Answered: The line voltages of a three-phase,…

The line voltages of a three-phase, 50Hz delta/star connected transformer are 20000V/200V. Calculate this transformer conversion ratio a? a)173.2051 b)17.3205 c)10 d)100

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 1. If a 0.6 accuracy class current transformer has a phase angle of + 10 at 100% rated current, the…

A: Ans.(1). Value of 'β=10'

Q: Two transformers A and B have the following data Transformer A: 6600/440 V, (250 KVA ) requires (…

A: Solving for given transformer A, aA=6600440aA=15 Given low voltage side is short circuited,…

Q: (b) Tests are performed on 14, 5 KVA, 110/1110, 50 Hz transformer and the following results are…

Q: 2.29 Three 10, 100 kVA, 2300/460 V, 60 Hz transformers are connected to form a 30, 2300/460 V trans-…

A: (a) Three-phase transformer schematic diagram:

Q: Two single-phase 11,000/400 V transformers have kVA ratings of 200 kVA and 100 kVA respectively. The…

Q: apparent power: 15 kVA, primary:500 V, secondary: 220 V, 50 Hz, idle running current: %7 Idle lost…

A: TRANSFORMER: Transformer is a static device which transfers power from one circuit to another…

Q: A current-carrying gold wire has diameter 2.76 mm. The electric field in the wire is 6.6 V/m. What…

A: Ohm's law: The Ohm's law in the vector form of the law used in electromagnetics and material…

Q: Consider a 7200V/240V transformer with center-tap on the secondary that is a grounded neutral. If a…

A: Given: Center-tap transformer with neutral grounded with rating 7200V/240V P1=1.0 kWP2=0.5 kW

Q: How to generate 480V three phase 400Hz ac from 230V three phase 60Hz ac source? (Please specify the…

Q: The hysteresis coefficient of the core material of a power transformer is 110J/ m3. The eddy current…

Q: (c) A 50 kVA, 2300 V/460 V transformer has a primary winding resistance and reactance of 3.5 N and…

Q: A 10 kVA, 600V/240V single-phase transformer has full load copper loss of 30U watts and a core loss…

A: In this question, We need to determine the efficiency of the transformer? We know…

Q: Q.3. Why is the transformer core laminated?

Q: Day loading duty-cycle profile of a 100 kVA, 2400/240 V, 50 Hz transformer is given below. The SC…

Q: Q3-(A)- Three single-phase, 50 kVA, 2310/ 230 V, 60 a 3-phase, star /delta, 4000/230V transformer…

A: NOTE- According to the policy, we can answer sub-parts of the first question, kindly post other…

Q: A short transmission line connects a step-up transformer on the source side with a series impedance…

A: It is given that: VL=17 kVVph=173 kVN1N2=114N3N4=181ZL=0.463+j0.0772 ΩX1=j0.5 ΩR1=50 Ω

Q: The transformer will operate at its minimum efficiency when the variable loss equals the fixed loss.…

Q: 43. A 250KVA, 2000/400V, single phase transformer achieved its variable loss equal to its fixed loss…

A: Given information about a single phase transformer: Rated power S=250 KVA. The induced EMF ratio is…

Q: We wish to connect a 6 kVA, 120/240 V transformer as an autotransformer to a 120 V source to supply…

A: "Since you have posted a question with multiple sub parts we will solve first three subpart for you…

Q: Please answer in typing format

A: To solve this problem, we'll break it down into steps and provide a comprehensive explanation for…

Q: 1. A 150 KVA, 2080/208-V, 3 PHASE, delta-wye transformer with the following: R₁=450mQ R₁=4.5mQ…

Q: Day loading duty-cycle profile of a 100 kVA, 2400/240 V, 50 Hz transformer is given below. The SC…

A: By definition, the all-day efficiency of a transformer is given by: ηall-day=Output kWh in 24…

Q: A three – phase transformer has rating of 60 MVA, 220 kV (star) – 33 kV (delta) with leakage…

A: The solution is given below

Q: 3. In a vacuum, (z, t) = 10³sin(wt - Bz)ây Obtain H (z. t)

Q: A 30 kVA, 4.8 kV-240 V, single-phase, transformer is to be connected to a 4.8 kV system at the…

Q: 200 KVA, single phase two-winding transformer rated 4160/230 V, 60 Hz has primary and second…

Q: Ql-phase step down transformer 1250 KVA, 11000/2200 V, 50 Hz .The resistance /phase and leakage…

Q: Q/ Two transformers A andB of ratings 500 KVA and 250 KVA are supplying a load KVA of 750 at 0.8 Pf…

A: Given- For Transformer A power PA=500 KVA open circuit voltage EA=400 V resistance=1% reactance=5%…

Q: A short transmission line connects a step-up transformer on the source side with a series impedance…

A: To find the real power absorbed by the load, we first need to determine the voltage and current at…

Q: A 125 kVA transformer has primary voltage of 2000 at 60 Hz. Primary turns are 182 and secondary…

