The machine shown is used for forming metal plates. It consists of two toggles ABC and DEF which are attached to a hydraulic jack at pt. H. The toggles push the curved bar at G forward, pressing the plate into the cavity. The curved bar at G slides along frictionless rails at the top and bottom of the machine. If a 12-kN force is applied to the center of the plate, determine the force, F, from the hydraulic jack in the configuration shown.

Q: The assembly consists of two 10-mm diameter red brass C83400 copper rods AB and CD, a 15- mm…

A: Given data : To Find :

Q: Consider the structure shown in Figure 1). Assume the cornections A. B and C are pins. Suppose that…

A:

Q: The pin-connected rigid rods AB and BC are inclined at 0 the force P is applied, 0 becomes 32°.…

A:

Q: Please help solve Quiestion 3 part A

A: Given data in question  Load 60 kN Length 18 m Internal hinges To find out  Indeterminacy  Note Ds=…

Q: The shaft system is made from aluminum and brass. Brass (G 39 GPa) 60 mm 2000 N.m 44 mm Aluminum (G=…

A: Given :-  A shaft system is given which made up from aluminium and brass  Twisting Moment at C =…

Q: The A-frame shown is pin-connected at A, B, C, and D. The surface at E is level and frictionless.…

A: To find support reaction and pin reaction at B,C,D

Q: A hollow steel tube (1) with an outside diameter of D1 and a wall thickness of t1 is connected to a…

A: E1 = 210 GPaE2 = E3 = 55 GPa Determinea. The movement of joint B with respect to support A. b. The…

Q: Question 1) Determine the x and z components of reaction at the journal bearing A and the tension in…

A: F1 = -800 k F2 = 350 j

Q: 6- Replace the two wrenches and the force acting on the pipe assembly, by an equivalent resultant…

A:

Q: P9-1 D The steel rod (E= 200GPA) is subjected to the loading shown. If the cross-sectional area of…

A:

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.