The fluid condition at the inlet and exit of a horizontal convergent nozzle is analysed. The nozzle is operating steadily. and heat loss is assumed negligible. If the specific enthalpy of fluid and velocity of fluid at the inlet are 3,089 kJ/kg and 229 km/hr respectively. At the exit the specific enthalpy of fluid is 2,569 J/kg. Calculate the exit area (in mm2)of the nozzle when the specific volume at the nozzle exit is 0.63 m3/kg at the inlet area of 0.2 m2 and the specific volume at the inlet is 0.31 m3/kg. You do not need to include the unit for this question.

The fluid condition at the inlet and exit of a horizontal convergent nozzle is analysed. The nozzle is operating steadily. and heat loss is assumed negligible. If the specific enthalpy of fluid and velocity of fluid at the inlet are 3,089 kJ/kg and 229 km/hr respectively. At the exit the specific enthalpy of fluid is 2,569 J/kg. Calculate the exit area (in mm2)of the nozzle when the specific volume at the nozzle exit is 0.63 m3/kg at the inlet area of 0.2 m2 and the specific volume at the inlet is 0.31 m3/kg. You do not need to include the unit for this question.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

2- 8 Air flows at a speed of 6.5 m/s through a pipe with a diameter of 25 cm and a length of 30 m. The total multiple local loss coefficient in the pipe is given as 4.4. The friction factor of the pipe was obtained from the Moody chart as 0.03. What is the total head loss in this pipe?
6 m 6 m Elbow 6 m 3 m. Activate Wind Goto Sectines1 15 m A fluid is pumped at a rate of 0.00156 m/s through a 0.025-m-diameter pipe to fill a 9°C 020
In seconds
Water (p = 1003.8 kg/m³) flows at the rate of 3.95 L/s in a pipe of diameter 31 mm, which enlarges to 44 mm diameter. Calculate the water mass flow rate in kg/s. Answer: 27
The pumping power of the human heart is approximately 2W (assuming a normal cardiac output of 5 liters/min). Like any pump, however, the heart is not 100% efficient, and, therefore, the power that is supplied to the heart muscle will actually exceed 2W. In this question we will estimate the heart’s pumping efficiency η by calculating how much energy is supplied to the heart muscle from the blood.(Note that the heart muscle has its own vasculature, called the coronarycirculation.) (a) When we calculated the pumping power of the heart, we only considered the head gain across the heart from the pressure increase. In general, there could also be changes in elevation (very small) and in kineticenergy. Estimate the ratio of kinetic energy head to pressure head at peaksystole, when pressure is 120 mmHg and blood velocity is 100 cm/s.Can we safely neglect kinetic energy gains in calculating pumpingpower?(b) At rest, the coronary blood flow is 225 ml/min, and 65% of the O2 isremoved from the…
A tube with 45 meters long, and a diameter of 1.8 meters and 2.3 meters, inlet and outlet respectively. Water is flowing inside the tube. What is the rate of change of the velocity with respect to its length when the inlet has a velocity of 2100 meters/min? *Include the units on the answer.
I need the answer as soon as possible
What are the primary considerations when selecting a flowmeter to measure the flow rate of a fluid?
What is the mass flow rate of air is flowing at a velocity of 20 m/s through a tube with an area of 2 m2 and density of 1.225 kg/m3? Assuming that the airflow is incompressible, what is the new velocity of the mass airflow if the tube narrows to an area of 1 m2? 24.5 kg / s, 10 m/s 49 kg /s, 40 m/s O 12.25 kg / s, 20 m / s 50 slugs / s, 40 ft/s
A spring-mass system has a spring constant 3 N/m. A mass of 2 kg is attached to the spring, and the motion takes place in a viscous fluid that offers a resistance numerically equal to the magnitude of the instantaneous velocity. If the system is driven by an external force of (15 cos 3t - 10 sin 3t) N, determine the steady state response. Express your answer in the form R cos(wt 8). (Let u(t) be the displacement of the mass from its equilibrium position at time t.) Uss(t) =
Water flows in a horizontal pipe with an I.D. of 5cm (circular cross-section) and a length of 20 meters at a velocity of 1.2 m/sec. The water enters the pipe at a temperature of 20 °C and exits at 60 °C. The system can be considered steady. Calculate the following: The (average) rate of heat transfer to the flow per square cm of pipe wall area (W/cm2).
Water at 60 deg. F is pumped from a reservoir to the top of a mountain through a 6-in SCH 120 pipe at an average velocity of 12 ft/s. The pipe discharges into the atmosphere at a level 3000 ft above the level in the reservoir. The pipeline itself is 4500 ft. long. If the overall efficiency of the pump and the motor driving it is 70% and the cost of electric energy to the motor is 4 cents per kilowatt-hour, 2. what is the theoretical power consumption in hp? 373755575557337733none of the given