The specific gravities and weight proportions for aggregate bitumen are as under for the preparation of Marshall Mix design. The volume and weight of one marshall specimen was found to be 475 cc and 1100 gm. Assuming absorption of bitumen in aggregate is zero. Find Vv V₂₁ VMA and VFB. Item Weight Specific Gravity Aggregate-1 Aggregate-2 Aggregate-3 Aggregate-4 Bitumen 825 1200 325 150 100 2.63 2.51 2.46 2.43 1.05

According to Figure 5-20, is ii possible to completely separate one of the four materials from the other three? Explain your answer.

Three groups of students from the Geotechnical Engineering class collected soil-aggregate samples for laboratory testing from a recycled aggregate processing plant in Palm Beach County, Florida. Three samples, denoted by Soil A, Soil B, and Soil C, were collected from three locations of the aggregate stockpile, and sieve analyses were conducted (see Figure 2.35). (a) (b) Figure 2.35 (a) Soil-aggregate stockpile; (b) sieve analysis (Courtesy of Khaled Sobhan, Florida Atlantic University, Boca Raton, Florida) a. Determine the coefficient of uniformity and the coefficient of gradation for Soils A, B, and C. b. Which one is coarser: Soil A or Soil C? Justify your answer. c. Although the soils are obtained from the same stockpile, why are the curves so different? (Hint: Comment on particle segregation and representative field sampling.) d. Determine the percentages of gravel, sand and fines according to Unified Soil Classification System.

An existing rural 4-lane highway is to be replaced by a 6-lane divided expressway (3 lanes in each direction). Traffic volume data on the highway indicate that the AADT (both directions) during the first year of operation is 24,000 with the following vehicle mix and axle loads. Passengercars=50percent 2-axle single-unit trucks (12,000lb/axle)=40percent 3-axle single-unit trucks (16,000lb/axle)=10percent The vehicle mix is expected to remain the same throughout the design life of 20 years, although traffic is expected to grow at a rate of 3.5 percent annually. Using the AASHTO design procedure, determine the minimum depth of concrete pavement required for the design period of 20 years. Pi=4.5J=3.2Pt=2.5Cd=1.0Sc=650lb/in.2So=0.3Ec=5106lb/in.2R=95k=130lb/in.3

A tensile test was performed on a metal specimen with a diameter of 1 2 inch and a gage length (the length over which the elongation is measured) of 4 inches. The dam were plotted on a load-displacement graph. P vs. L. A best-fit line was drawn through the points, and the slope of the straight-line portion was calculated to be P/L =1392 kips/in. What is the modulus of elasticity?