The double pulley consists of two parts that are attached to one another. It has a weight of 31 lb and a radius of gyration about its center of ko = 0.4 ft. If it rotates with an angular velocity of 21 rad/s clockwise, determine the kinetic energy of the system. Assume that neither cable slips on the pulley. 0.5ft 1 ft B 301b A 201b

The double pulley consists of two parts that are attached to one another. It has a weight of 31 lb and a radius of gyration about its center of ko = 0.4 ft. If it rotates with an angular velocity of 21 rad/s clockwise, determine the kinetic energy of the system. Assume that neither cable slips on the pulley. 0.5ft 1 ft B 301b A 201b

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

stion 5 The 20-kg wheel has a radius of gyration ko = 400 mm where O is the center of the wheel. If the wheel is subjected to a moment, M = (2t) N.m, where t is in seconds, determine its angular velocity when t- 4s starting from rest. Assume the wheel is subjected to rotation only (no translation). OA 16.0 rad/s B. 10.0 rads oc 8.0 rad/s 0 5.0 rad/s
The 18-kg rod AB is pin-connected at A and subjected to a couple moment of M =15 N- m The rod is released from rest when the spring is unstretched at 0 = 30°. As the rod rotates, the spring always remains horizontal, because of the roller support at C. (Figure 1) Determine the rod' s angular velocity, measured clockwise, at the instant 0 = 60°. Express your answer using three significant figures. Enter positive value if the angular velocity is clockwise and negative value if the angular velocity is counterclockwise. vec rad/s k = 40 N/m 0.75 m M = 15 N- m
The 10-kg uniform cylinder is pin supported at its center O. The square isacted upon by a constant force F = 10N and a constant couple moment M = 10 Nm.If the disk starts from rest, determine1) The reactions at the pin O and the angular acceleration of the disk2) The number of revolutions it must take to attain an angular velocity of 10 rad/s
The 2.5-kgkg rod ACBACB supports the two 4.1-kgkg disks at its ends. If both disks are given a clockwise angular velocity (ωA)1=(ωB)1=4.6rad/s(ωA)1=(ωB)1=4.6rad/s while the rod is held stationary and then released, determine the angular velocity of the rod after both disks have stopped spinning relative to the rod due to frictional resistance at the pins AA and BB. Motion is in the horizontal plane. Neglect friction at pin CC.
SOLVE USING PRINCIPLE OF WORK AND ENERGY
The 45-kg reel has a radius of gyration about its center O of ko = 220 mm. If it is released from rest, determine the total external work done to it when its center O has traveled 6.6 m down the smooth inclined plane (with angle = 35°). Please pay attention: the numbers may change since they are randomized. Your answer must include 1 place after the decimal point, and proper SI unit. Take g = 9.81 m/s². 0.4 m 0.2 m²
At the instant shown, the spring is un-deformed. Determine the change in potential energy if the 20 kg disk (with radius of gyration kG = 0.5 m) rolls 2 revolutions without slipping. k= 200 N/m 3 m/s datum 0.3 m M = 2 Nm 30° O 1791 J O -1791 J O 1051 J O 1421 J O E) None of the above
The 3.8 kg block is descending at a rate of 1.2 m/s when the hydraulic cylinder BC exerts a force F=500 N on the brake arm. Determine the number of radians the wheel will rotate before the system comes to rest. The wheel has a mass of 25 kg and a radius of gyration about its center kO=300 mm. The coefficient of kinetic friction between the brake arm and the wheel is 0.25.
At the instant shown, link CD rotates with an angular velocity of W = 9.0 rad/s. If it is subjected to a couple moment M= 320 N-m, determine the magnitude of the vertical reaction force developed on pin D. The block has a mass of 50 kg and center of mass at G. Neglect the mass of links AB and CD. (Hint, since the mass of link AB or CD is negligible, the external force or moment acting on it sums up to 0.) Please pay attention: the numbers may change since they are randomized. Your answer must include 1 place after the decimal point, and proper unit. Take g = 9.81 m/s². 0.1 m 0.6 m В А 0.4 m' G 0.4 m D C M Your Answer: Answer units
The system is made up of the 1-m, 6.7-kg uniform rod AB and the two uniform disks (each of 0.10 m radius and 2.2 kg mass). If the system is released from rest when 0- 55", when rod AB has just become horizontal, determine the angular velocity of rod ABin rad/s. Assume the disks roll without slipping. Your answer must include 2 places after the decimal point. Please pay attention: the numbers may change since they are randomized. Take g= 9.81 m/s?. 1m
The uniform 80 kg slender rod is at rest in the position shown when P = 450 N is applied. Determine the value of angular velocity, w2 the rod if L1 = 5.5 m and L2 = 6.5 m. A L L2 L1 B
The 21-kg uniform thin hollow square plate is pinned at point O, and its side L = 0.5 m. If it is subjected to the constant moment M = 78 N•m and is released from rest from the position as shown, determine its angular velocity w (in rad/s) when it has rotated 45°. Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point. Take g = 9.81 m/s2. `L MV Your Answer: Answer