The diameter of the ball is 30 cm as shown in figure. Calculate the river current speed [m/s]. (NOTE: Neglect the weight of the cable. Assume; SGball=0.20, pwater=1000 kg/m and CD bal=0,22). 30 Yanıt: Kontrol et

Q: : Neglecting the losses, calculate the required pump shaft horsepower. Figure (4)

A:

Q: The velocity components for idealised flow along a right angled wall is given by u = 4 x m/s, v = -4…

A:

Q: Suppose that ow q is dened in terms of density k by: q = 20k - 0:2k2 (a) Find the free ow speed (b)…

A:

Q: Oil of density ρ=880 kg / m3 flows through the Venturi tube (pictured). Calculate the flow if given:…

A: Given data: Oil density ρo=880kgm3 Mercury specific gravity sm=13.54 D=24 mm. d=12 mm. y=440 mm.

Q: The tank of water in Fig.  is 12 cm wide into the paper.If the tank is accelerated to the right in…

A: Given data *The length of the water tank, L = 24 cm *The height of the water tank, d = 9 cm *The…

Q: The reservoirs in Fig. contains water at 208C. If thepipe is smooth with L = 4500 m and d = 4 cm,…

A: The temperature of the water in the reservoir is T=208 C. The length of the pipe is L=4500 m. The…

Q: A piece of string 9.8 m long weighs 45.7 N. Find how fast a wave will travel on this string, if a…

A:

Q: If a body with a linear dimension of 1 ft is moving in a fluid with velocity q, find the Froude…

A: Feel free to ask any doubt. I hope it is helpful.

Q: Assuming that the pressure is uniform on each of the ch the pressure difference between the upper…

A: GivenF=-1950 N  since -y directionV=55 m/sh=6mmw=215mml=120mm

Q: How to predict the detailed thermal properties of specific physical systems ?

A: Thermal properties When applied to solid bodies, thermal properties are defined as: Material's…

Q: he cross section of a particular riverbed is a parabola. A dam blocks its path. The width of the…

A: Solution: Given Data: w=20 md=9 m   To Find: The total force exerted on the face of the dam.

Q: 9. The thin ( 3 mm ) thick plastic panel shown in the figure is lowered from a ship to a…

A:

Q: Assume the gross weight of the airplane is 600 lbs, what would be a reasonable estimate of its wing…

A: given data; Assume the gross weight of the airplane is 600 lbs, what would be a reasonable estimate…

Q: Fluid with constant velocity Uo and density p flows past an infinitely long cylinder (see figure).…

A: The detailed solution to the above question is given below

Q: The diameter of the ball is 30 cm as shown in figure. Calculate the river current speed [m/s].…

A:

Q: The horizontal V fitting, steady, uniform flow at each section, incompressible, and neglect weight…

A: Given Q1=0.4 m3/s  ,D1=20cm=0.2mD2=8cm=0.08mP1=206.8 KPa  ,P2=120KpaDensity of waterρ=1000…

Q: Required information Water flows through a two-dimensional narrowing wedge at 23.18 gal/min per…

A: Introduction The velocity potential function of space and time whose negative derivative with…

Q: at point A in Fig. 2 i is 18 m/s, what is the pressure at point B if we neglect friction? 15m D- 75…

A: Given: The velocity of fluid at A, v = 18 m/s The height of point A, h = 15 m The diameter of…

Q: The horizontal V fitting, steady, uniform flow at each section, incompressible, and neglect weight…

A: Let us find the velocities at 1 and 2 - Q=A1V1 =A2V20.4=π4201002V1=π481002V2V1=12.73ms, V2=79.577ms…

Q: 2 A lawn sprinkler with unequal arms, shown in the figure, discharges water at 1L/s through its each…

A:

Q: The water jet -13.5 cm in the figure strikes normal to a fixed plate. The velocity of the jet is -8…

A: Write the given data. Dj=13.5 cmVj=8 m/s

Q: Q3 For the given setup find the minimum force F, required to keep the walls in equilibrium. Assume…

A: Given:To find:Minimum force Fx required to keep the walls in equilibrium.

