The rigid bar AC is supported by a hinge at A and a steel cable BD having a diameter of 12 mm. The boom supports a horizontal load F = 24 kN acting at point C. Neglecting the weight of the bar, determine the horizontal displacement of the point where the load F is acting. For steel, E = 200 GPa.

Q: The solid 34 mm diameter steel [E = 200 GPa] shaft supports two belt pulleys. Assume that the…

A: Given Data:Diameter of steel shaft =34mmAssumption: Bearing at support B as roller,Bearing at D as…

Q: Q4/ The rigid beam is supported by a pin at A and two steel wires BD and CE. Each rod has a diameter…

A: Given Esteel=200 Gpa  a= 1 m, b= 1.5 m, d= 40 mm, h= 10 mm

Q: b) The L bracket ABC is supported by a roller at A and a pin at B and is loaded with a system of…

A: Note:Hi! Thank you for the question As per the honour code, We’ll answer the first question since…

Q: F2 F1 E 3m 3 m

A:

Q: 40 kN 20 kN 20 kN A IAB = 120(10°) mmB IBC = 90(10°) mm1[C -3 m- -3 m-3 m- -4 m -4 m s ai 8 omuazA…

A:

Q: Determine the force in member AB for the truss using the method of joints. T 2.5 m TT 20 KN O a. 52…

A: Given data,  Load at B = 40 kN Load at C = 40 kN Load at A = 20 KN

Q: The frame shown in the figure is supported by a hinge at A and a roller at E. Compute the horizontal…

A:

Q: •6-13. Determine the largest load P2 that can be applied to the truss so that the force in any…

A:

Q: Determine the force in member AB, FE and CD using method of section. A |– 3 m →✦✦✦▬▬4 m —✦✦✦▬ 3 m →|…

A:

Q: Determine the vertical displacement of joint C. The truss is made from A992 steel rods each having a…

A: Given :- The truss is made from A992 steel rods having diameter of 1 inch  To determine :- The…

Q: в с D E F G Hinge Hinge 4 m- - 4 m+3 m--3 m- 2 m 2 m a) Determine the maximum positive moment that…

A:

Q: An unsymmetric moment of M = 5 kN.m is applied on the cross-section of an aluminum beam. Find the…

A:

Q: 4. If the load P on the beam below causes the end C to be displaced 10mm downward, determine the…

A:

Q: Q4/ The rigid beam is supported by a pin at A and two steel wires BD and CE. Each rod has a diameter…

A:

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.