The following are examples of systematic errors that can occur while using a pipet to transfer a known volume of liquid EXCEPT: The inner surfaces of the pipet are contaminated with soap. The pipet is miscalibrated and holds a slightly different volume of liquid than the indicated volume. The user repetitively reads the volume marking on the pipet from an angle rather than at eye level. The fluctuations in the temperature of the laboratory affected the volume of the pipet and the viscosity of the liquid.

The following are examples of systematic errors that can occur while using a pipet to transfer a known volume of liquid EXCEPT: The inner surfaces of the pipet are contaminated with soap. The pipet is miscalibrated and holds a slightly different volume of liquid than the indicated volume. The user repetitively reads the volume marking on the pipet from an angle rather than at eye level. The fluctuations in the temperature of the laboratory affected the volume of the pipet and the viscosity of the liquid.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A poiseuille flow experiment was carried out to measure the viscosity of air at 298 k. the sample was allowed to flow through a 100 cm tube of internal diameter 1mm. The high pressure end was at 865 Torr and the low pressure end was at 760 Torr. The volume was measured at the latter pressure. In 59 seconds a volume of 90.2cm^3 passed through the tube. What is the viscosity (use the unit cp of air at this temperature?
1g a proportion of the form a/(x+b) = c/x Solve for x. - 12 -14 x+1 ?.
The diffusion coefficient of water molecules in hydrogen (the carrier gas) at 307 k and 1 atm is 1 cm2/sec. What is the average time that the water molecules to travel a distance of 1 mm in the gas chromatographic system? Assuming there no interactions between water and the system.
1. calculate the density of water in g/ml. 2. calculate the viscosity of water in cP. *
You are given three unknown samples stored in screw-cappedcontainers and was told to analyse them. You noted that Container A iscloudy and have some particles that are staying near the bottom of thecontainer. Container B is translucent while Container C is transparent. If thecontents of Container A can be separated by simple decantation,what isthe particle size that BEST describes its composition?i. <1 nmii. 1 nmiii. 1 nm-100 nmiv. >1000 nm
Calculate the modulus of elasticity of a metal-matrix composite under isostrain conditions. Assume an aluminum matrix is reinforced by 80 vol % SiC fibers. Express your answer to three significant digits. The modulus of elasticity is Submit Request Answer | ΑΣΦ | | vec ? MPa.
In the solvent hexane, the average end-to-end distance of a 7 kDa molecular weight poly(ethylene glycol) polymer chain is 3.65 nm and the average end-to-end distance of a 56 kDa molecular weight poly(ethylene glycol) polymer chain is 7.30 nm. By calculation, show whether hexane is a good, poor or theta solvent for poly(ethylene (i) glycol).
if a volumetric pipet delivers 24.844 g of deionized water at 31.00 celsius what is the calibrated volume of the pipet?
A poiseuille flow experiment was carried out to measure the viscosity of air at 298 K. The sample was allowed to flow through a 100 cm tube of internal diameter 1 mm. The high pressure end was at 865 torr and the low pressure end was at 760 torr. The volume was measured at the latter pressure. In 59 seconds a volume of 90.2 cm^3 passed through the tube. What is the viscosity in cp of air at this temperature
The efflux time of glycerin sample is 320 seconds having a density of 1.26 grams per mL. This is based on the room temperature setting. Water is used as a standard with the computed efflux time of 225 seconds having a density of 0.997 grams per mL. Viscosity of water was identified as 0.7202 CP. What is the viscosity of glycerin?
Using the Poiseuille formula, the viscosity of carbon dioxide was measured by comparing its flow rate through a long, narrow tube with that of argon. For the same pressures, the same volume of carbon dioxide passed through the tube in 55 s as argon in 83 s. The viscosity of argon at 25 °C is 208 μP. What is the viscosity of carbon dioxide? Give your answer in μP
A capillary viscometer was used to measure the viscosity of a fluid at room temperature. At a pressure drop per unit length of 0.28 mmHg cm−1, i.e., ΔP/L, the measured flow rate of the fluid through the capillary viscometer was found to be 0.0125 cm3 s−1. When the value of ΔP/L was increased to 0.79 mmHg cm−1, the flow rate of the fluid was found to be .047 cm3 s−1. Under these conditions, is the fluid Newtonian or non-Newtonian? Be sure to justify your answer.