The flow rate through a channel can be determined using a weir by the following formula: Q = 5.4LH1.5 where Q = discharge rate (ft3/s) L = length of weir (ft) H = height of fluid above crest (ft) For a weir length 1.5 m and fluid of height 2.2 m above the crest, what is the flow rate in m3/s

The flow rate through a channel can be determined using a weir by the following formula: Q = 5.4LH1.5 where Q = discharge rate (ft3/s) L = length of weir (ft) H = height of fluid above crest (ft) For a weir length 1.5 m and fluid of height 2.2 m above the crest, what is the flow rate in m3/s

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

The volume of HCI is 100 mL , mass of solid added is 1.008g, moles of solid 0.0276 Mol, mass of HCI is 100g, initial temperature is 21.8 degrees Celsius, Final temperature is 30.7 degrees Celsius, Calculate q rxn(= -mc Delta T of HCI),
It is intended to produce Propylene Glycol, PG (CH2(OH)CH(OH)CH3) by the hydrolysis of Propylene Oxide, PO (CH20CHCH3) in CSTR. The acid-catalyzed liquid-phase exothermic reaction is shown below: CH20CHCH, + H20 - CH2(OH)CH(OH)CH, The feed, containing 3 mol/L of Propylene Oxide and 30 mol/L of water, enters the well-mixed adiabatic reactor at 303 K at a total volumetric flowrate of 10 L/min. Propylene Oxide is a volatile substance, and you cannot exceed an operating temperature of 80°C. Assume that you operate the system at this maximum temperature. Additional Information: AHxn(298K) = -18,000 cal/mol k at 298 K = 2.77x10-4 min- Gas law constant = 1.987 cal/K.mol. E = 15,000 cal/mol Cp (PO) = 35 cal/molK Cp (H20) = 18 cal/mol K Cp (PG) = 46 cal/mol K %3D The reaction is dependent in Propylene Oxide concentration and independent of water concentration. It can be treated as a first order and also second order reaction. Analyse and justify the effect of reaction order on the conversion of…
Two liquids of different densities pi= 1500 kg/m³ and p2= 500 kg/m are poured together into a 100 L tank, filling it. If the resulting density of the mixture is 800 kg/m³, find the respective quantities of liquids used Also, find the weight of the mixture @ g = 9.675 mps?.
dt The Gompertz growth model is commonly used to model tumor cell growth. Let v(t) be the tumor's volume, then du(t) = A e-atv(t) where λ and a are two appropriate constants. (a) Verify that the solution is given by v(t) = voe/a(1-e-at), where vo is the initial tumor volume. (b) This model takes into account the fact that when nutrients and oxygen are scarce at the tumor's core, its growth is impaired. Find the final predicted tumor volume (let too). (c) For a specific mouse tumor, it was experimentally found that λ = 2.5 days, a = 0.1 days with vo = 50 x 10³ mm³. Use any method available to make a plot of v(t) vs t. (d) Check the result obtained in Part b with the results from the graph from pat c.
An extraction experiment was carried out with the soxhlet extraction technique to obtain oil from a plant seed. In the experiment, 10 g of plant seeds were taken and extracted with 150 mL of hexane solvent. The oil-hexane mixture obtained at the end of the extraction will be separated in the rotary evaporator and the mass and percent extraction efficiency of the collected oil will be calculated. The data obtained at the end of the experiment are given in the table below. Accordingly, calculate the amount of oil obtained, the amount of oil obtained per 1 gof plant seed and the percent extraction efficiency by establishing la mass conservation balance around the rotary evaporator. Weighing result (g) The tare of the sampled balloon 35 Initial mass (balloon + solvent + oil) 88.13 Tare the balloon in which the solvent was collected 45 93.47 At the end of the experiment, the balloon + solvent mass in which the solvent is collected
6. A volatilization gravimetry experiment was conducted on an unknown organic liquid (presumed to only contain carbon, hydrogen, and oxygen). The liquid was massed (data in the first column below) and then combusted in an excess of oxygen. The exhaust gas was passed through a trap containing drierite and then through a trap containing ascarite. The starting and ending masses of the drierite and ascarite were used to obtain the data in the second two columns below. Mass Unknown 12.4370 12.5590 12.2230 Mass CO2 17.0822 17.2497 16.7882 Mass H₂O 13.9849 14.1221 13.7443 A.) Calculate the mass percent of carbon, hydrogen, and oxygen in the unknown liquid. There are no outliers, so you can average the data before processing, if you wish. B.) Calculate the empirical formula of the unknown compound.
Calculate the pressure at the base of a mercury column 400 mm high. The mercury density at room temperature is 13.5951 g / cm3.Express the result in column, atmosphere, psi, pascal, and bar units. Calculate the pressure exerted on the drum skin of a diver located at a depth of 20 feet below sea level. Assume that the seawater density is: 1 gr / cm3. Calculate the molar volume of Cu2Te. Express this volume in mol/liter and mol/cm 3 units. ( rm=7.270 g/cm3) Use the ideal gas law and the van der Waals equation to calculate the pressure of ammonia gas at a temperature. T = 300 K the molar volume is V = 24 liters / mol
A presure of 436.5 mm Hg is equal to how many atmospheres of presure?
You have to use systems of equations to solve the problem. Write down the systems you are using on paper and then use Matlab to solve the systems. Interprete your results from the Matlab computations again on your paper and give the final answers on the answer sheet. Balance the following chemical equation: _PbCrO4+ -- HCl + ----FESO4 → ----P6C12 + ----Cr2(SO4)3 + ----FeCl3 + ---H2O+ ----Fe2(SO4)3
Ethyl alcohol (C2H5OH) may be prepared by the fermentation of glucose (C6H12O6) as indicated by the equation: yeastC6H12O6 ----> C2H5OH + CO2 74.12 mL of ethyl alcohol (specific gravity = 0.790) was collected by this fermentation pro- cess. What mass of glucose was used?
If a cylindrical tank holds 100,000 gallons of water, which can be drained from the bottom of the tank in an hour, then Torricelli's Law gives the volume V of water remaining in the tank after t minutes as 1 V (t) = 100, 000 (1- 60 for 0
Hg²+ + 2 e → Hg Hg2* + 2 e → 2 Hg Hg,Br2 + 2 e –→ 2 Hg + 2 Br MnO4 + 4 H* + 3 e¯ → MNO2 + 2 H2O E° = +1.68 V Pb + 2 e –→ Pb Sn²* + 2 e → Sn E° = +0.851 V 2+ E° = +0.797 V E° = -0.126 V E° = +0.139 V E° = –0.02 V Calculate the solubility product for Hg2Br2.