Q: Initial Final %3D Y = (3 m)sin 37° = 15 ms Xp = 0- %3D %3D m= 60 kg X - 3,0 m %3D Y= 0: V= 0. k=?…

A: Given data, Mass of cannonball, m=60 kg,Initial compresion in spring, xi=3 m,Final position:Initial…

Q: Water flows in a channel with uniform curvature R. The channel has height h=ℎ=4mm and width w=200mm…

A: GivenF=-1850 N  since -y directionV=48 m/sh=4mmw=200mml=115mm

Q: Water flows through a rectangular duct of height h = 575.5 mm and width b = 100 mm. (coming off…

A: Given: U = 58 m/s Vmax = 2Vmin Find: Vmin = ?

Q: sailing vessels can carry lead ballast such as bricks to keep the vessel properly oriented and…

A:

Q: Let's consider a snowplow which is scooping up snow 2 cm deep (d) and the blade is 1 m wide. Lets…

A:

Q: The stream function for uniform horizontal flow over a circular cylinder of radius R = 2 m is given…

A: The value of radius r for the two given coordinates can be determined as, And,

Q: Water flows in a channel with uniform curvature R. The channel has height h=6mm and width w=215mm…

A: Given That: Channel height h = 6 mm, width w = 215 mm l = 100 mm in x direction The velocity of the…

Q: A sluice gate is opened in order to allow flow from upstream to downstream as shown in Figure 2.…

A:

Q: What is the maximum power generated by the wind farm with wind speed of 4 m/s? Typical wind…

A:

Q: What is the velocity (m/s) at section 4, if the d4-10.0 cm? The problem is steady and…

A: for solution refer below images.

Q: Question : In the model test of spillway the discharge are 4m3/s and the velocity is 2 m/s find the…

A: Data given-  Discharge Qmodel = 4 m3/s  Vmodel = 2 m /s  Lr = 64

Q: A water jet comes out of a nozzle with a diameter of 20 cm and strikes a vertical plate at the…

A:

Q: (a) Use the y-momentum equation to show that the pressure gradient across the boundary layer is…

A:

Q: A trough whose cross section is an equilateral triangle with side a = 3 m long is filled with water.…

A: Given:Triangle is givenSide, a= 3m To find:Force due to the water pressure on the one end of the…

Q: A river flowing through campus appears quite placid. A leaf floats by and we estimate the average…

A: Velocity, V=0.2 m/s Depth, L=0.6 m Kinematic viscosity, v=1.004*10-6 m2/s

Q: Q.2A) A tall water tank discharges through a well-rounded orifice, as in Fig. below. If, at this…

A: To find : The value of depth h. Given : The diameter of orifice is d=4×10-2 m. The density of water…

Q: What force is exerted on the joint if the flowrate of water is 0.02 r LOAD T NOT 5 cm dia AM PLOAD…

A: Given:  D1 = 5cm =0.05m D2 = 2cm = 0.02m Q =0.02 m3/s Force on the joint is F flow rate; Q =A1V1…

Q: In his study of the circular hydraulic jump formed by afaucet fl owing into a sink, Watson  proposed…

A: Given: The volume flow rate is Q. The density of the fluid is ρ. The viscosity of the fluid is μ.…

Q: A cylinder is formed by bolting two semicylindrical channelstogether on the inside, as shown in Fig.…

A: Apply the Bernoulli equation to find surface pressure.

Fluid Kinematics

The branch of science that deals with objects which are either in motion or stationary are studied under the branch of classical mechanics. Fluid mechanics is a subcategory of classical mechanics that deals with the behavior of fluids at rest (fluid statics) or in motion (posing some velocity). In fluid kinematics, studies focus on the associated motion of fluid particles or groups of particles, and its associated parameters like displacements, velocity, and acceleration without concerning about the forces that caused the motion. All the laws of classical mechanics are applied in the study of fluid kinematics.