The lap joint shown is connected by three 16-mm diameter rivets. If the allowable stress for shear in rivets is 40 MPa  and bearing between the rivets and the plates is 60 MPa determine the safe load P.

Q: A short column is made by nailing two 1 * 4-in. planks to a 2 * 4-in. timber. Determine the largest…

A: Given Data: The top surface area of center plank (A) is of (2 inchx4 inch) The top surface area of…

Q: Link AB is to be made of a steel for which the ultimate normal stress is 450 MPa. Determine the…

A: Free Body Diagram:

Q: For the clevis connection shown, the shear stress in the 0.21-in.-diameter bolt must be limited to…

A: Given: Let us consider the given data, Shear stress,  τ=39 ksi=39×103 Psi Bolt's diameter, d=0.21 in…

Q: Required information Two horizontal 9.5-kip forces (P) are applied to pin B of the assembly shown. A…

A: Given P = 9.5 kip Diameter of pin = 0.8 in To find Normal stress at link AB

Q: In the steel structure shown, a 6-mm-diameter pin is used at C and10-mm-diameter pins are used at B…

A: Given Data: The ultimate shear stress is:τul=150 Mpa The ultimate normal stress is: σul=400 MPa.…

Q: 1. The structure is used to support a distributed load of w = 15 kN/m. The bolts at A, B, and C each…

A:

Q: 1.55 In the structure shown, an 8-mm-diameter pin is used at A, and 12-mm-diameter pins are used at…

A:

Q: 4. A load P is applied concentrically to the bar shown. If the allowable normal stress is 76 ksi,…

A:

Q: A bar with an allowable tensile stress of 16 ksi has two holes at A and B. Determine the maximum…

A:

Q: (4) The shown cast-iron bracket has an ultimate compressive strength of 504 MPa and an ultimate…

A: The ultimate compressive strength is σc=504 MPa. The ultimate tensile strength is σt=225 MPa The…

Q: 5.0 in. 3.0 in. The 1.4-kip load P is supported by two wooden members of uniform cross section that…

A: Given load P=1.4 kip Cross section A=5×3 in.2

Q: Two horizontal 5.5-kip forces (P) are applied to pin B of the assembly shown. A 0.8-in. diameter pin…

A: Given:Force = 5.5 kipDiameter = 0.8 in

Q: In the structure shown, an 8-mm diameter pin is used at A, and 12-mm diameter pins are used at B and…

A:

Q: Link BC is to be made of a steel for which the ultimate normal stress is 250 MPa. Determine the…

A:

Q: The 1.4-kip load P is supported by two wooden members of uniform cross section that are joined by…

A: Given Data: The load on member is P = 1.4 kip. The cross-section area is A = 3 in ×5 in. The angle…

Q: 1.55 In the structure shown, an 8-mm-diameter pin is used at A, and 12-mm-diameter pins are used at…

A: