The Schottky diode is used a. in high-power circuits. • b. in circuits requiring negative resistance. C. none of these d. in power supply rectifiers. O e. in very fast-switching circuits.

Q: Answer Question1 D,E,F please

A: In this question we need to find the Laplace transform of the given signal.

Q: The rotational losses for a 1000 hp synchronous motor are found to be 18 kW. The motor operates from…

A: Given V =2300 V Power =1000 HP Rotational loss =18 kW synchronous reactance = Xs =1.9 ohm   We have…

Q: d) depending upon the value ofk

A:

Q: What will be value of R1.

A:

Q: Question: 1) Use superposition technique to determine V, in the circuit given in figure 01. 600 N…

A: Given circuit is: 1. Turn off all independent source except one source 2. If we desire to calculate…

Q: If the area of cross section of a conductor is increasing, then the resistance of the conductor…

A: If the area of the cross section of a conductor is increase then resistance?

Q: 3. Determine the voltage across R2 for the first and second diode approximations. Diode: Si, r = 10…

A:

Q: Q1: check the Circuit is stiff or not ? Bdc = l0 Vce = lov R, Rc lok RE 5.6K 56052

A: The solution is given below

Q: Question-Sa BJT based current-mirror VBEQIVREQ2 +0.7V & Bor a) Apply KVL at Rref & Q1 branch to…

A:

Q: time t seconds, find (a) the total charge that has entered between 4 and 9 seconds, (b) the charge…

A:

Q: Q1. Design a 4-input, one output combinational logic circuit for the following input-output…

A:

Q: Determine the power factor of the entire circuit below as seen by the source. Calculate the average…

A: In this question we need to find a input power factor and average power delivered by source.

Q: T- Design a CS amplifier using E-MOSFET with voltage gain 20dB , VGs=5V, VDD=12V (gm=4500µS ).

A: Due to the complexity involved in the questions, we shall answer only one question in this session.…

Q: a) Find the no-load value of v, in the circuit shown. b) Find v, when Rị is 150 kN. c) How much…

A: As per company guidelines, we are supposed to answer the first 3 subparts of the question. Kindly…

Q: Q1. It is desired to run the motor at 1000 rpm, Find the value of the field resistance that to be…

A: 1)Given Desired speed N2=1000 rpmV=220 vRa=0.5 ΩRf=200 ΩT=constantArmature current Ia=20 Aspeed…

Q: For the circuit shown below, The maximum power supplied to the load resistor (Pmax)= 475 Watts and…

A: Find the Thevenin voltage Vth If the maximum power given.

Q: The input to the system is x[n], the impulse response hi[n] and hz[n] are in 1. Let x[n]- [1 2 4 21,…

A: Given  x[n]=1 2 4 2h1[n]=2 0 1 5h2[n]=1 1 1xn is inputh1[n] & h2[n] are connected in cascade

Q: (a) 10 cos(100r + (b) 10 cos (1001 +) + 16 sin (150r + ") (c) (10+2 sin 3t) cos 10r

A:

Q: 1. A balanced Y-load is connected to a 60-Hz three-phase source with Vab = "A" v. The load has pf =…

A:

Q: Ex. 430. G(s)=k (s+3)/(s(s+ 4)(s+ 5)) is the forward transfer function of a unity feedback…

A: The root locus is the plot of location of poles of the closed loop transfer function by varying the…

Q: R1 R2 R3 IS IS; İs1=2,9 Amps VR2=2,3 Volts R1=160 R2=132 R3=32

A:

Q: 1. Refer to Figure 1. A Y-connected source supplies 3 balanced 3-phase loads. The source has voltage…

A: As per the client requirements, We are providing the solution of Part G in multipart Question. Delta…

Q: Qlfill the blank 1-The current in semi- conductor produced by. 2-Processof adding an impurity to an…

A: As per Bartleby guidelines we are allowed to solve only three subparts,please ask the rest again.

Q: BA series-connected load draws a current i(t) = 4 cos(315t + 10°) A when the applied voltage is v(t)…

A: According to question we have to calculate the value of Apparent power, power factor  and value of…

Q: In the circuit of Fig. 2.76, obtain v1, V2, and v3. 15 V 25 V 10 V + V2 - + v2 20 V v1 = V V2 = V3 =…

A: To find voltages v1 , v2 and v3 in the given circuit

Q: 1. A hydro-electric power station is supplied from a reservoir having an area of 59 km2 and a head…

A: A hydro-electric power station is supplied from a reservoir having an area of 59 km2 and a head of…

Q: d) collector current, Ico e) base current, Ig f) beta, B g) collector resistor, Rc h) base resistor,…

A: We need to find out resistance value for given graph .

Q: # Implement the following function using Op Amps: O E = 11 - 11 V2 + 10 d Vs dt (ii) F2 = 11Vy – 15…

A: We need to implement the following given function using Op-amps: i F1=11v1-11v2+10dv3dt,ii…

Q: A single phase 220-V shunt DC motor has armature winding resistance is 0.2 2, the field winding…

A:

Q: If we use 5000 µF, we can get a very low ripple voltage. But this is so bad and this a disadvantage,…

A: Ripple voltage usually occurs when we convert the AC voltage in to DC voltage conversion. But at…

Q: ind the slew rate SR of op-amp.

A:

Q: Question is in the image

A: Let’s draw the single line diagram by locating distance and current Let r be a resistance per unit…

Q: 1. For a circuit with the following given: E = 50V, R = 10 ohms and C = 4(10)-4 farad. Assume that…

A:

Q: For numbers 11-14, refers to the figure below. G- 0.04 µF 47 pF 0.02 uF 150 pF 0.047 µF G= 100 pF…

A: In this question we will find equivalent capacitance of figure... Note:- due to Bartleby policy, I…

Q: 9. Find the the equivalent capacitance, the voltage across the capacitors, and the energy stored in…

A: The given circuit is shown below.We need to calculate equivalent capacitance of the circuit from…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.