The following spot speeds (mph) were measured at a location along a two-lanehighway (for one direction only), over a period of 10 minutes.69 5467695862| 57616358606058545760716557636969595460675846535962545868665957645852616561535857654764546859596257666758646059596356626459576161585764706555634565577361676248625760715358606561676276714958Calculate the following traffic stream parameters1) Time Mean Speed2) Space Mean Speed (assume that all vehicles were traveling at a constantspeed)3) Hourly Flow Rate4) Density5) Sketch the speed-flow curve for these traffic conditions, assuming that theroadway capacity and free-flow speed have previously been determined to be1800 veh/hr/ln and 62 mi/h, respectively. You can use Excel to plot the data,but should submit an original excel file to the blackboard.

1.) The expression for time mean speed is given as Vt=1n∑vii=1n Here n is the number of vehicles and…

Answered: The following spot speeds (mph) were…

The following spot speeds (mph) were measured at a location along a two-lane highway (for one direction only), over a period of 10 minutes.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

25 The table below shows the design flow rate and saturation flow rate for a major intersection on a highway. Using the Webster method, determine the optimum cycle length for the intersection and also determine the green time for each phase. Design Flow Rate (pcu/hr) Through Phase Saturation Flow Rate (pcu/hr) Intergreen period (sec) Left Through Left A 976 234 3700 1615 3.5 676 135 3700 1615 3.5 194 26 3700 1615 3.5 322 371 3700 1615 3.5
solve the problem given in image. please solve it completely.
Determine the safe distance travelled by a vehicle before coming to a full stop having an initial velocity of 75 kph, it skids to a stop on a 3% downgrade and assuming AASHTO recommended perception-reaction time
The length of a highway is 550 m when a head-on vehicle collision occurred. Police reports show that neither human error nor vehicle malfunction was the cause of the collision. Check if the length of the highway is sufficient for an overtaking maneuver. *Accident Report: Speed of Overtaking Car = 96 kph, Speed of Overtaken Car = 88 kph, Perception-reaction Time = 2.5 sec, Average acceleration = 2.4 m/sec2, Time of the passing vehicle occupying the left lane = 10.4 sec, Distance between the passing vehicle at the end of its maneuver and the opposing vehicle = 84m.
answer asap. will upvote
plz, solve this problem, it is not graded question. Transportation Engineering-1
Transportation Engineering Determine the median speed, the modal speed
Q2: What are the assumptions for using the equations in the queue test? Q3: A signalized intersection, of 105 sec cycle length, the east approach has an effective green time of 20 sec, and the percentage of vehicles arriving during green time is 28%. The west approach has 16 sec green time and 32% of vehicles arriving during the green time. Determine which approach is best coordinated with the upstream signal.
Problem 3 (30%) Problem 11-1 in Roess, Prassas, McShane, 5th ed. (edited - omit part f) Consider the spot speed data below, collected at a rural highway site under conditions of uncongested flow: Speed Group (mi/h) Number of Vehicles Observed (N) 15-20 0 20-25 4 25-30 9 30-35 18 35-40 35 40-45 42 45-50 32 50-55 20 55-60 9 60-65 0 a. Plot the frequency and cumulative frequency curves for this data. b. Determine the median speed, the modal speed, the pace, and the percentage of vehicles in the pace from the curves and show how each was found. c. Compute the mean and standard deviation of the speed distribution. d. What are the confidence bounds of the estimate of the true mean speed of the distribution with 95% confidence? With 99.7% confidence? e. Based on the results of this study, a second study is to be conducted to achieve a tolerance of ±0.8 mi/h with 95% confidence. What sample size is required?
. An automobile traveling at a rate of 30 ft/sec is approaching an intersection. When the automobile is 120 ft from the intersection, a truck traveling at the rate of 40 fi/sec crosses the intersection, The automobile and the truck are on roads that are at right angles to each other. How fast are the automobile and the truck separating 2 sec after the truck leaves the intersection?
A turning movement count and a saturation flow study were conducted at a major intersection on an expressway with configuration as presented in Fig.1. The peak-hour volumes and saturation flows obtained from the studies for each movement are presented in Tables 1 and 2, respectively. i) provide a diagrammatic representation of the signal sequence at the intersection. Assume a yellow interval of 3s, all-red interval of 2s and a peak hour factor of 0.95 for all the approaches. Note: No two movements should conflict during the determination of the phasing plan.
Determine whether a T intersection (one leg on the minor approach) with the hourly volume data satisfy MUTCD Warrant 3 (peak-hr vehicular volume) for signalization. All approaches have one lane entering the intersection. For the warrant that is met, explain how the warrant is met (rules applied, hours in which the volume criteria were met, etc.) and refer to necessary graphs and tables. The major street speed limit is 60 km/h, and the minor street speed limit is 40 km/h.