Answered: Q. 1. A source of ac voltage V = Vosin… | bartleby

Related questions

Question

Q. 1. A source of ac voltage V = Vosin oot, is connected
across a pure inductor of inductance L. Derive the
expressions for the instantaneous current in the
circuit. Show that average power dissipated in the
circuit is zero.

Expert Solution

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A microscope illuminator uses a transformer to step down the 120 V AC of the wall outlet to power a 12.0 V, 50 W microscope bulb.a. What is the resistance of the bulb filament?b. What is the rms current in the bulb filament?c. What is the rms current in the primary coil?
A 250-ohm resistor, a 0.450 H inductor, and a 6.45 µF capacitor are connected in series across an emf with a 36.0 volt amplitude and an angular frequency of 260 rad/s. What is the impedance? What is the current amplitude? What is the phase angle between the voltage and current? Does the voltage lag or lead? a. b. с.
An inductor is connected across an oscillating emf. The peak current through the inductor is 2.0 A. ▼ Part A What is the peak current if the inductance L is doubled? Express your answer with the appropriate units. I = Submit Part B I = Submit Part C 0. μA Value I = Request Answer What is the peak current if the peak emf &o is doubled? Express your answer with the appropriate units. μA Value Request Answer μÀ Value Units Submit Request Answer C Units What is the peak current if the frequency w is doubled? Express your answer with the appropriate units. w B Units ? ? ?
Two resistors of resistance R1and R2 are placed in series across a battery with voltage V, such that a current I=V/(R1+R2) flows around the circuit. If a coil with inductance L is then placed inparallel withR1, what is the new currentIa long time after the coil has been added? Give your final answer.
An inductor is connected across an AC source. show the graph of the instantaneous current through the inductor and the instantaneous voltage across the inductor?
An AC circuit has a purely capacitive load. If the amplitude of the EMF is 10.27 V with a frequency of 193.3 Hz, the capacitance is 73.2 UF, and the driving voltage is initially zero. What is the current in the capacitor after 0.732 s? A Save for Later Submit Answer
Your RL circuit has a characteristic time constant of 21.5 ns, and a resistance of 5.40 MΩ. A. What is the inductance (in H) of the circuit? B. What resistance (in MΩ) should you use (instead of the 5.40 MΩ resistor) to obtain a 1.00 ns time constant, perhaps needed for quick response in an oscilloscope?