The distance from earth to a distant planet is approximately 9 x 10^10 m. What is the channel utilization if a stop-and-wait protocol is used for frame transmission on a 64 Mbps point-to-point link? Assume that the frame size is 32 KB and the speed of light is 3 × 10^8 m/s.

Q: What are the advantages and disadvantages of the different random access access methods? Why does…

A: Multiple Access Protocols: The Data Link Layer is in charge of the data transfer that occurs between…

Q: eam of data is being carried by STS-1 frames. If the data rate of the stre 40 Mbps, how many STS-1…

A: Introduction: The data rate is the number of bits transmitted per second from one device to another…

Q: Question: Find the Global Unicast Address if EUI-64 is used to generate the interface identifier and…

A: This is about generating a Global Unicast Address (GUA) using EUI-64 and a given Ethernet physical…

Q: agation delay, The Stop & Wait Protoc

A:

Q: Assume a shared connection of 1 Mbps (for example, an Ethernet bus). How long does it take (in…

A: - We have to calculate the time required to transmit thousand bit frame over connection of 1 mbps.

Q: Question 2: Consider the system shown in the figure below. The frames have 8,000 bits, ACKS are…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: Consider a selective repeat sliding window protocol that uses a frame size of 2 KB to send data on a…

A: Given the Frame Size as 2KB, Bandwidth=4Mbps Latency =60ms, which is also known as Propagation delay…

Q: Ten signals, each requiring 3000 hz, are multiplexed onto a single channel using FDM. How much…

A: Here in this question question we have given Ten signals, each requiring 3000 hz.we are using FDM…

Q: A stream of data is being carried by STS-1 frames. If the data rate of the stream is 49.540 Mbps,…

A:

Q: Suppose a switch is built using a computer workstation and that it can forward packets at a rate of…

A: given bandwidth of main memory is 2 Gbps I/O bus is used to access the memory. I/O bus speed is…

Q: A channel has a bit rate of 4 kbps and a propaga tion delay of 20 msec. For what range of frame…

A: The Answer is

Q: Suppose you are designing a sliding window GBN protocol for a 5 Mbps point to point link, which has…

A: Find the required answer with calculation given as below :

Q: onsider a bus network with two computers connected shown below: -d m- -X m- A В Rate: R1 Mbps…

A: Given : For A : Bandwidth = R1 Mbps Speed = v1 m/s For B : Bandwidth = R2 Mbps Speed = v2 m/s…

Q: Suppose a switch is built using a computer workstation and that it can forward packets at a rate of…

A:

Q: what is the throughput if the system produces the 1000 frames/sec then A pure ALOHA network…

A: The Answer is in Below Steps

Q: In cdma2000 reverse link, a user stream of 9.6kbps is sent to an encoder r = 14 (4 coded bit for…

A: Hey there, I am writing the required solution of the above stated question.Please do find the…

Q: 23 The maximum window size for data transmission using the selective reject protocol with n-bit…

A: ANSWER : Option C In selective reject protocol, the maximum window size must be half the Sequence…

Q: Suppose you are designing a sliding window protocol for a 2-Mbps point-to-point link to the moon,…

A: Given- Bandwidth = 2 Mbps Propagation delay (Tp) = 1.25 sec Packet size = 1 KB = 210B= 210*8 bits

Q: Assume there is a shared connection with a 1 Mbps speed, such as an Ethernet bus. How long (in…

A: Now a detailed analysis of the comprehensive Ethernet LAN protocol has been performed. Since…

Q: Suppose a 128-Kbps point-to-point link is set up between Earth and a rover on Mars. The distance…

A: HELLO STUDENT PLEASE DO LIKE IF THIS SOLUTION WILL HELP YOU

Q: Define a function convert_to_milliliters() that has two parameters as the number of tablespoons and…

A: The objective of the question is to create a function that converts the volume in tablespoons and…

Q: The following frame should be transmitted over a given network (the frame is shown in hexadecimal):…

A: The question is related to the concept of framing in computer networking. Framing is the process of…

Q: Assume there is a shared connection with a 1 Mbps speed, such as an Ethernet bus. How long (in…

A: Introduction: Now a detailed analysis of the comprehensive Ethernet LAN protocol has been performed.…

Q: What is the total delay (latency) for a frame of size 78 million bits that is being sent on a same…

A: Given, Frame of size = 78 million bits = 78 × 106bits = 78000000 bits Queuing time = 83 μs =  83×…

Q: A Go-Back-N (GBN) ARQ scheme has been designed with window-size W = 10 such that it is fully…

A: Given that, In Go-Back-N ARQ scheme, Window size w= 10 Frame size= 20,000 bits There are no errors…

Transmission media

A communication channel that transmits data from a source to a recipient is referred to as "transmission media." Electromagnetic impulses are used to transmit data. Transmission media's primary purpose is to transmit data in the form of bits via a local area network (LAN). In data transport, it is the physical link that connects the transmitter and receiver. Transmission medium is part of layer 1 or physical layer of the ISO/OSI (Open System Interconnection) model.