)
-18V
Figure 1
24 mH
Ao
8 mH
51 mH
V(t)
Bo-
6.8 mH
Figure 2

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step by step

Solved in 6 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

How do I solve this question Pt A -C? A series RLCcircuit consists of a 75 Ω resistor, a 0.19 H inductor, and a 25 μFcapacitor. It is attached to a 120 V/60 Hz power line. What is the peak current II at this frequency? What is the phase angle ϕ? What is the average power loss?
The capacitance of capacity 0.4 µF is connected to an alternating e.m.f. of 100 cycles. What is the capacitive reactance.
Use the worked example above to help you solve this problem. An AC generator consists of eight turns of wire, each having area A = 0.0890 m², with a total resistance of 10.3. The loop rotates in a magnetic field of 0.445 T at a constant frequency of 63.5 Hz. (a) Find the maximum induced emf. V (b) What is the maximum induced current? A (c) Determine the induced emf and current as functions of time. E = ( V)sin(wt) I = ( A) sin(wt) W = (d) What maximum torque must be applied to keep the coil turning? N.m (
Solve it asap
In the given circuit, four identical resistors with resistance R= 5 ohm, one inductor with inductance 4mH, a capacitor with capacitance 2μF and an ideal battery with emf = 62 V are connected. What is the current through the battery, long time after the switch is closed? (Please write your answer in the box without rounding and unit. Write what you see on calculator upto two decimal points. DO NOT WRITE UNIT) mell ww www
You are given an LC oscillator, with an L = 3.3 mH and a C = 0.09 mF. Initially, the inductor has a current flowing through it of 24 mA and the charge on the capacitor is zero at this same time. Find the maximum charge that we can expect on the capacitor at some later time. Assume that there are no internal resistance losses for these oscillations.
An inductor and a resistor are connected in series. When connected to a 60-Hz, 90-V (rms) source, the voltage drop across the resistor is found to be 55 V (rms) and the power delivered to the circuit is 18 W. (a) Find the value of the resistance. 22 (b) Find the value of the inductance. H
A(n) 37.0 µF capacitor is charged to 4.7 µC and then an inductor of 9 mH is connected across the terminals of the charged capacitor. Find the maximum current that will flow in this circuit assuming there are no losses due to internal resistance.