Q: Answer by true or false True False The efficiency of a transformer at load 0.8 p.f. Lag is less than…

A: The efficiency of a transformer at load 0.8 pf lag is slightly more than at load 0.8 pf lead. As…

Q: N1: N2 In-1A Vac 60 Hz Ver Center tapped 5000uF D2 Output Waveform: Vpp Voc 12V

Q: a 5kva, 757v/ 420V, single-phase transformer has the percentage regulation drops 4%. determine the…

A: KVA rating is given S = 5 KVA. Primary voltage with no load E1=757 V. Secondary voltage with no…

Q: A 10 MVA, 115 kV/25 kV, 60 Hz, Y-A connected, three-phase power transformer has an equivalent series…

A: Given: A 10 MVA, 115 kV/25 kV, 60 Hz, Y-Δ connected, three-phase power transformer has Equivalent…

Q: Two transformers A and B of ratings 500 KVA and 250 KVA are supplying a load KVA of 750 at e.8…

A: Open circuit voltage VAO=400 volt impedance for transformer A, ZA=RA+jXA×Voc2KVAA…

Q: Write the voltage as a function of the transformer turns ratio for the following circuits respecting…

A: This question belongs to electrical machine . It is based on the concept of relation between…

Q: 5. A 50-kVA 20,000/480-V 60-Hz single-phase distribution transformer is tested with the following…

Q: A low voltage distribution transformer feeds two different loads with a three-phase line. The…

A: Given Data is- Nominal Voltage V=400 volt The total length of the feeder L=500 m…

Q: A short transmission line connects a step-up transformer on the source side with a series impedance…

A: Short Transmission Line: A short transmission line is one with an effective length of less than 80…

Q: 2.5 A 16,25 KVA, 220/440 V, 60 Hz transformer gave the following test results. Open circuit test…

A: It is given that: P=25 kvaV1V2=220440f=60 Hz open circuit test: 220 V,9.5 A,650 W short circuit…

Question

The line voltages of a three-phase, 50Hz delta/star connected transformer are 20000V/200V. Calculate this transformer conversion ratio a?

a)173.2051

b)17.3205

c)10

d)100

Expert Solution

Step 1

According to question we have to

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

During the load test of single-phase transformer, when the secondary terminal voltage increases, the regulation of the transformer will ................?(complete)
A 200 MVA 15/200 kV single-phase power transformer has a resistance of 2.40 and a reactance of 10.012 referred to the high voltage side. The voltage regulation of this transformer for the secondary winding current of 1100A at PF of 0.8 lagging is a. 5% b. 4.01% C. 3.8%
5. An ideal 2KVA, 240V/24V, single-phase transformer has 50 turns at its secondary winding. If the transformer is connected to a 240V, 50Hz source at its primary, at full load, calculate: a) The number of primary turns. [500] b) The primary and secondary currents. 83.3A] c) The maximum value of the flux. [2.162mWb] [8.33A,
Subject name: Power System Protection
The turns ratio of a particular transformer is less than 1. Where would you expect to see this type of transformer? OI. A 0 0 0 0 0 Power Plant K Generation II. A and B III. B IV. B and C V. C VI. C and A A Station High-Voltage Power Lines Transmission B Substation C Distribution Power Lines ( .00 Industrial Consumer Commercial Consumer Residential Consumer Distribution
500 kva, 11,000/2300 volts 60Hz transformer has 5.45% impedance and 1.2% resistance. What is the percent regulation at full load 80% power factor lagging?" A. 3.26 B. 6.23 C. 4.21 D. 5.28
Solve the following problems with complete solutions and units usingtwo(2) decimal digits.2. A 5-kVA transformer has 35 W. core loss and 40 W. copper loss atfull-load. It operates at rated kVA and 0.8 power factor lagging for 6hours, one-half rated kVA and 0.5 power factor lagging for 12 hoursand no-load for 6 hours. What is the all-day efficiency?
Ql-phase step down transformer 1250 KVA, 11000/2200 V, 50 Hz . The resistance /phase and leakage reactance/phase of the primary winding are 0.78 N and 4.80 and the corresponding values for the secondary winding are 0.012 and 0.062 respectively if the primary winding is connected in delta and secondary in star calculate: i)The voltage to be applied at normal frequency to the primary to circulate full-load through it when the secondary is short-circuited Ii) The full load copper loss
A short transmission line connects a step-up transformer on the source side with a series impedance of j0.5 ohms (referred to the primary) to a step-down transformer on the load side with a series impedance of 50 ohms (referred to the primary). The turn ratio of the step-up transformer is 1:10 and a no-load primary voltage of 23 (line-to-line) kV. The step-down transformer has a turn ratio of 35:2 and it has a Y-connected, balanced load of 0.490 +j 0.0816 ohms connected to its secondary side. A capacitor bank of -j0.171 ohms is added parallel to the load. Assuming an ideal transmission line, the load voltage (line-to-neutral) would be: O A. 7360 V O B. 6.2 kV O C. 12750 V O D. 4806 V O E. None of the other choices are correct